linux-toradex.git/drivers/mmc, branch v4.1

mmc: atmel-mci: fix bad variable type for clkdiv

2015-05-18T07:04:42+00:00

clkdiv is declared as an u32 but it can be set to a negative value
causing a huge divisor value. Change its type to int to avoid this case.

Signed-off-by: Ludovic Desroches 
Cc:  # 3.4 and later
Signed-off-by: Ulf Hansson

mmc: dw_mmc: dw_mci_get_cd check MMC_CAP_NONREMOVABLE

2015-05-08T06:55:47+00:00

When non-removable is used for emmc,  MMC_CAP_NONREMOVABLE should
also be checked, otherwise detection fail since present=0

Signed-off-by: Zhangfei Gao 
Signed-off-by: Jaehoon Chung 
Signed-off-by: Ulf Hansson

mmc: dw_mmc: init desc in dw_mci_idmac_init

2015-05-08T06:55:14+00:00

Set 0 to des1 in 32bit case.
Otherwise the random value of des1 will be used in
dw_mci_translate_sglist: IDMAC_SET_BUFFER1_SIZE(desc, length)

Signed-off-by: Fei Wang 
Signed-off-by: Zhangfei Gao 
Signed-off-by: Jaehoon Chung 
Signed-off-by: Ulf Hansson

mmc: card: Don't access RPMB partitions for normal read/write

2015-05-06T12:55:12+00:00

During kernel boot, it will try to read some logical sectors
of each block device node for the possible partition table.

But since RPMB partition is special and can not be accessed
by normal eMMC read / write CMDs, it will cause below error
messages during kernel boot:
...
 mmc0: Got data interrupt 0x00000002 even though no data operation was in progress.
 mmcblk0rpmb: error -110 transferring data, sector 0, nr 32, cmd response 0x900, card status 0xb00
 mmcblk0rpmb: retrying using single block read
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 mmcblk0rpmb: timed out sending r/w cmd command, card status 0x400900
 end_request: I/O error, dev mmcblk0rpmb, sector 0
 Buffer I/O error on device mmcblk0rpmb, logical block 0
 end_request: I/O error, dev mmcblk0rpmb, sector 8
 Buffer I/O error on device mmcblk0rpmb, logical block 1
 end_request: I/O error, dev mmcblk0rpmb, sector 16
 Buffer I/O error on device mmcblk0rpmb, logical block 2
 end_request: I/O error, dev mmcblk0rpmb, sector 24
 Buffer I/O error on device mmcblk0rpmb, logical block 3
...

This patch will discard the access request in eMMC queue if
it is RPMB partition access request. By this way, it avoids
trigger above error messages.

Fixes: 090d25fe224c ("mmc: core: Expose access to RPMB partition")
Signed-off-by: Yunpeng Gao 
Signed-off-by: Chuanxiao Dong 
Tested-by: Michael Shigorin 
Signed-off-by: Ulf Hansson

mmc: sh_mmcif: Fix timeout value for command request

2015-05-06T09:58:33+00:00

f9fd54f22e ("mmc: sh_mmcif: Use msecs_to_jiffies() for host->timeout")
changed the timeout value from 1000 jiffies to 1s. In the case where
HZ is 1000 the values are the same. However, for smaller HZ values the
timeout is now smaller, 1s instead of 10s in the case of HZ=100.

Since the timeout occurs in spite of a normal data transfer a timeout of
10s seems more appropriate. This restores the previous timeout in the
case where HZ=100 and results in an increase over the previous timeout
for larger values of HZ.

Fixes: f9fd54f22e ("mmc: sh_mmcif: Use msecs_to_jiffies() for host->timeout")
Signed-off-by: Takeshi Kihara 
[horms: rewrote changelog to refer to HZ]
Signed-off-by: Simon Horman 
Signed-off-by: Yoshihiro Kaneko 
Signed-off-by: Ulf Hansson

mmc: core: add missing pm event in mmc_pm_notify to fix hib restore

2015-05-04T08:33:33+00:00

The PM_RESTORE_PREPARE is not handled now in mmc_pm_notify(),
as result mmc_rescan() could be scheduled and executed at
late hibernation restore stages when MMC device is suspended
already - which, in turn, will lead to system crash on TI dra7-evm board:

WARNING: CPU: 0 PID: 3188 at drivers/bus/omap_l3_noc.c:148 l3_interrupt_handler+0x258/0x374()
44000000.ocp:L3 Custom Error: MASTER MPU TARGET L4_PER1_P3 (Idle): Data Access in User mode during Functional access

Hence, add missed PM_RESTORE_PREPARE PM event in mmc_pm_notify().

