Pull input fixes from Dmitry Torokhov:
 "Just a few assorted driver fixes"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: elants_i2c - fix wake-on-touch
  Input: elan_i2c - set input device's vendor and product IDs
  Input: sun4i-lradc-keys - fix typo in binding documentation
  Input: atmel_mxt_ts - add maxtouch to I2C table for module autoload
  Input: arizona-haptic - fix disabling of haptics device
  Input: aiptek - fix crash on detecting device without endpoints
  Input: atmel_mxt_ts - add generic platform data for Chromebooks
  Input: parkbd - clear unused function pointers
  Input: walkera0701 - clear unused function pointers
  Input: turbografx - clear unused function pointers
  Input: gamecon - clear unused function pointers
  Input: db9 - clear unused function pointers

Pull MTD fixes from Brian Norris:
 "I was holding out on this pull request for a bit, since there are a
  few other small issues being discussed that look like 4.4-rc
  regressions.  Hopefully I can get those stabilized soon, but these are
  ready at any rate:

   - A little bit of a last-minute change for the device tree "fixed
     partition" binding.  This is needed because we might want to reuse
     the 'partitions' subnode for other sorts of partitioning
     descriptions -- e.g., for describing which on-flash partition
     format(s) might be used on the system.

   - Also tone down a warning message, since it is probably going to
     show up on a lot of systems where it should just be ignored"

* tag 'for-linus-20151217' of git://git.infradead.org/linux-mtd:
  doc: dt: mtd: partitions: add compatible property to "partitions" node
  mtd: ofpart: don't complain about missing 'partitions' node too loudly

Pull dmaengine fixes from Vinod Koul:
 "This has fixes spread thru driver, notably among them:

   - edma fixes for recent edma DT changes which went into 4.4
   - odd fixes for at_hdmac
   - minor fixes on bc dma and mic dma"

* tag 'dmaengine-fix-4.4-rc6' of git://git.infradead.org/users/vkoul/slave-dma:
  dmaengine: at_xdmac: fix at_xdmac_prep_dma_memcpy()
  dmaengine: edma: DT: Change reserved slot array from 16bit to 32bit type
  dmaengine: edma: DT: Change memcpy channel array from 16bit to 32bit type
  dmaengine: mic_x100: add missing spin_unlock
  dmaengine: bcm2835-dma: Convert to use DMA pool
  dmaengine: at_xdmac: fix bad behavior in interleaved mode
  dmaengine: at_xdmac: fix false condition for memset_sg transfers
  dmaengine: at_xdmac: fix macro typo

Pull ARM SoC fixes from Arnd Bergmann:
 "Here are a bunch of small bug fixes for various ARM platforms, nothing
  really sticks out this week, most of either fixes bugs in code that
  was just added in 4.4, or that has been broken for many years without
  anyone noticing.

  at91/sama5d2:
   - fix sama5de hardware setup of sd/mmc interface
   - proper selection of pinctrl drivers.  PIO4 is necessary for sama5d2

  berlin:
   - fix incorrect clock input for SDIO

  exynos:
   - Fix potential NULL pointer dereference in Exynos PMU driver.

  imx:
   - Fix vf610 SAI clock configuration bug which is discovered by the
     newly added master mode support in SAI audio driver.
   - Fix buggy L2 cache latency values in vf610 device trees, which may
     cause system hang when cpu runs at a higher frequency.

  ixp4xx:
   - fix prototypes for readl/writel functions

  ls2080a:
   - use little-endian register access for GPIO and SDHCI

  omap:
   - Fix clock source for ARM TWD and global timers on am437x
   - Always select REGULATOR_FIXED_VOLTAGE for omap2+ instead of when
     MACH_OMAP3_PANDORA is selected
   - Fix SPI DMA handles for dm816x as only some were mapped
   - Fix up mbox cells for dm816x to make mailbox usable

  pxa:
   - use PWM lookup table for all ezx machines

  s3c24xx:
   - Remove incorrect __init annotation from s3c24xx cpufreq driver
     structures.

  versatile:
   - fix PCI IRQ mapping on Versatile PB"

* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  ls2080a/dts: Add little endian property for GPIO IP block
  dt-bindings: define little-endian property for QorIQ GPIO
  ARM64: dts: ls2080a: fix eSDHC endianness
  ARM: dts: vf610: use reset values for L2 cache latencies
  ARM: pxa: use PWM lookup table for all machines
  ARM: dts: berlin: add 2nd clock for BG2Q sdhci0 and sdhci1
  ARM: dts: berlin: correct BG2Q's sdhci2 2nd clock
  ARM: dts: am4372: fix clock source for arm twd and global timers
  ARM: at91: fix pinctrl driver selection
  ARM: at91/dt: add always-on to 1.8V regulator
  ARM: dts: vf610: fix clock definition for SAI2
  ARM: imx: clk-vf610: fix SAI clock tree
  ARM: ixp4xx: fix read{b,w,l} return types
  irqchip/versatile-fpga: Fix PCI IRQ mapping on Versatile PB
  ARM: OMAP2+: enable REGULATOR_FIXED_VOLTAGE
  ARM: dts: add dm816x missing spi DT dma handles
  ARM: dts: add dm816x missing #mbox-cells
  cpufreq: s3c24xx: Do not mark s3c2410_plls_add as __init
  ARM: EXYNOS: Fix potential NULL pointer access in exynos_sys_powerdown_conf

Trivial typo fix ("mut" -> "must") in the sunxi LRADC-keys binding
documentation.

Signed-off-by: Karsten Merker <merker@debian.org>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

The GPIO block on different QorIQ chips could have registers in different
endianess.  Define the property to specify which endian is used by the
hardware.

Signed-off-by: Liu Gang <Gang.Liu@freescale.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Kevin Hilman <khilman@linaro.org>

This change makes the DT file to be easier to read since the reserved slots
array does not need the '/bits/ 16' to be specified, which might confuse
some people.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

This change makes the DT file to be easier to read since the memcpy
channels array does not need the '/bits/ 16' to be specified, which might
confuse some people.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Rob Herring <robh@kernel.org>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

As noted here [1], there are potentially future conflicts if we try to
use MTD's "partitions" subnode to describe anything besides just the
fixed-in-the-device-tree partitions currently described in this
document. Particularly, there was a proposal to use this node for the
AFS parser too.

It can pose a (small) problem to try to differentiate the following
nodes:

	// using binding as currently specified
	partitions {
		#address-cells = <x>;
		#size-cells = <y>;
		partition@0 {
			...;
		};
	};

and

	// proposed future binding
	partitions {
		compatible = "arm,arm-flash-structure";
	};

It's especially difficult if other uses of this node start having
subnodes.

So, since the "partitions" node is new in v4.4, let's fixup the binding
before release so that it requires a compatible property, so it's much
clearer to distinguish. e.g.:

	// proposed
	partitions {
		compatible = "fixed-partitions";
		#address-cells = <x>;
		#size-cells = <y>;
		partition@0 {
			...;
		};
	};

[1] Subject: "mtd: create a partition type device tree binding"
    http://lkml.kernel.org/g/20151113220039.GA74382@google.com
    http://lists.infradead.org/pipermail/linux-mtd/2015-November/063355.html
    http://lists.infradead.org/pipermail/linux-mtd/2015-November/063364.html

Cc: Michal Suchanek <hramrach@gmail.com>
Signed-off-by: Brian Norris <computersforpeace@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>