Pull xen fixes from Juergen Gross:
 "Two very minor fixes: one remove of a #include for an unused header
  and a fix of the xen ML address in MAINTAINERS"

* tag 'for-linus-5.0-rc6-tag' of git://git.kernel.org/pub/scm/linux/kernel/git/xen/tip:
  MAINTAINERS: unify reference to xen-devel list
  arch/arm/xen: Remove duplicate header

Pull ARM SoC fixes from Arnd Bergmann:
 "This is a bit larger than normal, as we had not managed to send out a
  pull request before traveling for a week without my signing key.

  There are multiple code fixes for older bugs, all of which should get
  backported into stable kernels:

   - tango: one fix for multiplatform configurations broken on other
     platforms when tango is enabled

   - arm_scmi: device unregistration fix

   - iop32x: fix kernel oops from extraneous __init annotation

   - pxa: remove a double kfree

   - fsl qbman: close an interrupt clearing race

  The rest is the usual collection of smaller fixes for device tree
  files, on the renesas, allwinner, meson, omap, davinci, qualcomm and
  imx platforms.

  Some of these are for compile-time warnings, most are for board
  specific functionality that fails to work because of incorrect
  settings"

* tag 'armsoc-fixes-5.0' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (30 commits)
  ARM: tango: Improve ARCH_MULTIPLATFORM compatibility
  firmware: arm_scmi: provide the mandatory device release callback
  ARM: iop32x/n2100: fix PCI IRQ mapping
  arm64: dts: add msm8996 compatible to gicv3
  ARM: dts: am335x-shc.dts: fix wrong cd pin level
  ARM: dts: n900: fix mmc1 card detect gpio polarity
  ARM: dts: omap3-gta04: Fix graph_port warning
  ARM: pxa: ssp: unneeded to free devm_ allocated data
  ARM: dts: r8a7743: Convert to new LVDS DT bindings
  soc: fsl: qbman: avoid race in clearing QMan interrupt
  arm64: dts: renesas: r8a77965: Enable DMA for SCIF2
  arm64: dts: renesas: r8a7796: Enable DMA for SCIF2
  arm64: dts: renesas: r8a774a1: Enable DMA for SCIF2
  ARM: dts: da850: fix interrupt numbers for clocksource
  dt-bindings: imx8mq: Number clocks consecutively
  arm64: dts: meson: Fix mmc cd-gpios polarity
  ARM: dts: imx6sx: correct backward compatible of gpt
  ARM: dts: imx: replace gpio-key,wakeup with wakeup-source property
  ARM: dts: vf610-bk4: fix incorrect #address-cells for dspi3
  ARM: dts: meson8m2: mxiii-plus: mark the SD card detection GPIO active-low
  ...

Pull PCI fixes from Bjorn Helgaas:

 - Revert armada8k GPIO reset change that broke Macchiatobin booting
   (Baruch Siach)

 - Use actual size config reads on ARM cns3xxx (Koen Vandeputte)

 - Fix ARM cns3xxx config write alignment issue (Koen Vandeputte)

 - Fix imx6 PHY device link error checking (Leonard Crestez)

 - Fix imx6 probe failure on chips without separate PCI power domain
   (Leonard Crestez)

* tag 'pci-v5.0-fixes-3' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci:
  Revert "PCI: armada8k: Add support for gpio controlled reset signal"
  ARM: cns3xxx: Use actual size reads for PCIe
  ARM: cns3xxx: Fix writing to wrong PCI config registers after alignment
  PCI: imx: Fix checking pd_pcie_phy device link addition
  PCI: imx: Fix probe failure without power domain

commit 802b7c06adc7 ("ARM: cns3xxx: Convert PCI to use generic config
accessors") reimplemented cns3xxx_pci_read_config() using
pci_generic_config_read32(), which preserved the property of only doing
32-bit reads.

It also replaced cns3xxx_pci_write_config() with pci_generic_config_write(),
so it changed writes from always being 32 bits to being the actual size,
which works just fine.

Given that:

- The documentation does not mention that only 32 bit access is allowed.
- Writes are already executed using the actual size
- Extensive testing shows that 8b, 16b and 32b reads work as intended

Allow read access of any size by replacing pci_generic_config_read32()
with the pci_generic_config_read() accessors.

Fixes: 802b7c06adc7 ("ARM: cns3xxx: Convert PCI to use generic config accessors")
Suggested-by: Bjorn Helgaas <bhelgaas@google.com>
Signed-off-by: Koen Vandeputte <koen.vandeputte@ncentric.com>
[lorenzo.pieralisi@arm.com: updated commit log]
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Acked-by: Krzysztof Halasa <khalasa@piap.pl>
Acked-by: Arnd Bergmann <arnd@arndb.de>
CC: Krzysztof Halasa <khalasa@piap.pl>
CC: Olof Johansson <olof@lixom.net>
CC: Robin Leblon <robin.leblon@ncentric.com>
CC: Rob Herring <robh@kernel.org>
CC: Russell King <linux@armlinux.org.uk>
CC: Tim Harvey <tharvey@gateworks.com>

Originally, cns3xxx used its own functions for mapping, reading and
writing config registers.