Fixes: 4c2ef25fe0b8 (mmc: fix all hangs related to mmc/sd card...)
Signed-off-by: Grygorii Strashko 
Signed-off-by: Ulf Hansson

Merge branch 'for-linus' of git://git.infradead.org/users/vkoul/slave-dma

2015-04-24T16:49:37+00:00

Pull slave-dmaengine updates from Vinod Koul:

 - new drivers for:
        - Ingenic JZ4780 controller
        - APM X-Gene controller
        - Freescale RaidEngine device
        - Renesas USB Controller

  - remove device_alloc_chan_resources dummy handlers

  - sh driver cleanups for peri peri and related emmc and asoc patches
    as well

  - fixes and enhancements spread over the drivers

* 'for-linus' of git://git.infradead.org/users/vkoul/slave-dma: (59 commits)
  dmaengine: dw: don't prompt for DW_DMAC_CORE
  dmaengine: shdmac: avoid unused variable warnings
  dmaengine: fix platform_no_drv_owner.cocci warnings
  dmaengine: pch_dma: fix memory leak on failure path in pch_dma_probe()
  dmaengine: at_xdmac: unlock spin lock before return
  dmaengine: xgene: devm_ioremap() returns NULL on error
  dmaengine: xgene: buffer overflow in xgene_dma_init_channels()
  dmaengine: usb-dmac: Fix dereferencing freed memory 'desc'
  dmaengine: sa11x0: report slave capabilities to upper layers
  dmaengine: vdma: Fix compilation warnings
  dmaengine: fsl_raid: statify fsl_re_chan_probe
  dmaengine: Driver support for FSL RaidEngine device.
  dmaengine: xgene_dma_init_ring_mngr() can be static
  Documentation: dma: Add documentation for the APM X-Gene SoC DMA device DTS binding
  arm64: dts: Add APM X-Gene SoC DMA device and DMA clock DTS nodes
  dmaengine: Add support for APM X-Gene SoC DMA engine driver
  dmaengine: usb-dmac: Add Renesas USB DMA Controller (USB-DMAC) driver
  dmaengine: renesas,usb-dmac: Add device tree bindings documentation
  dmaengine: edma: fixed wrongly initialized data parameter to the edma callback
  dmaengine: ste_dma40: fix implicit conversion
  ...

Merge tag 'mmc-4.1-rc1' of git://git.linaro.org/people/ulf.hansson/mmc

2015-04-22T16:29:08+00:00

Pull MMC fixes from Ulf Hansson:
 "Here is two mmc core fixes for v.4.1 rc1:

   - fix error code propagation in mmc_pwrseq_simple_alloc()

   - revert 'mmc: core: Convert mmc_driver to device_driver'"

* tag 'mmc-4.1-rc1' of git://git.linaro.org/people/ulf.hansson/mmc:
  Revert "mmc: core: Convert mmc_driver to device_driver"
  mmc: pwrseq: Fix error code propagation in mmc_pwrseq_simple_alloc()

Merge tag 'armsoc-cleanup' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2015-04-22T16:04:39+00:00

Pull ARM SoC cleanups from Olof Johansson:
 "We've got a fairly large cleanup branch this time.  The bulk of this
  is removal of non-DT platforms of several flavors:

   - Atmel at91 platforms go full-DT, with removal of remaining
     board-file based support

   - OMAP removes legacy board files for three more platforms

   - removal of non-DT mach-msm, newer Qualcomm platforms now live in
     mach-qcom

   - Freescale i.MX25 also removes non-DT platform support"

Most of the rest of the changes here are fallout from the above, i.e. for
example removal of drivers that now lack platforms, etc.

* tag 'armsoc-cleanup' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (58 commits)
  mmc: Remove msm_sdcc driver
  gpio: Remove gpio-msm-v1 driver
  ARM: Remove mach-msm and associated ARM architecture code
  ARM: shmobile: cpuidle: Remove the pointless default driver
  ARM: davinci: dm646x: Add interrupt resource for McASPs
  ARM: davinci: irqs: Correct McASP1 TX interrupt definition for DM646x
  ARM: davinci: dm646x: Clean up the McASP DMA resources
  ARM: davinci: devices-da8xx: Add support for McASP2 on da830
  ARM: davinci: devices-da8xx: Clean up and correct the McASP device creation
  ARM: davinci: devices-da8xx: Add interrupt resource to McASP structs
  ARM: davinci: devices-da8xx: Add resource name for the McASP DMA request
  ARM: OMAP2+: Remove legacy support for omap3 TouchBook
  ARM: OMAP3: Remove legacy support for devkit8000
  ARM: OMAP3: Remove legacy support for EMA-Tech Stalker board
  ARM: shmobile: Consolidate the pm code for R-Car Gen2
  ARM: shmobile: r8a7791: Correct SYSCIER value
  ARM: shmobile: r8a7790: Correct SYSCIER value
  ARM: at91: remove old setup
  ARM: at91: sama5d4: remove useless map_io
  ARM: at91: sama5 use SoC detection infrastructure
  ...

Revert "mmc: core: Convert mmc_driver to device_driver"

2015-04-17T09:48:01+00:00

This reverts commit 6685ac62b2f0 ("mmc: core: Convert mmc_driver to
device_driver")

The reverted commit went too far in simplifing the device driver parts
for mmc.

Let's restore the old mmc_driver to enable driver core to sooner
or later to remove the ->probe(), ->remove() and ->shutdown() callbacks
from the struct device_driver.

Note that, the old ->suspend|resume() callbacks in the struct
mmc_driver don't need to be restored, since the mmc block layer has
converted to the modern system PM ops.

Fixes: 6685ac62b2f0 ("mmc: core: Convert mmc_driver to device_driver")
Signed-off-by: Ulf Hansson 
Acked-by: Jaehoon Chung