Pull input subsystem fixes from Dmitry Torokhov:
 "Just a few fixups to various drivers"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
  Input: elantech - fix touchpad initialization on Gigabyte U2442
  Input: tca8418 - fix loading this driver as a module from a device tree
  Input: bma150 - extend chip detection for bma180
  Input: atkbd - fix keyboard not working on some LG laptops
  Input: synaptics - add min/max quirk for ThinkPad Edge E431

Pull networking fixes from David Miller:

 1) e1000e computes header length incorrectly wrt vlans, fix from Vlad
    Yasevich.

 2) ns_capable() check in sock_diag netlink code, from Andrew
    Lutomirski.

 3) Fix invalid queue pairs handling in virtio_net, from Amos Kong.

 4) Checksum offloading busted in sxgbe driver due to incorrect
    descriptor layout, fix from Byungho An.

 5) Fix build failure with SMC_DEBUG set to 2 or larger, from Zi Shen
    Lim.

 6) Fix uninitialized A and X registers in BPF interpreter, from Alexei
    Starovoitov.

 7) Fix arch dependencies of candence driver.

 8) Fix netlink capabilities checking tree-wide, from Eric W Biederman.

 9) Don't dump IFLA_VF_PORTS if netlink request didn't ask for it in
    IFLA_EXT_MASK, from David Gibson.

10) IPV6 FIB dump restart doesn't handle table changes that happen
    meanwhile, causing the code to loop forever or emit dups, fix from
    Kumar Sandararajan.

11) Memory leak on VF removal in bnx2x, from Yuval Mintz.

12) Bug fixes for new Altera TSE driver from Vince Bridgers.

13) Fix route lookup key in SCTP, from Xugeng Zhang.

14) Use BH blocking spinlocks in SLIP, as per a similar fix to CAN/SLCAN
    driver.  From Oliver Hartkopp.

15) TCP doesn't bump retransmit counters in some code paths, fix from
    Eric Dumazet.

16) Clamp delayed_ack in tcp_cubic to prevent theoretical divides by
    zero.  Fix from Liu Yu.

17) Fix locking imbalance in error paths of HHF packet scheduler, from
    John Fastabend.

18) Properly reference the transport module when vsock_core_init() runs,
    from Andy King.

19) Fix buffer overflow in cdc_ncm driver, from Bjørn Mork.

20) IP_ECN_decapsulate() doesn't see a correct SKB network header in
    ip_tunnel_rcv(), fix from Ying Cai.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (132 commits)
  net: macb: Fix race between HW and driver
  net: macb: Remove 'unlikely' optimization
  net: macb: Re-enable RX interrupt only when RX is done
  net: macb: Clear interrupt flags
  net: macb: Pass same size to DMA_UNMAP as used for DMA_MAP
  ip_tunnel: Set network header properly for IP_ECN_decapsulate()
  e1000e: Restrict MDIO Slow Mode workaround to relevant parts
  e1000e: Fix issue with link flap on 82579
  e1000e: Expand workaround for 10Mb HD throughput bug
  e1000e: Workaround for dropped packets in Gig/100 speeds on 82579
  net/mlx4_core: Don't issue PCIe speed/width checks for VFs
  net/mlx4_core: Load the Eth driver first
  net/mlx4_core: Fix slave id computation for single port VF
  net/mlx4_core: Adjust port number in qp_attach wrapper when detaching
  net: cdc_ncm: fix buffer overflow
  Altera TSE: ALTERA_TSE should depend on HAS_DMA
  vsock: Make transport the proto owner
  net: sched: lock imbalance in hhf qdisc
  net: mvmdio: Check for a valid interrupt instead of an error
  net phy: Check for aneg completion before setting state to PHY_RUNNING
  ...

The hw_version 3 Elantech touchpad on the Gigabyte U2442 does not accept
0x0b as initialization value for r10, this stand-alone version of the
driver: http://planet76.com/drivers/elantech/psmouse-elantech-v6.tar.bz2

Uses 0x03 which does work, so this means not setting bit 3 of r10 which
sets: "Enable Real H/W Resolution In Absolute mode"

Which will result in half the x and y resolution we get with that bit set,
so simply not setting it everywhere is not a solution. We've been unable to
find a way to identify touchpads where setting the bit will fail, so this
patch uses a dmi based blacklist for this.

https://bugzilla.kernel.org/show_bug.cgi?id=61151

Cc: stable@vger.kernel.org
Reported-by: Philipp Wolfer <ph.wolfer@gmail.com>
Tested-by: Philipp Wolfer <ph.wolfer@gmail.com>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Pull arm64 fixes from Catalin Marinas:
 "These are mostly arm64 fixes with an additional arm(64) platform fix
  for the initialisation of vexpress clocks (the latter only affecting
  arm64; the arch/arm64 code is SoC agnostic and does not rely on early
  SoC-specific calls)

