commit 950eabbd6ddedc1b08350b9169a6a51b130ebaaf upstream.

With some gcc versions, we get a warning about the eicon driver,
and that currently shows up as the only remaining warning in one
of the build bots:

In file included from ../drivers/isdn/hardware/eicon/message.c:30:0:
eicon/message.c: In function 'mixer_notify_update':
eicon/platform.h:333:18: warning: array subscript is above array bounds [-Warray-bounds]

The code is easily changed to open-code the unusual PUT_WORD() line
causing this to avoid the warning.

Link: http://arm-soc.lixom.net/buildlogs/stable-rc/v4.4.45/
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

There are two issue here.
1)  cnt starts as maxloop + 1 so all these loops iterate one more time
    than intended.
2)  At the end of the loop we test for "if (maxloop && !cnt)" but for
    the first two loops, we end with cnt equal to -1.  Changing this to
    a pre-op means we end with cnt set to 0.

Fixes: cae86d4a4e56 ('mISDN: Add driver for Infineon ISDN chipset family')
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull trivial tree from Jiri Kosina:
 "Usual trivial tree updates.  Nothing outstanding -- mostly printk()
  and comment fixes and unused identifier removals"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/trivial:
  goldfish: goldfish_tty_probe() is not using 'i' any more
  powerpc: Fix comment in smu.h
  qla2xxx: Fix printks in ql_log message
  lib: correct link to the original source for div64_u64
  si2168, tda10071, m88ds3103: Fix firmware wording
  usb: storage: Fix printk in isd200_log_config()
  qla2xxx: Fix printk in qla25xx_setup_mode
  init/main: fix reset_device comment
  ipwireless: missing assignment
  goldfish: remove unreachable line of code
  coredump: Fix do_coredump() comment
  stacktrace.h: remove duplicate declaration task_struct
  smpboot.h: Remove unused function prototype
  treewide: Fix typo in printk messages
  treewide: Fix typo in printk messages
  mod_devicetable: fix comment for match_flags

This patch fix spelling typo in printk messages.

Signed-off-by: Masanari Iida <standby24x7@gmail.com>
Acked-by: Randy Dunlap <rdunlap@infradead.org>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>

Pull networking fixes from David Miller:

 1) If an IPVS tunnel is created with a mixed-family destination
    address, it cannot be removed.  Fix from Alexey Andriyanov.

 2) Fix module refcount underflow in netfilter's nft_compat, from Pablo
    Neira Ayuso.

 3) Generic statistics infrastructure can reference variables sitting on
    a released function stack, therefore use dynamic allocation always.
    Fix from Ignacy Gawędzki.

 4) skb_copy_bits() return value test is inverted in ip_check_defrag().

 5) Fix network namespace exit in openvswitch, we have to release all of
    the per-net vports.  From Pravin B Shelar.

 6) Fix signedness bug in CAIF's cfpkt_iterate(), from Dan Carpenter.

 7) Fix rhashtable grow/shrink behavior, only expand during inserts and
    shrink during deletes.  From Daniel Borkmann.

 8) Netdevice names with semicolons should never be allowed, because
    they serve as a separator.  From Matthew Thode.

 9) Use {,__}set_current_state() where appropriate, from Fabian
    Frederick.

10) Revert byte queue limits support in r8169 driver, it's causing
    regressions we can't figure out.

11) tcp_should_expand_sndbuf() erroneously uses tp->packets_out to
    measure packets in flight, properly use tcp_packets_in_flight()
    instead.  From Neal Cardwell.

12) Fix accidental removal of support for bluetooth in CSR based Intel
    wireless cards.  From Marcel Holtmann.

13) We accidently added a behavioral change between native and compat
    tasks, wrt testing the MSG_CMSG_COMPAT bit.  Just ignore it if the
    user happened to set it in a native binary as that was always the
    behavior we had.  From Catalin Marinas.

14) Check genlmsg_unicast() return valud in hwsim netlink tx frame
    handling, from Bob Copeland.

15) Fix stale ->radar_required setting in mac80211 that can prevent
    starting new scans, from Eliad Peller.

16) Fix memory leak in nl80211 monitor, from Johannes Berg.

17) Fix race in TX index handling in xen-netback, from David Vrabel.

18) Don't enable interrupts in amx-xgbe driver until all software et al.
    state is ready for the interrupt handler to run.  From Thomas
    Lendacky.

19) Add missing netlink_ns_capable() checks to rtnl_newlink(), from Eric
    W Biederman.

