linux-toradex.git/drivers/mtd/nand, branch v4.19-rc1

Merge tag 'char-misc-4.19-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc

2018-08-18T18:04:51+00:00

Pull char/misc driver updates from Greg KH:
 "Here is the bit set of char/misc drivers for 4.19-rc1

  There is a lot here, much more than normal, seems like everyone is
  writing new driver subsystems these days... Anyway, major things here
  are:

   - new FSI driver subsystem, yet-another-powerpc low-level hardware
     bus

   - gnss, finally an in-kernel GPS subsystem to try to tame all of the
     crazy out-of-tree drivers that have been floating around for years,
     combined with some really hacky userspace implementations. This is
     only for GNSS receivers, but you have to start somewhere, and this
     is great to see.

  Other than that, there are new slimbus drivers, new coresight drivers,
  new fpga drivers, and loads of DT bindings for all of these and
  existing drivers.

  All of these have been in linux-next for a while with no reported
  issues"

* tag 'char-misc-4.19-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (255 commits)
  android: binder: Rate-limit debug and userspace triggered err msgs
  fsi: sbefifo: Bump max command length
  fsi: scom: Fix NULL dereference
  misc: mic: SCIF Fix scif_get_new_port() error handling
  misc: cxl: changed asterisk position
  genwqe: card_base: Use true and false for boolean values
  misc: eeprom: assignment outside the if statement
  uio: potential double frees if __uio_register_device() fails
  eeprom: idt_89hpesx: clean up an error pointer vs NULL inconsistency
  misc: ti-st: Fix memory leak in the error path of probe()
  android: binder: Show extra_buffers_size in trace
  firmware: vpd: Fix section enabled flag on vpd_section_destroy
  platform: goldfish: Retire pdev_bus
  goldfish: Use dedicated macros instead of manual bit shifting
  goldfish: Add missing includes to goldfish.h
  mux: adgs1408: new driver for Analog Devices ADGS1408/1409 mux
  dt-bindings: mux: add adi,adgs1408
  Drivers: hv: vmbus: Cleanup synic memory free path
  Drivers: hv: vmbus: Remove use of slow_virt_to_phys()
  Drivers: hv: vmbus: Reset the channel callback in vmbus_onoffer_rescind()
  ...

Merge tag 'sound-4.19-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound

2018-08-14T21:10:30+00:00

Pull sound updates from Takashi Iwai:
 "It's been busy summer weeks and hence lots of changes, partly for a
  few new drivers and partly for a wide range of fixes.

  Here are highlights:

  ALSA Core:
   - Fix rawmidi buffer management, code cleanup / refactoring
   - Fix the SG-buffer page handling with incorrect fallback size
   - Fix the stall at virmidi trigger callback with a large buffer; also
     offloading and code-refactoring along with it
   - Various ALSA sequencer code cleanups

  ASoC:
   - Deploy the standard snd_pcm_stop_xrun() helper in several drivers
   - Support for providing name prefixes to generic component nodes
   - Quite a few fixes for DPCM as it gains a bit wider use and more
     robust testing
   - Generalization of the DIO2125 support to a simple amplifier driver
   - Accessory detection support for the audio graph card
   - DT support for PXA AC'97 devices
   - Quirks for a number of new x86 systems
   - Support for AM Logic Meson, Everest ES7154, Intel systems with
     RT5682, Qualcomm QDSP6 and WCD9335, Realtek RT5682 and TI TAS5707

  HD-audio:
   - Code refactoring in HD-audio ext codec codes to drop own classes;
     preliminary works for the upcoming legacy codec support
   - Generalized DRM audio component for the upcoming radeon / amdgpu
     support
   - Unification of mic mute-LED and GPIO support for various codecs
   - Further improvement of CA0132 codec support including Recon3D
   - Proper vga_switcheroo handling for AMD i-GPU
   - Update of model list in documentation
   - Fixups for another HP Spectre x360, Conexant codecs, power-save
     blacklist update

  USB-audio:
   - Fix the invalid sample rate setup with external clock
   - Support of UAC3 selector units and processing units
   - Basic UAC3 power-domain support
   - Support for Encore mDSD and Thesycon-based DSD devices
   - Preparation for future complete callback changes

  Firewire:
   - Add support for MOTU Traveler

  Misc:
   - The endianess notation fixes in various drivers
   - Add fall-through comment in lots of drivers
   - Various sparse warning fixes, e.g. about PCM format types"

