linux-toradex.git, branch v3.2.34

Linux 3.2.34

2012-11-16T16:47:22+00:00

ALSA: usb-audio: Fix mutex deadlock at disconnection

2012-11-16T16:47:21+00:00

commit 10e44239f67d0b6fb74006e61a7e883b8075247a upstream.

The recent change for USB-audio disconnection race fixes introduced a
mutex deadlock again.  There is a circular dependency between
chip->shutdown_rwsem and pcm->open_mutex, depicted like below, when a
device is opened during the disconnection operation:

A. snd_usb_audio_disconnect() ->
     card.c::register_mutex ->
       chip->shutdown_rwsem (write) ->
         snd_card_disconnect() ->
           pcm.c::register_mutex ->
             pcm->open_mutex

B. snd_pcm_open() ->
     pcm->open_mutex ->
       snd_usb_pcm_open() ->
         chip->shutdown_rwsem (read)

Since the chip->shutdown_rwsem protection in the case A is required
only for turning on the chip->shutdown flag and it doesn't have to be
taken for the whole operation, we can reduce its window in
snd_usb_audio_disconnect().

Reported-by: Jiri Slaby 
Signed-off-by: Takashi Iwai 
Signed-off-by: Ben Hutchings

sky2: Fix for interrupt handler

2012-11-16T16:47:20+00:00

commit d663d181b9e92d80c2455e460e932d34e7a2a7ae upstream.

Re-enable interrupts if it is not our interrupt

Signed-off-by: Mirko Lindner 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings

r8169: use unlimited DMA burst for TX

2012-11-16T16:47:20+00:00

commit aee77e4accbeb2c86b1d294cd84fec4a12dde3bd upstream.

The r8169 driver currently limits the DMA burst for TX to 1024 bytes. I have
a box where this prevents the interface from using the gigabit line to its full
potential. This patch solves the problem by setting TX_DMA_BURST to unlimited.

The box has an ASRock B75M motherboard with on-board RTL8168evl/8111evl
(XID 0c900880). TSO is enabled.

I used netperf (TCP_STREAM test) to measure the dependency of TX throughput
on MTU. I did it for three different values of TX_DMA_BURST ('5'=512, '6'=1024,
'7'=unlimited). This chart shows the results:
http://michich.fedorapeople.org/r8169/r8169-effects-of-TX_DMA_BURST.png

Interesting points:
 - With the current DMA burst limit (1024):
   - at the default MTU=1500 I get only 842 Mbit/s.
   - when going from small MTU, the performance rises monotonically with
     increasing MTU only up to a peak at MTU=1076 (908 MBit/s). Then there's
     a sudden drop to 762 MBit/s from which the throughput rises monotonically
     again with further MTU increases.
 - With a smaller DMA burst limit (512):
   - there's a similar peak at MTU=1076 and another one at MTU=564.
 - With unlimited DMA burst:
   - at the default MTU=1500 I get nice 940 Mbit/s.
   - the throughput rises monotonically with increasing MTU with no strange
     peaks.

Notice that the peaks occur at MTU sizes that are multiples of the DMA burst
limit plus 52. Why 52? Because:
  20 (IP header) + 20 (TCP header) + 12 (TCP options) = 52

The Realtek-provided r8168 driver (v8.032.00) uses unlimited TX DMA burst too,
except for CFG_METHOD_1 where the TX DMA burst is set to 512 bytes.
CFG_METHOD_1 appears to be the oldest MAC version of "RTL8168B/8111B",
i.e. RTL_GIGA_MAC_VER_11 in r8169. Not sure if this MAC version really needs
the smaller burst limit, or if any other versions have similar requirements.

Signed-off-by: Michal Schmidt 
Acked-by: Francois Romieu 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings

r8169: Fix WoL on RTL8168d/8111d.

2012-11-16T16:47:19+00:00

commit b00e69dee4ccbb3a19989e3d4f1385bc2e3406cd upstream.

This regression was spotted between Debian squeeze and Debian wheezy
kernels (respectively based on 2.6.32 and 3.2). More info about
Wake-on-LAN issues with Realtek's 816x chipsets can be found in the
following thread: http://marc.info/?t=132079219400004

Probable regression from d4ed95d796e5126bba51466dc07e287cebc8bd19;
more chipsets are likely affected.