   - vexpress platform clocks initialisation moved earlier following the
     arm64 move of of_clk_init() call in a previous commit
   - Default DMA ops changed to non-coherent to preserve compatibility
     with 32-bit ARM DT files.  The "dma-coherent" property can be used
     to explicitly mark a device coherent.  The Applied Micro DT file
     has been updated to avoid DMA cache maintenance for the X-Gene SATA
     controller (the only arm64 related driver with such assumption in
     -rc mainline)
   - Fixmap correction for earlyprintk
   - kern_addr_valid() fix for huge pages"

* tag 'arm64-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm64/linux:
  vexpress: Initialise the sysregs before setting up the clocks
  arm64: Mark the Applied Micro X-Gene SATA controller as DMA coherent
  arm64: Use bus notifiers to set per-device coherent DMA ops
  arm64: Make default dma_ops to be noncoherent
  arm64: fixmap: fix missing sub-page offset for earlyprintk
  arm64: Fix for the arm64 kern_addr_valid() function

Since the default DMA ops for arm64 are non-coherent, mark the X-Gene
controller explicitly as dma-coherent to avoid additional cache
maintenance.

Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: Loc Ho <lho@apm.com>

Pull timer fixes from Thomas Gleixner:
 "This update brings along:

   - Two fixes for long standing bugs in the hrtimer code, one which
     prevents remote enqueuing and the other preventing arbitrary delays
     after a interrupt hang was detected

   - A fix in the timer wheel which prevents math overflow

   - A fix for a long standing issue with the architected ARM timer
     related to the C3STOP mechanism.

   - A trivial compile fix for nspire SoC clocksource"

* 'timers-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  timer: Prevent overflow in apply_slack
  hrtimer: Prevent remote enqueue of leftmost timers
  hrtimer: Prevent all reprogramming if hang detected
  clocksource: nspire: Fix compiler warning
  clocksource: arch_arm_timer: Fix age-old arch timer C3STOP detection issue

Pull sound fixes from Takashi Iwai:
 "A few collections of small eggs that have been gathered during the
  Easter holidays.  Mostly small ASoC fixes, with a HD-audio quirk and a
  workaround for Nvidia controller"

* tag 'sound-3.15-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound:
  ALSA: hda - Suppress CORBRP clear on Nvidia controller chips
  ALSA: hda - add headset mic detect quirk for a Dell laptop
  ASoC: jz4740: Remove Makefile entry for removed file
  ASoC: Intel: Fix audio crash due to negative address offset
  ASoC: dapm: Fix widget double free with auto-disable DAPM kcontrol
  ASoC: Intel: Fix incorrect sizeof() in sst_hsw_stream_get_volume()
  ASoC: Intel: some incorrect sizeof() usages
  ASoC: cs42l73: Convert to use devm_gpio_request_one
  ASoC: cs42l52: Convert to use devm_gpio_request_one
  ASoC: tlv320aic31xx: document that the regulators are mandatory
  ASoC: fsl_spdif: Fix wrong OFFSET of STC_SYSCLK_DIV
  ASoC: alc5623: Fix regmap endianness
  ASoC: tlv320aic3x: fix shared reset pin for DT
  ASoC: rsnd: fix clock prepare/unprepare

clockevent fixes for 3.15 from Daniel Lezcano:
 * Lorenzo Pieralizi fixed an issue with the arch_arm_timer where the
   C3STOP flag for all the arch can cause some trouble by setting the
   flag only if the power domain is not always on
 * Alexander Shiyan fixed a compilation by changing the init function
   to the right prototype

ARM arch timers are tightly coupled with the CPU logic and lose context
on platform implementing HW power management when cores are powered
down at run-time. Marking the arch timers as C3STOP regardless of power
management capabilities causes issues on platforms with no power management,
since in that case the arch timers cannot possibly enter states where the
timer loses context at runtime and therefore can always be used as a high
resolution clockevent device.

In order to fix the C3STOP issue in a way compliant with how real HW
works, this patch adds a boolean property to the arch timer bindings
to define if the arch timer is managed by an always-on power domain.

This power domain is present on all ARM platforms to date, and manages
HW that must not be turned off, whatever the state of other HW
components (eg power controller). On platforms with no power management
capabilities, it is the only power domain present, which encompasses
and manages power supply for all HW components in the system.

If the timer is powered by the always-on power domain, the always-on
property must be present in the bindings which means that the timer cannot
be shutdown at runtime, so it is not a C3STOP clockevent device.
If the timer binding does not contain the always-on property, the timer is
assumed to be power-gateable, hence it must be defined as a C3STOP
clockevent device.

Cc: Daniel Lezcano <daniel.lezcano@linaro.org>
Cc: Magnus Damm <damm@opensource.se>
Cc: Marc Carino <marc.ceeeee@gmail.com>
Cc: Mark Rutland <mark.rutland@arm.com>
Acked-by: Marc Zyngier <marc.zyngier@arm.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>

This adds ability for the arc_emac to really handle its supplying clock.
To get the needed clock-frequency either a real clock or the previous
clock-frequency property must be provided.

Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Tested-by: Max Schwarz <max.schwarz@online.de>
Signed-off-by: David S. Miller <davem@davemloft.net>