Registers that can be fetched from the info ioctl.

Tested-by: Marek Olšák <marek.olsak@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Signed-off-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Reviewed-by: Christian König <christian.koenig@amd.com>
Signed-off-by: Slava Grigorev <slava.grigorev@amd.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Program HDMI_CONTROL to send general control packets
for hdmi deep color mode signalling at every video
frame if bpc > 8.

This is only supported on evergreen / DCE-4 and later.

v2: rebase

Signed-off-by: Mario Kleiner <mario.kleiner.de@gmail.com>
Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

pci config reset is a low level reset that resets
the entire chip from the bus interface.  It can
be more reliable if soft reset fails.

v2: put behind module parameter

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Bit a bit -fixes pull request in the merge window than usual dua to two
feauture-y things:
- Display CRCs are now enabled on all platforms, including the odd DP case
  on gm45/vlv. Since this is a testing-only feature it should ever hurt,
  but I figured it'll help with regression-testing -fixes. So I left it
  in and didn't postpone it to 3.14.
- Display power well refactoring from Imre. Would have caused major pain
  conflict with the bdw stage 1 patches if I'd postpone this to -next.
  It's only an relatively small interface rework, so shouldn't cause pain.
  It's also been in my tree since almost 3 weeks already.

That accounts for about two thirds of the pull, otherwise just bugfixes:
- vlv backlight fix from Jesse/Jani
- vlv vblank timestamp fix from Jesse
- improved edp detection through vbt from Ville (fixes a vlv issue)
- eDP vdd fix from Paulo
- fixes for dvo lvds on i830M
- a few smaller things all over

Note: This contains a backmerge of v3.12. Since the -internal branch
always applied on top of -nightly I need that unified base to merge bdw
patches. So you'll get a conflict with radeon connector props when pulling
this (and nouveau/master will also conflict a bit when Ben doesn't
rebase). The backmerge itself only had conflicts in drm/i915.

There's also a tiny conflict between Jani's backlight fix and your sysfs
lifetime fix in drm-next.

* tag 'drm-intel-fixes-2013-11-07' of git://people.freedesktop.org/~danvet/drm-intel: (940 commits)
  drm/i915/vlv: use per-pipe backlight controls v2
  drm/i915: make backlight functions take a connector
  drm/i915: move opregion asle request handling to a work queue
  drm/i915/vlv: use PIPE_START_VBLANK interrupts on VLV
  drm/i915: Make intel_dp_is_edp() less specific
  drm/i915: Give names to the VBT child device type bits
  drm/i915/vlv: enable HDA display audio for Valleyview2
  drm/i915/dvo: call ->mode_set callback only when the port is running
  drm/i915: avoid unclaimed registers when capturing the error state
  drm/i915: Enable DP port CRC for the "auto" source on g4x/vlv
  drm/i915: scramble reset support for DP port CRC on vlv
  drm/i915: scramble reset support for DP port CRC on g4x
  drm/i916: add "auto" pipe CRC source
  ...

Conflicts:
	MAINTAINERS
	drivers/gpu/drm/i915/intel_panel.c
	drivers/gpu/drm/nouveau/core/subdev/mc/base.c
	drivers/gpu/drm/radeon/atombios_encoders.c
	drivers/gpu/drm/radeon/radeon_connectors.c

Needed by the hda driver to properly set up synchronization
on the audio side.

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Reviewed-by: Christian König <christian.koenig@amd.com>

The FMT blocks control how data is sent from the backend
of the display pipe to to monitor.  Proper set up of the
FMT blocks are required for 30bpp formats.  Additionally,
dithering can be enabled on for better display with 18 and
24bpp displays.  The exception is LVDS/eDP which atom
takes care of in the SelectCRTC_Source table.  For now
just enable truncation until we test dithering more.

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

Wrong bit offset for SRC endian swapping.

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

We need to allocate line buffer to each display when
setting up the watermarks.  Failure to do so can lead
to a blank screen.  This fixes blank screen problems
on dce4.1/5 asics.

Based on an initial fix from:
Jay Cornwall <jay.cornwall@amd.com>

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org