commit 5ae256dcd91bf308826a4ac19598b27ebb86a536 upstream.

The current serial UART code, while fidling with ocp idlemode bits,
forget about the smart idle wakeup bit even if it is supported by
UART IP block. This will lead to missing the module wakeup on OMAP's
where the smart idle wakeup is supported.

This was the root cause of the console sluggishness issue, I have been
observing on OMAP4 devices and also can be potential reason for some
other UART wakeup issues.

Signed-off-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Acked-by: Kevin Hilman <khilman@ti.com>
Acked-by: Govindraj.R <govindraj.raja@ti.com>
Reviewed-by: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull two IOMMU fixes from Joerg Roedel:
 "The first is an additional fix for the OMAP initialization order issue
  and the second patch fixes a possible section mismatch which can lead
  to a kernel crash in the AMD IOMMU driver when suspend/resume is used
  and the compiler has not inlined the iommu_set_device_table function."

* tag 'iommu-fixes-v3.3-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/joro/iommu:
  x86/amd: iommu_set_device_table() must not be __init
  ARM: OMAP: fix iommu, not mailbox

* 'fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
  ARM: OMAP2+: Fix module build errors with CONFIG_OMAP4_ERRATA_I688
  ARM: OMAP: id: Add missing break statement in omap3xxx_check_revision
  ARM: OMAP2+: Remove apply_uV constraints for fixed regulator
  ARM: OMAP: irqs: Fix NR_IRQS value to handle PRCM interrupts

While building modules with randconfig the below errors are observed.

ERROR: "omap_bus_sync" [drivers/watchdog/sp805_wdt.ko] undefined!
ERROR: "omap_bus_sync" [drivers/watchdog/dw_wdt.ko] undefined!
ERROR: "omap_bus_sync" [drivers/virtio/virtio_ring.ko] undefined!
ERROR: "omap_bus_sync" [drivers/video/sm501fb.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/mon/usbmon.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/host/sl811-hcd.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/host/ohci-hcd.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/host/isp1760.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/host/isp1362-hcd.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/host/isp116x-hcd.ko] undefined!
ERROR: "omap_bus_sync" [drivers/usb/core/usbcore.ko] undefined!
ERROR: "omap_bus_sync" [drivers/tty/serial/altera_uart.ko] undefined!
ERROR: "omap_bus_sync" [drivers/tty/serial/altera_jtaguart.ko] undefined!
ERROR: "omap_bus_sync" [drivers/tty/serial/8250/8250_dw.ko] undefined!
ERROR: "omap_bus_sync" [drivers/ssb/ssb.ko] undefined!
ERROR: "omap_bus_sync" [drivers/rtc/rtc-cmos.ko] undefined!
ERROR: "omap_bus_sync" [drivers/rtc/rtc-bq4802.ko] undefined!
ERROR: "omap_bus_sync" [drivers/mtd/nand/tmio_nand.ko] undefined!
ERROR: "omap_bus_sync" [drivers/mtd/nand/omap2.ko] undefined!

Signed-off-by: R Sricharan <r.sricharan@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

For some weird (freudian?) reason, commit 435792d "ARM: OMAP: make
iommu subsys_initcall to fix builtin omap3isp" unintentionally changed
the mailbox's initcall instead of the iommu's.

Fix that.

Reported-by: Fernando Guzman Lugo <fernando.lugo@ti.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Cc: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Cc: Joerg Roedel <Joerg.Roedel@amd.com>
Cc: Tony Lindgren <tony@atomide.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>

Add missing break statement in the function omap3xxx_check_revision.

The commit id 4390f5b2cb1f56 [ARM: OMAP: TI814X: Add cpu type macros
and detection support], removed the 'break' statement from the function
omap3xxx_check_revision(), resulting into wrong omap/cpu_revision
initialization for AM335x devices.

Signed-off-by: Vaibhav Hiremath <hvaibhav@ti.com>
[tony@atomide.com: refreshed to apply after changes to cpu_rev]
Signed-off-by: Tony Lindgren <tony@atomide.com>

Arnd Bergmann says:
 "Another set of arm-soc bug fixes on top of v3.3-rc5.  The few larger
  bits are all for devices that still need to get set up in board code.

  Only three platforms are in this set of fixes: omap2+, pxa and lpc32xx."

* tag 'fixes-3.3-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (22 commits)
  ARM: LPC32xx: serial.c: Fixed loop limit
  ARM: LPC32xx: serial.c: HW bug workaround
  ARM: LPC32xx: irq.c: Clear latched event
  ARM: LPC32xx: Fix interrupt controller init
  ARM: LPC32xx: Fix irq on GPI_28
  ARM: OMAP2: fix mailbox init code
  ARM: OMAP2+: gpmc-smsc911x: add required smsc911x regulators
  ARM: OMAP1: Fix out-of-bounds array access for Innovator
  OMAP3 EVM: remove out-of-bounds array access of gpio_leds
  ARM: OMAP: Fix build error when mmc_omap is built as module
  ARM: OMAP: Fix kernel panic with HSMMC when twl4030_gpio is a module
  pxa/hx4700: add platform device and I2C info for AK4641 codec
  arch/arm/mach-pxa/: included linux/gpio.h twice
  arch/arm/mach-mmp/: some files include some headers twice
  ARM: pxa: fix error handling in pxa2xx_drv_pcmcia_probe
  ARM: pxa: fix including linux/gpio.h twice
  ARM: pxa: fix mixed declarations and code in sharpsl_pm
  ARM: pxa: fix wrong parsing gpio event on spitz
  ARM: OMAP2+: usb-host: fix compile warning
  ARM: OMAP4: Move the barrier memboclk_steal() as part of reserve callback
  ...

VUSB is a fixed regulator, so get rid of the apply_uV constraint
for it, which fixes the following error seen at boot on omap4
SDP and PANDA boards.

machine_constraints_voltage: VUSB: failed to apply 3300000uV constraint
twl_reg twl_reg.46: can't register VUSB, -22
twl_reg: probe of twl_reg.46 failed with error -22

Signed-off-by: Rajendra Nayak <rnayak@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

IOMMU fixes for Linux 3.3-rc5

All the fixes are for the OMAP IOMMU driver. The first patch is the
biggest one. It fixes the calls of the function omap_find_iovm_area() in
the omap-iommu-debug module which expects a 'struct device' parameter
since commit fabdbca instead of an omap_iommu handle. The
omap-iommu-debug code still passed the handle to the function which
caused a crash.

The second patch fixes a NULL pointer dereference in the OMAP code and
the third patch makes sure that the omap-iommu is initialized before the
omap-isp driver, which relies on the iommu. The last patch is only a
workaround until defered probing is implemented.

* tag 'iommu-fixes-v3.3-rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/joro/iommu:
  ARM: OMAP: make iommu subsys_initcall to fix builtin omap3isp
  iommu/omap: fix NULL pointer dereference
  iommu/omap: fix erroneous omap-iommu-debug API calls

* 'lpc32xx/fixes' of git://git.antcom.de/linux-2.6: (5 commits)
  ARM: LPC32xx: serial.c: Fixed loop limit
  ARM: LPC32xx: serial.c: HW bug workaround
  ARM: LPC32xx: irq.c: Clear latched event
  ARM: LPC32xx: Fix interrupt controller init
  ARM: LPC32xx: Fix irq on GPI_28

Update to Linux 3.3-rc5

Signed-off-by: Arnd Bergmann <arnd@arndb.de>