Tested on top of a 3.2.23 kernel.

Reported-by: Florent Fourcot 
Tested-by: Florent Fourcot 
Hinted-by: Francois Romieu 
Signed-off-by: Cyril Brulebois 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings

r8169: allow multicast packets on sub-8168f chipset.

2012-11-16T16:47:19+00:00

commit 0481776b7a70f09acf7d9d97c288c3a8403fbfe4 upstream.

RTL_GIGA_MAC_VER_35 includes no multicast hardware filter.

Signed-off-by: Nathan Walp 
Suggested-by: Hayes Wang 
Acked-by: Francois Romieu 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings

eCryptfs: check for eCryptfs cipher support at mount

2012-11-16T16:47:19+00:00

commit 5f5b331d5c21228a6519dcb793fc1629646c51a6 upstream.

The issue occurs when eCryptfs is mounted with a cipher supported by
the crypto subsystem but not by eCryptfs. The mount succeeds and an
error does not occur until a write. This change checks for eCryptfs
cipher support at mount time.

Resolves Launchpad issue #338914, reported by Tyler Hicks in 03/2009.
https://bugs.launchpad.net/ecryptfs/+bug/338914

Signed-off-by: Tim Sally 
Signed-off-by: Tyler Hicks 
Signed-off-by: Ben Hutchings

eCryptfs: Copy up POSIX ACL and read-only flags from lower mount

2012-11-16T16:47:18+00:00

commit 069ddcda37b2cf5bb4b6031a944c0e9359213262 upstream.

When the eCryptfs mount options do not include '-o acl', but the lower
filesystem's mount options do include 'acl', the MS_POSIXACL flag is not
flipped on in the eCryptfs super block flags. This flag is what the VFS
checks in do_last() when deciding if the current umask should be applied
to a newly created inode's mode or not. When a default POSIX ACL mask is
set on a directory, the current umask is incorrectly applied to new
inodes created in the directory. This patch ignores the MS_POSIXACL flag
passed into ecryptfs_mount() and sets the flag on the eCryptfs super
block depending on the flag's presence on the lower super block.

Additionally, it is incorrect to allow a writeable eCryptfs mount on top
of a read-only lower mount. This missing check did not allow writes to
the read-only lower mount because permissions checks are still performed
on the lower filesystem's objects but it is best to simply not allow a
rw mount on top of ro mount. However, a ro eCryptfs mount on top of a rw
mount is valid and still allowed.

https://launchpad.net/bugs/1009207

Signed-off-by: Tyler Hicks 
Reported-by: Stefan Beller 
Cc: John Johansen 
Signed-off-by: Ben Hutchings

ipv6: send unsolicited neighbour advertisements to all-nodes

2012-11-16T16:47:18+00:00

[ Upstream commit 60713a0ca7fd6651b951cc1b4dbd528d1fc0281b ]

As documented in RFC4861 (Neighbor Discovery for IP version 6) 7.2.6.,
unsolicited neighbour advertisements should be sent to the all-nodes
multicast address.

Signed-off-by: Hannes Frederic Sowa 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings

af-packet: fix oops when socket is not present

2012-11-16T16:47:17+00:00

[ Upstream commit a3d744e995d2b936c500585ae39d99ee251c89b4 ]

Due to a NULL dereference, the following patch is causing oops
in normal trafic condition:

commit c0de08d04215031d68fa13af36f347a6cfa252ca
Author: Eric Leblond 
Date:   Thu Aug 16 22:02:58 2012 +0000

    af_packet: don't emit packet on orig fanout group

This buggy patch was a feature fix and has reached most stable
branches.

When skb->sk is NULL and when packet fanout is used, there is a
crash in match_fanout_group where skb->sk is accessed.
This patch fixes the issue by returning false as soon as the
socket is NULL: this correspond to the wanted behavior because
the kernel as to resend the skb to all the listening socket in
this case.

Signed-off-by: Eric Leblond 
Signed-off-by: David S. Miller 
Signed-off-by: Ben Hutchings