20) The amount of header space needed in macvtap was not calculated
    properly, fix it otherwise we splat past the beginning of the
    packet.  From Eric Dumazet.

21) Fix bcmgenet TCP TX perf regression, from Jaedon Shin.

22) Don't raw initialize or mod timers, use setup_timer() and
    mod_timer() instead.  From Vaishali Thakkar.

23) Fix software maintained statistics in bcmgenet and systemport
    drivers, from Florian Fainelli.

24) DMA descriptor updates in sh_eth need proper memory barriers, from
    Ben Hutchings.

25) Don't do UDP Fragmentation Offload on RAW sockets, from Michal
    Kubecek.

26) Openvswitch's non-masked set actions aren't constructed properly
    into netlink messages, fix from Joe Stringer.

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (116 commits)
  openvswitch: Fix serialization of non-masked set actions.
  gianfar: Reduce logging noise seen due to phy polling if link is down
  ibmveth: Add function to enable live MAC address changes
  net: bridge: add compile-time assert for cb struct size
  udp: only allow UFO for packets from SOCK_DGRAM sockets
  sh_eth: Really fix padding of short frames on TX
  Revert "sh_eth: Enable Rx descriptor word 0 shift for r8a7790"
  sh_eth: Fix RX recovery on R-Car in case of RX ring underrun
  sh_eth: Ensure proper ordering of descriptor active bit write/read
  net/mlx4_en: Disbale GRO for incoming loopback/selftest packets
  net/mlx4_core: Fix wrong mask and error flow for the update-qp command
  net: systemport: fix software maintained statistics
  net: bcmgenet: fix software maintained statistics
  rxrpc: don't multiply with HZ twice
  rxrpc: terminate retrans loop when sending of skb fails
  net/hsr: Fix NULL pointer dereference and refcnt bugs when deleting a HSR interface.
  net: pasemi: Use setup_timer and mod_timer
  net: stmmac: Use setup_timer and mod_timer
  net: 8390: axnet_cs: Use setup_timer and mod_timer
  net: 8390: pcnet_cs: Use setup_timer and mod_timer
  ...

Use helper function to access current->state.
Direct assignments are prone to races and therefore buggy.

Thanks to Peter Zijlstra for the exact definition of the problem.

Signed-off-by: Fabian Frederick <fabf@skynet.be>
Signed-off-by: David S. Miller <davem@davemloft.net>

Pull kconfig updates from Michal Marek:
 "Yann E Morin was supposed to take over kconfig maintainership, but
  this hasn't happened.  So I'm sending a few kconfig patches that I
  collected:

   - Fix for missing va_end in kconfig
   - merge_config.sh displays used if given too few arguments
   - s/boolean/bool/ in Kconfig files for consistency, with the plan to
     only support bool in the future"

* 'kconfig' of git://git.kernel.org/pub/scm/linux/kernel/git/mmarek/kbuild:
  kconfig: use va_end to match corresponding va_start
  merge_config.sh: Display usage if given too few arguments
  kconfig: use bool instead of boolean for type definition attributes

Conflicts:
	drivers/net/vxlan.c
	drivers/vhost/net.c
	include/linux/if_vlan.h
	net/core/dev.c

The net/core/dev.c conflict was the overlap of one commit marking an
existing function static whilst another was adding a new function.

In the include/linux/if_vlan.h case, the type used for a local
variable was changed in 'net', whereas the function got rewritten
to fix a stacked vlan bug in 'net-next'.

In drivers/vhost/net.c, Al Viro's iov_iter conversions in 'net-next'
overlapped with an endainness fix for VHOST 1.0 in 'net'.

In drivers/net/vxlan.c, vxlan_find_vni() added a 'flags' parameter
in 'net-next' whereas in 'net' there was a bug fix to pass in the
correct network namespace pointer in calls to this function.

Signed-off-by: David S. Miller <davem@davemloft.net>

The bug here is that we use "Reject" as the index into the cau_t[] array
in the else path.  Since the cau_t[] has 9 elements if Reject == 9 then
we are reading beyond the end of the array.

My understanding of the code is that it's saying that if Reject is 1 or
too high then that's invalid and we should hang up.

Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Conflicts:
	drivers/net/xen-netfront.c

Minor overlapping changes in xen-netfront.c, mostly to do
with some buffer management changes alongside the split
of stats into TX and RX.

Signed-off-by: David S. Miller <davem@davemloft.net>