bus: Add Tegra GMI support

This provides a driver to enable the use of the Generic Memory Interface
found on Tegra SoCs that can host various types of high-speed devices.

* tag 'tegra-for-4.10-bus' of git://git.kernel.org/pub/scm/linux/kernel/git/tegra/linux:
  bus: Add support for Tegra Generic Memory Interface
  dt/bindings: Add bindings for Tegra GMI controller

Signed-off-by: Olof Johansson <olof@lixom.net>

Document the devicetree bindings for the Generic Memory Interface (GMI)
bus driver found on Tegra SOCs.

Signed-off-by: Mirza Krak <mirza.krak@gmail.com>
Tested-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Tested-on: Colibri T20/T30 on EvalBoard V3.x and GMI-Memory Board
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Thierry Reding <treding@nvidia.com>

Create the driver for the da8xx master peripheral priority
configuration and implement support for writing to the three
Master Priority registers on da850 SoCs.

Reviewed-by: Kevin Hilman <khilman@baylibre.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
[nsekhar@ti.com: subject line adjustment]
Signed-off-by: Sekhar Nori <nsekhar@ti.com>

This adds device tree bindings for the External Bus Interface 2, EBI2
to the Qualcomm SoC drivers.

Cc: devicetree@vger.kernel.org
Acked-by: Rob Herring <robh+dt@kernel.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

Add binding documentation for the Tegra ACONNECT bus that is part of the
Audio Processing Engine (APE) on Tegra210. The ACONNECT bus is used to
access devices within the APE subsystem. The APE is located in a
separate power domain and so accesses made to the ACONNECT require the
power domain to be enabled as well as some platform specific clocks.

Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Thierry Reding <treding@nvidia.com>

omap-gpmc.c is a memory controller so move the binding to the
right place.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Tony Lindgren <tony@atomide.com>

GPMC provides 2 interrupts for NAND use. i.e. fifoevent and termcount.
Use IRQ domain for this. NAND device tree node can then
get the necessary interrupts by using gpmc as the interrupt parent.

Legacy boot uses gpmc_get_client_irq to get the
NAND interrupts from the GPMC IRQ domain.
Get rid of custom bitmasks and use IRQ domain for that
as well.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Tony Lindgren <tony@atomide.com>

In order to support advanced AAD timings, add these properties to the DT
GPMC bindings.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Roger Quadros <rogerq@ti.com>

The UniPhier System Bus is an external bus that connects on-board
devices to the UniPhier SoC.  Each bank (chip select) is dynamically
mapped to the CPU-viewed address base via the bus controller.  The
bus controller must be configured before any access to the bus.

This driver parses the "ranges" property of the System Bus node and
initialized the bus controller.  After the bus becomes ready, devices
below it are populated.

Note:
Each bank can be mapped anywhere in the supported address space;
there is nothing preventing us from assigning bank 0 on 0x42000000,
0x43000000, or anywhere as long as such region is not used by others.
So, the "ranges" is just one possible software configuration, which
does not seem to fit in device tree because device tree is a hardware
description language.  However, of_translate_address() requires
"ranges" in every bus node between CPUs and device mapped on the CPU
address space.  In other words, "ranges" properties must be statically
defined in device tree.  After some discussion, I decided the dynamic
address reassignment by the driver is too bothersome.  Instead, the
device tree should provide a reasonable translation setup that the OS
can rely on.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Olof Johansson <olof@lixom.net>

Reduced Serial Bus is a proprietary 2-line push-pull serial bus supporting
multiple slave devices. It was developed by Allwinner, Inc. and used by
Allwinner and X-Powers, Inc. for their line of PMICs and other peripheral
ICs.

Recent Allwinner SoCs, starting with the A23, have an RSB controller. This
is used to talk to the PMIC, and later with the A80 and A83 platform, the
audio codec IC.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: Olof Johansson <olof@lixom.net>