Commit 802b7c06adc7 ("ARM: cns3xxx: Convert PCI to use generic config
accessors") removed the internal PCI config write function in favor of
the generic one:

  cns3xxx_pci_write_config() --> pci_generic_config_write()

cns3xxx_pci_write_config() expected aligned addresses, being produced by
cns3xxx_pci_map_bus() while the generic one pci_generic_config_write()
actually expects the real address as both the function and hardware are
capable of byte-aligned writes.

This currently leads to pci_generic_config_write() writing to the wrong
registers.

For instance, upon ath9k module loading:

- driver ath9k gets loaded
- The driver wants to write value 0xA8 to register PCI_LATENCY_TIMER,
  located at 0x0D
- cns3xxx_pci_map_bus() aligns the address to 0x0C
- pci_generic_config_write() effectively writes 0xA8 into register 0x0C
  (CACHE_LINE_SIZE)

Fix the bug by removing the alignment in the cns3xxx mapping function.

Fixes: 802b7c06adc7 ("ARM: cns3xxx: Convert PCI to use generic config accessors")
Signed-off-by: Koen Vandeputte <koen.vandeputte@ncentric.com>
[lorenzo.pieralisi@arm.com: updated commit log]
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Acked-by: Krzysztof Halasa <khalasa@piap.pl>
Acked-by: Tim Harvey <tharvey@gateworks.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
CC: stable@vger.kernel.org	# v4.0+
CC: Bjorn Helgaas <bhelgaas@google.com>
CC: Olof Johansson <olof@lixom.net>
CC: Robin Leblon <robin.leblon@ncentric.com>
CC: Rob Herring <robh@kernel.org>
CC: Russell King <linux@armlinux.org.uk>

Calling platform-specific code unconditionally blows up when running
an ARCH_MULTIPLATFORM kernel on a different platform. Don't do it.

Reported-by: Paolo Pisati <p.pisati@gmail.com>
Signed-off-by: Marc Gonzalez <marc.w.gonzalez@free.fr>
Acked-by: Pavel Machek <pavel@ucw.cz>
Cc: stable@vger.kernel.org # v4.8+
Fixes: a30eceb7a59d ("ARM: tango: add Suspend-to-RAM support")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Third Round of Renesas ARM Based SoC Fixes for v5.0

* Convert to new LVDS DT bindings fixing a regression introduced in v4.17

* tag 'renesas-fixes3-for-v5.0' of git://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas:
  ARM: dts: r8a7743: Convert to new LVDS DT bindings

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Allwinner Fixes for 5.0

A couple of device tree fixes for the 5.0 cycle:

  - Add missing clock-output-names for the osc24M clock on sun6i/A31

    The Linux clock driver uses the device node as the clock name if
    the property is missing. The node name was changed in 5.0-rc1,
    breaking a subtle dependency in the sunxi-ng clock driver, and
    renders Linux unable to completely boot up.

  - Add alias for Ethernet controller on Beelink X2

    This allows the bootloader to assign a deterministically generated
    MAC address to it.

  - Add property to enable USB VBUS regulator on OrangePi Win

    The board had defined the constraints for the regulator, but was
    missing the property to actually enable it.

* tag 'sunxi-fixes-for-5.0' of git://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux:
  arm64: dts: allwinner: a64: Fix USB OTG regulator
  ARM: dts: sun8i: h3: Add ethernet0 alias to Beelink X2
  ARM: dts: sun6i: Add clock-output-names to osc24M clock
  arm64: dts: allwinner: a64: Fix the video engine compatible

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Amlogic fixes for v5.0-rc, round 2
- several fixups for the GPIO cd-inverted change
- IRQ trigger fixes for MAC IRQ

* tag 'amlogic-fixes-2.1' of git://git.kernel.org/pub/scm/linux/kernel/git/khilman/linux-amlogic:
  arm64: dts: meson: Fix mmc cd-gpios polarity
  ARM: dts: meson8m2: mxiii-plus: mark the SD card detection GPIO active-low
  ARM: dts: meson8b: ec100: mark the SD card detection GPIO active-low
  ARM: dts: meson8b: odroidc1: mark the SD card detection GPIO active-low
  arm: dts: meson: Fix IRQ trigger type for macirq

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Booting 4.20 on a TheCUS N2100 results in a kernel oops while probing
PCI, due to n2100_pci_map_irq() having been discarded during boot.

Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Cc: stable@vger.kernel.org # 2.6.18+
Signed-off-by: Arnd Bergmann <arnd@arndb.de>