If dma mapping for dma_addr_out fails, the descriptor memory is freed but the previous dma mapping for dma_addr_in remains. This patch resolves the missing dma unmap and groups resource allocations at function start. Cc: <stable@vger.kernel.org> # 3.13+ Signed-off-by: Cristian Stoica <cristian.stoica@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
CAAM's memory is broken into following address blocks: Block Included Registers 0 General Registers 1-4 Job ring registers 6 RTIC registers 7 QI registers 8 DECO and CCB Size of the above stated blocks varies in various platforms. The block size can be 4K or 64K. The block size can be dynamically determined by reading CTPR register in CAAM. This patch initializes the block addresses dynamically based on the value read from this register. Signed-off-by: Ruchika Gupta <r66431@freescale.com> Signed-off-by: Nitesh Narayan Lal <b44382@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
buf_0 and buf_1 in caam_hash_state are not next to each other. Accessing buf_1 is incorrect from &buf_0 with an offset of only size_of(buf_0). The same issue is also with buflen_0 and buflen_1 Cc: <stable@vger.kernel.org> # 3.13+ Signed-off-by: Cristian Stoica <cristian.stoica@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Replace equivalent (and partially incorrect) scatter-gather functions with ones from crypto-API. The replacement is motivated by page-faults in sg_copy_part triggered by successive calls to crypto_hash_update. The following fault appears after calling crypto_ahash_update twice, first with 13 and then with 285 bytes: Unable to handle kernel paging request for data at address 0x00000008 Faulting instruction address: 0xf9bf9a8c Oops: Kernel access of bad area, sig: 11 [#1] SMP NR_CPUS=8 CoreNet Generic Modules linked in: tcrypt(+) caamhash caam_jr caam tls CPU: 6 PID: 1497 Comm: cryptomgr_test Not tainted 3.12.19-rt30-QorIQ-SDK-V1.6+g9fda9f2 #75 task: e9308530 ti: e700e000 task.ti: e700e000 NIP: f9bf9a8c LR: f9bfcf28 CTR: c0019ea0 REGS: e700fb80 TRAP: 0300 Not tainted (3.12.19-rt30-QorIQ-SDK-V1.6+g9fda9f2) MSR: 00029002 <CE,EE,ME> CR: 44f92024 XER: 20000000 DEAR: 00000008, ESR: 00000000 GPR00: f9bfcf28 e700fc30 e9308530 e70b1e55 00000000 ffffffdd e70b1e54 0bebf888 GPR08: 902c7ef5 c0e771e2 00000002 00000888 c0019ea0 00000000 00000000 c07a4154 GPR16: c08d0000 e91a8f9c 00000001 e98fb400 00000100 e9c83028 e70b1e08 e70b1d48 GPR24: e992ce10 e70b1dc8 f9bfe4f4 e70b1e55 ffffffdd e70b1ce0 00000000 00000000 NIP [f9bf9a8c] sg_copy+0x1c/0x100 [caamhash] LR [f9bfcf28] ahash_update_no_ctx+0x628/0x660 [caamhash] Call Trace: [e700fc30] [f9bf9c50] sg_copy_part+0xe0/0x160 [caamhash] (unreliable) [e700fc50] [f9bfcf28] ahash_update_no_ctx+0x628/0x660 [caamhash] [e700fcb0] [f954e19c] crypto_tls_genicv+0x13c/0x300 [tls] [e700fd10] [f954e65c] crypto_tls_encrypt+0x5c/0x260 [tls] [e700fd40] [c02250ec] __test_aead.constprop.9+0x2bc/0xb70 [e700fe40] [c02259f0] alg_test_aead+0x50/0xc0 [e700fe60] [c02241e4] alg_test+0x114/0x2e0 [e700fee0] [c022276c] cryptomgr_test+0x4c/0x60 [e700fef0] [c004f658] kthread+0x98/0xa0 [e700ff40] [c000fd04] ret_from_kernel_thread+0x5c/0x64 Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The sampling of the oscillator can be done in multiple modes for generating the entropy value. By default, this is set to von Neumann. This patch changes the sampling to raw data, since it has been discovered that the generated entropy has a better 'quality'. Signed-off-by: Alex Porosanu <alexandru.porosanu@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The entropy delay (the length in system clocks of each entropy sample) for the RNG4 block of CAAM is dependent on the frequency of the SoC. By elaborate methods, it has been determined that a good starting value for all platforms integrating the CAAM IP is 3200. Using a higher value has additional benefit of speeding up the process of instantiating the RNG, since the entropy delay will be increased and instantiation of the RNG state handles will be reattempted by the driver. If the starting value is low, for certain platforms, this can lead to a quite lengthy process. This patch changes the starting value of the length of the entropy sample to 3200 system clocks. In addition to this change, the attempted entropy delay values are now printed on the console upon initialization of the RNG block. While here, a safeguard for yielding the processor was added for ensuring that in very adverse cases, the CPU isn't hogged by the instantiation loop. Signed-off-by: Alex Porosanu <alexandru.porosanu@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
The rtfrqmax & rtfrqmin set the bounds of the expected frequency of the oscillator, when SEC runs at its maximum frequency. For certain platforms (f.i. T2080), the oscillator is very fast and thus if the SEC runs at a lower than normal frequency, the ring oscillator is incorrectly detected as being out of bounds. This patch effectively disables the maximum frequency check, by setting a high enough maximum allowable frequency for the oscillator. The reasoning behind this is that usually a broken oscillator will run too slow (i.e. not run at all) rather than run too fast. Signed-off-by: Alex Porosanu <alexandru.porosanu@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Pull crypto update from Herbert Xu: - CTR(AES) optimisation on x86_64 using "by8" AVX. - arm64 support to ccp - Intel QAT crypto driver - Qualcomm crypto engine driver - x86-64 assembly optimisation for 3DES - CTR(3DES) speed test - move FIPS panic from module.c so that it only triggers on crypto modules - SP800-90A Deterministic Random Bit Generator (drbg). - more test vectors for ghash. - tweak self tests to catch partial block bugs. - misc fixes. * git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6: (94 commits) crypto: drbg - fix failure of generating multiple of 2**16 bytes crypto: ccp - Do not sign extend input data to CCP crypto: testmgr - add missing spaces to drbg error strings crypto: atmel-tdes - Switch to managed version of kzalloc crypto: atmel-sha - Switch to managed version of kzalloc crypto: testmgr - use chunks smaller than algo block size in chunk tests crypto: qat - Fixed SKU1 dev issue crypto: qat - Use hweight for bit counting crypto: qat - Updated print outputs crypto: qat - change ae_num to ae_id crypto: qat - change slice->regions to slice->region crypto: qat - use min_t macro crypto: qat - remove unnecessary parentheses crypto: qat - remove unneeded header crypto: qat - checkpatch blank lines crypto: qat - remove unnecessary return codes crypto: Resolve shadow warnings crypto: ccp - Remove "select OF" from Kconfig crypto: caam - fix DECO RSR polling crypto: qce - Let 'DEV_QCE' depend on both HAS_DMA and HAS_IOMEM ...
RSR (Request Source Register) is not used when virtualization is disabled, thus don't poll for Valid bit. Besides this, if used, timeout has to be reinitialized. Signed-off-by: Horia Geanta <horia.geanta@freescale.com> Acked-by: Kim Phillips <kim.phillips@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
AES currently shares descriptor creation functions with DES and 3DES. DK bit is set in all cases, however it is valid only for the AES accelerator. Signed-off-by: Horia Geanta <horia.geanta@freescale.com> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>