commit 4fe16897c59882420d66f2d503106653d026ed6c upstream Signed-off-by: Karl Beldan <karl.beldan@gmail.com> Acked-by: Eric Miao <eric.miao@marvell.com> Signed-off-by: Pierre Ossman <drzeus@drzeus.cx> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
The pxa27x DMA controller defaults to 64-bit alignment. This caused the SCR reads to fail (and, depending on card type, error out) when card->raw_scr was not aligned on a 8-byte boundary. For performance reasons all scatter-gather addresses passed to pxamci_request should be aligned on 8-byte boundaries, but if this can't be guaranteed, byte aligned DMA transfers in the have to be enabled in the controller to get correct behaviour. Signed-off-by: Philipp Zabel <philipp.zabel@gmail.com> Signed-off-by: Pierre Ossman <drzeus@drzeus.cx> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Even the newer ENE controllers have bugs in their DMA engine that make it too dangerous to use. Disable it until someone has figured out under which conditions it corrupts data. This has caused problems at least once, and can be found as bug report 10925 in the kernel bugzilla. Signed-off-by: Pierre Ossman <drzeus@drzeus.cx> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
The CaFe chip has a hardware bug that ends up with us getting a timeout value that's too small, causing the following sorts of problems: [ 60.525138] mmcblk0: error -110 transferring data [ 60.531477] end_request: I/O error, dev mmcblk0, sector 1484353 [ 60.533371] Buffer I/O error on device mmcblk0p2, logical block 181632 [ 60.533371] lost page write due to I/O error on mmcblk0p2 Presumably this is an off-by-one error in the hardware. Incrementing the timeout count value that we stuff into the TIMEOUT_CONTROL register gets us a value that works. This bug was originally discovered by Pierre Ossman, I believe. [thanks to Robert Millan for proving that this was still a problem] Signed-off-by: Andres Salomon <dilinger@debian.org> Cc: Pierre Ossman <drzeus-list@drzeus.cx> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This has been sitting around unloved for way too long.. The Marvell CaFe chip's SD implementation chokes during card insertion if one attempts to set the voltage and power up in the same SDHCI_POWER_CONTROL register write. This adds a quirk that does that particular dance in two steps. It also adds an entry to pci_ids.h for the CaFe chip's SD device. Signed-off-by: Andres Salomon <dilinger@debian.org> Cc: Pierre Ossman <drzeus-list@drzeus.cx> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
With CONFIG_DEBUG_SHIRQ set we will get an interrupt as soon as we allocate one. Tasklets may be scheduled in the interrupt handler but they will be initialized after the handler returns, causing a BUG() in kernel/softirq.c when they run. Should fix this Fedora bug report: https://bugzilla.redhat.com/show_bug.cgi?id=449817 Signed-off-by: Chuck Ebbert <cebbert@redhat.com> Acked-by: Pierre Ossman <drzeus@drzeus.cx> Cc: <stable@kernel.org> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Fairly simple. "dev_use" was being allocated as a zero length array because of bad math on 64-bit systems, causing a crash in find_first_zero_bit(). One-liner follows: Signed-off-by: Ben Collins <ben.collins@canonical.com> Acked-by: Pierre Ossman <drzeus@drzeus.cx> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc: at91_mci: minor cleanup mmc: mmc host test driver mmc: Fix omap compile by replacing dev_name with dma_dev_name
MMC_POWER_ON is a noop, no need to set the power pin again. Signed-off-by: Marc Pignat <marc.pignat@hevs.ch> Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>