* tag 'sound-4.19-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound: (529 commits)
  ASoC: adav80x: mark expected switch fall-through
  ASoC: da7219: Add delays to capture path to remove DC offset noise
  ALSA: usb-audio: Mark expected switch fall-through
  ALSA: mixart: Mark expected switch fall-through
  ALSA: opl3: Mark expected switch fall-through
  ALSA: hda/ca0132 - Add exit commands for Recon3D
  ALSA: hda/ca0132 - Change mixer controls for Recon3D
  ALSA: hda/ca0132 - Add Recon3D input and output select commands
  ALSA: hda/ca0132 - Add DSP setup defaults for Recon3D
  ALSA: hda/ca0132 - Add Recon3D startup functions and setup
  ALSA: hda/ca0132 - Add bool variable to enable/disable pci region2 mmio
  ALSA: hda/ca0132 - Add Recon3D pincfg
  ALSA: hda/ca0132 - Add quirk ID and enum for Recon3D
  ALSA: hda/ca0132 - Add alt_functions unsolicited response
  ALSA: hda/ca0132 - Clean up ca0132_init function.
  ALSA: hda/ca0132 - Create mmio gpio function to make code clearer
  ASoC: wm_adsp: Make DSP name configurable by codec driver
  ASoC: wm_adsp: Declare firmware controls from codec driver
  ASoC: max98373: Added software reset register to readable registers
  ASoC: wm_adsp: Correct DSP pointer for preloader control
  ...

mtd: rawnand: atmel: Select GENERIC_ALLOCATOR

2018-08-11T16:07:44+00:00

The driver uses genalloc functions. Select GENERIC_ALLOCATOR to prevent
build errors when selected through COMPILE_TEST.

Fixes: 88a40e7dca00 ("mtd: rawnand: atmel: Allow selection of this driver when COMPILE_TEST=y")
Reported-by: Randy Dunlap 
Signed-off-by: Boris Brezillon 
Acked-by: Miquel Raynal 
Acked-by: Randy Dunlap

Merge branch 'asoc-4.19' into asoc-next

2018-08-09T13:47:05+00:00

mtd: rawnand: allocate dynamically ONFI parameters during detection

2018-08-01T07:45:59+00:00

Now that it is possible to do dynamic allocations during the
identification phase, convert the onfi_params structure (which is only
needed with ONFI compliant chips) into a pointer that will be allocated
only if needed.

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon

mtd: rawnand: allocate model parameter dynamically

2018-07-31T07:46:14+00:00

Thanks to the migration of all drivers to use nand_scan() and the
related nand_controller_ops, we can now allocate data during the
detection phase. Let's do it first for the NAND model parameter which
is allocated in nand_detect().

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon

mtd: rawnand: do not export nand_scan_[ident|tail]() anymore

2018-07-31T07:46:14+00:00

Both nand_scan_ident() and nand_scan_tail() helpers used to be called
directly from controller drivers that needed to tweak some ECC-related
parameters before nand_scan_tail(). This separation prevented dynamic
allocations during the phase of NAND identification, which was
inconvenient.

All controller drivers have been moved to use nand_scan(), in
conjunction with the chip->ecc.[attach|detach]_chip() hooks that
actually do the required tweaking sequence between both ident/tail
calls, allowing programmers to use dynamic allocation as they need all
across the scanning sequence.

Declare nand_scan_[ident|tail]() statically now.

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon

mtd: rawnand: txx9ndfmc: convert driver to nand_scan()

2018-07-31T07:46:13+00:00

Two helpers have been added to the core to do all kind of controller
side configuration/initialization between the detection phase and the
final NAND scan. Implement these hooks so that we can convert the driver
to just use nand_scan() instead of the nand_scan_ident() +
nand_scan_tail() pair.

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon

mtd: rawnand: txx9ndfmc: clarify ECC parameters assignation

2018-07-31T07:46:13+00:00

A comment in the probe declares that values are assigned to ecc.size
and ecc.bytes, but these values will be overwritten. This is not
entirely right as they are overwritten only if
mtd->writesize >= 512. Let's clarify this by moving these assignations
to txx9ndfmc_nand_scan().

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon

mtd: rawnand: tegra: convert driver to nand_scan()

2018-07-31T07:46:12+00:00

Two helpers have been added to the core to do all kind of controller
side configuration/initialization between the detection phase and the
final NAND scan. Implement these hooks so that we can convert the driver
to just use nand_scan() instead of the nand_scan_ident() +
nand_scan_tail() pair.

Signed-off-by: Miquel Raynal 
Reviewed-by: Boris Brezillon