Pull kvm fixes from Paolo Bonzini:
 "ARM:

   - Take care of faults occuring between the PARange and IPA range by
     injecting an exception

   - Fix S2 faults taken from a host EL0 in protected mode

   - Work around Oops caused by a PMU access from a 32bit guest when PMU
     has been created. This is a temporary bodge until we fix it for
     good.

  x86:

   - Fix potential races when walking host page table

   - Fix shadow page table leak when KVM runs nested

   - Work around bug in userspace when KVM synthesizes leaf 0x80000021
     on older (pre-EPYC) or Intel processors

  Generic (but affects only RISC-V):

   - Fix bad user ABI for KVM_EXIT_SYSTEM_EVENT"

* tag 'for-linus' of git://git.kernel.org/pub/scm/virt/kvm/kvm:
  KVM: x86: work around QEMU issue with synthetic CPUID leaves
  Revert "x86/mm: Introduce lookup_address_in_mm()"
  KVM: x86/mmu: fix potential races when walking host page table
  KVM: fix bad user ABI for KVM_EXIT_SYSTEM_EVENT
  KVM: x86/mmu: Do not create SPTEs for GFNs that exceed host.MAXPHYADDR
  KVM: arm64: Inject exception on out-of-IPA-range translation fault
  KVM/arm64: Don't emulate a PMU for 32-bit guests if feature not set
  KVM: arm64: Handle host stage-2 faults from 32-bit EL0

Pull x86 fixes from Borislav Petkov:

 - A fix to disable PCI/MSI[-X] masking for XEN_HVM guests as that is
   solely controlled by the hypervisor

 - A build fix to make the function prototype (__warn()) as visible as
   the definition itself

 - A bunch of objtool annotation fixes which have accumulated over time

 - An ORC unwinder fix to handle bad input gracefully

 - Well, we thought the microcode gets loaded in time in order to
   restore the microcode-emulated MSRs but we thought wrong. So there's
   a fix for that to have the ordering done properly

 - Add new Intel model numbers

 - A spelling fix

* tag 'x86_urgent_for_v5.18_rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  x86/pci/xen: Disable PCI/MSI[-X] masking for XEN_HVM guests
  bug: Have __warn() prototype defined unconditionally
  x86/Kconfig: fix the spelling of 'becoming' in X86_KERNEL_IBT config
  objtool: Use offstr() to print address of missing ENDBR
  objtool: Print data address for "!ENDBR" data warnings
  x86/xen: Add ANNOTATE_NOENDBR to startup_xen()
  x86/uaccess: Add ENDBR to __put_user_nocheck*()
  x86/retpoline: Add ANNOTATE_NOENDBR for retpolines
  x86/static_call: Add ANNOTATE_NOENDBR to static call trampoline
  objtool: Enable unreachable warnings for CLANG LTO
  x86,objtool: Explicitly mark idtentry_body()s tail REACHABLE
  x86,objtool: Mark cpu_startup_entry() __noreturn
  x86,xen,objtool: Add UNWIND hint
  lib/strn*,objtool: Enforce user_access_begin() rules
  MAINTAINERS: Add x86 unwinding entry
  x86/unwind/orc: Recheck address range after stack info was updated
  x86/cpu: Load microcode during restore_processor_state()
  x86/cpu: Add new Alderlake and Raptorlake CPU model numbers

Pull objtool fixes from Borislav Petkov:
 "A bunch of objtool fixes to improve unwinding, sibling call detection,
  fallthrough detection and relocation handling of weak symbols when the
  toolchain strips section symbols"

* tag 'objtool_urgent_for_v5.18_rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  objtool: Fix code relocs vs weak symbols
  objtool: Fix type of reloc::addend
  objtool: Fix function fallthrough detection for vmlinux
  objtool: Fix sibling call detection in alternatives
  objtool: Don't set 'jump_dest' for sibling calls
  x86/uaccess: Don't jump between functions

Pull ARM SoC fixes from Arnd Bergmann:

 - A fix for a regression caused by the previous set of bugfixes
   changing tegra and at91 pinctrl properties.

   More work is needed to figure out what this should actually be, but a
   revert makes it work for the moment.

 - Defconfig regression fixes for tegra after renamed symbols

 - Build-time warning and static checker fixes for imx, op-tee, sunxi,
   meson, at91, and omap

 - More at91 DT fixes for audio, regulator and spi nodes

 - A regression fix for Renesas Hyperflash memory probe

 - A stability fix for amlogic boards, modifying the allowed cpufreq
   states

 - Multiple fixes for system suspend on omap2+

 - DT fixes for various i.MX bugs

 - A probe error fix for imx6ull-colibri MMC

 - A MAINTAINERS file entry for samsung bug reports

* tag 'soc-fixes-5.18-3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (42 commits)
  Revert "arm: dts: at91: Fix boolean properties with values"
  bus: sunxi-rsb: Fix the return value of sunxi_rsb_device_create()
  Revert "arm64: dts: tegra: Fix boolean properties with values"
  arm64: dts: imx8mn-ddr4-evk: Describe the 32.768 kHz PMIC clock
  ARM: dts: imx6ull-colibri: fix vqmmc regulator
  MAINTAINERS: add Bug entry for Samsung and memory controller drivers
  memory: renesas-rpc-if: Fix HF/OSPI data transfer in Manual Mode
  ARM: dts: logicpd-som-lv: Fix wrong pinmuxing on OMAP35
  ARM: dts: am3517-evm: Fix misc pinmuxing
  ARM: dts: am33xx-l4: Add missing touchscreen clock properties
  ARM: dts: Fix mmc order for omap3-gta04
  ARM: dts: at91: fix pinctrl phandles
  ARM: dts: at91: sama5d4_xplained: fix pinctrl phandle name
  ARM: dts: at91: Describe regulators on at91sam9g20ek
  ARM: dts: at91: Map MCLK for wm8731 on at91sam9g20ek
  ARM: dts: at91: Fix boolean properties with values
  ARM: dts: at91: use generic node name for dataflash
  ARM: dts: at91: align SPI NOR node name with dtschema
  ARM: dts: at91: sama7g5ek: Align the impedance of the QSPI0's HSIO and PCB lines
  ARM: dts: at91: sama7g5ek: enable pull-up on flexcom3 console lines
  ...

Pull clk fixes from Stephen Boyd:
 "A semi-large pile of clk driver fixes this time around.

  Nothing is touching the core so these fixes are fairly well contained
  to specific devices that use these clk drivers.

   - Some Allwinner SoC fixes to gracefully handle errors and mark an
     RTC clk as critical so that the RTC keeps ticking.

   - Fix AXI bus clks and RTC clk design for Microchip PolarFire SoC
     driver introduced this cycle. This has some devicetree bits acked
     by riscv maintainers. We're fixing it now so that the prior
     bindings aren't released in a major kernel version.

   - Remove a reset on Microchip PolarFire SoCs that broke when enabling
     CONFIG_PM.

   - Set a min/max for the Qualcomm graphics clk. This got broken by the
     clk rate range patches introduced this cycle"

* tag 'clk-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux:
  clk: sunxi: sun9i-mmc: check return value after calling platform_get_resource()
  clk: sunxi-ng: sun6i-rtc: Mark rtc-32k as critical
  riscv: dts: microchip: reparent mpfs clocks
  clk: microchip: mpfs: add RTCREF clock control
  clk: microchip: mpfs: re-parent the configurable clocks
  dt-bindings: rtc: add refclk to mpfs-rtc
  dt-bindings: clk: mpfs: add defines for two new clocks
  dt-bindings: clk: mpfs document msspll dri registers
  riscv: dts: microchip: fix usage of fic clocks on mpfs
  clk: microchip: mpfs: mark CLK_ATHENA as critical
  clk: microchip: mpfs: fix parents for FIC clocks
  clk: qcom: clk-rcg2: fix gfx3d frequency calculation
  clk: microchip: mpfs: don't reset disabled peripherals
  clk: sunxi-ng: fix not NULL terminated coccicheck error

This reverts commit 0dc23d1a8e17, which caused another regression
as the pinctrl code actually expects an integer value of 0 or 1
rather than a simple boolean property.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Synthesizing AMD leaves up to 0x80000021 caused problems with QEMU,
which assumes the *host* CPUID[0x80000000].EAX is higher or equal
to what KVM_GET_SUPPORTED_CPUID reports.

This causes QEMU to issue bogus host CPUIDs when preparing the input
to KVM_SET_CPUID2.  It can even get into an infinite loop, which is
only terminated by an abort():

   cpuid_data is full, no space for cpuid(eax:0x8000001d,ecx:0x3e)

To work around this, only synthesize those leaves if 0x8000001d exists
on the host.  The synthetic 0x80000021 leaf is mostly useful on Zen2,
which satisfies the condition.

Fixes: f144c49e8c39 ("KVM: x86: synthesize CPUID leaf 0x80000021h if useful")
Reported-by: Maxim Levitsky <mlevitsk@redhat.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

Pull RISC-V fixes from Palmer Dabbelt:

 - A fix to properly ensure a single CPU is running during patch_text().

 - A defconfig update to include RPMSG_CTRL when RPMSG_CHAR was set,
   necessary after a recent refactoring.

* tag 'riscv-for-linus-5.18-rc5' of git://git.kernel.org/pub/scm/linux/kernel/git/riscv/linux:
  RISC-V: configs: Configs that had RPMSG_CHAR now get RPMSG_CTRL
  riscv: patch_text: Fixup last cpu should be master

Pull arm64 fix from Will Deacon:
 "Rename and reallocate the PT_ARM_MEMTAG_MTE ELF segment type.

  This is a fix to the MTE ELF ABI for a bug that was added during the
  most recent merge window as part of the coredump support.

  The issue is that the value assigned to the new PT_ARM_MEMTAG_MTE
  segment type has already been allocated to PT_AARCH64_UNWIND by the
  ELF ABI, so we've bumped the value and changed the name of the
  identifier to be better aligned with the existing one"

* tag 'arm64-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm64/linux:
  elf: Fix the arm64 MTE ELF segment name and value

Drop lookup_address_in_mm() now that KVM is providing it's own variant
of lookup_address_in_pgd() that is safe for use with user addresses, e.g.
guards against page tables being torn down.  A variant that provides a
non-init mm is inherently dangerous and flawed, as the only reason to use
an mm other than init_mm is to walk a userspace mapping, and
lookup_address_in_pgd() does not play nice with userspace mappings, e.g.
doesn't disable IRQs to block TLB shootdowns and doesn't use READ_ONCE()
to ensure an upper level entry isn't converted to a huge page between
checking the PAGE_SIZE bit and grabbing the address of the next level
down.

This reverts commit 13c72c060f1ba6f4eddd7b1c4f52a8aded43d6d9.

Signed-off-by: Sean Christopherson <seanjc@google.com>
Message-Id: <YmwIi3bXr/1yhYV/@google.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>