Pull mtd fixes from Brian Norris:
 "Two trivial MTD updates for 3.17-rc4:

   - a tiny comment tweak, to kill a bunch of DocBook warnings added
     during the merge window

   - a small fixup to the OTP routines' error handling"

* tag 'for-linus-20140905' of git://git.infradead.org/linux-mtd:
  mtd: nand: fix DocBook warnings on nand_sdr_timings doc
  mtd: cfi_cmdset_0002: check return code for get_chip()

commit 65b97cf6b8de introduced in v3.7 caused a regression
by using a reversed CS_MASK thus causing omap_calculate_ecc to
always fail. As the NAND base driver never checks for .calculate()'s
return value, the zeroed ECC values are used as is without showing
any error to the user. However, this won't work and the NAND device
won't be guarded by any error code.

Fix the issue by using the correct mask.

Code was tested on omap3beagle using the following procedure
- flash the primary bootloader (MLO) from the kernel to the first
NAND partition using nandwrite.
- boot the board from NAND. This utilizes OMAP ROM loader that
relies on 1-bit Hamming code ECC.

Fixes: 65b97cf6b8de (mtd: nand: omap2: handle nand on gpmc)

Cc: <stable@vger.kernel.org>	[3.7+]
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

For v3.12 and prior, 1-bit Hamming code ECC via software was the
default choice. Commit c66d039197e4 in v3.13 changed the behaviour
to use 1-bit Hamming code via Hardware using a different ECC layout
i.e. (ROM code layout) than what is used by software ECC.

This ECC layout change causes NAND filesystems created in v3.12
and prior to be unusable in v3.13 and later. So revert back to
using software ECC by default if an ECC scheme is not explicitely
specified.

This defect can be observed on the following boards during legacy boot

-omap3beagle
-omap3touchbook
-overo
-am3517crane
-devkit8000
-ldp
-3430sdp

Signed-off-by: Roger Quadros <rogerq@ti.com>
Tested-by: Grazvydas Ignotas <notasas@gmail.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

Coverity CID 1230633

Signed-off-by: Brian Norris <computersforpeace@gmail.com>
Tested-by: Christian Riesch <christian.riesch@omicron.at>

Pull UBI/UBIFS changes from Artem Bityutskiy:
 "No significant changes, mostly small fixes here and there.  The more
  important fixes are:

   - UBI deleted list items while iterating the list with
     'list_for_each_entry'
   - The UBI block driver did not work properly with very large UBI
     volumes"

* tag 'upstream-3.17-rc1' of git://git.infradead.org/linux-ubifs: (21 commits)
  UBIFS: Add log overlap assertions
  Revert "UBIFS: add a log overlap assertion"
  UBI: bugfix in ubi_wl_flush()
  UBI: block: Avoid disk size integer overflow
  UBI: block: Set disk_capacity out of the mutex
  UBI: block: Make ubiblock_resize return something
  UBIFS: add a log overlap assertion
  UBIFS: remove unnecessary check
  UBIFS: remove mst_mutex
  UBIFS: kernel-doc warning fix
  UBI: init_volumes: Ignore volumes with no LEBs
  UBIFS: replace seq_printf by seq_puts
  UBIFS: replace count*size kzalloc by kcalloc
  UBIFS: kernel-doc warning fix
  UBIFS: fix error path in create_default_filesystem()
  UBIFS: fix spelling of "scanned"
  UBIFS: fix some comments
  UBIFS: remove useless @ecc in struct ubifs_scan_leb
  UBIFS: remove useless statements
  UBIFS: Add missing break statements in dbg_chk_pnode()
  ...

Pull MTD updates from Brian Norris:
 "AMD-compatible CFI driver:
   - Support OTP programming for Micron M29EW family
   - Increase buffer write timeout, according to detected flash
     parameter info

  NAND
   - Add helpers for retrieving ONFI timing modes
   - GPMI: provide option to disable bad block marker swapping (required
     for Ka-On electronics platforms)

  SPI NOR
   - EON EN25QH128 support
   - Support new Flag Status Register (FSR) on a few Micron flash

  Common
   - New sysfs entries for bad block and ECC stats

  And a few miscellaneous refactorings, cleanups, and driver
  improvements"

* tag 'for-linus-20140808' of git://git.infradead.org/linux-mtd: (31 commits)
  mtd: gpmi: make blockmark swapping optional
  mtd: gpmi: remove line breaks from error messages and improve wording
  mtd: gpmi: remove useless (void *) type casts and spaces between type casts and variables
  mtd: atmel_nand: NFC: support multiple interrupt handling
  mtd: atmel_nand: implement the nfc_device_ready() by checking the R/B bit
  mtd: atmel_nand: add NFC status error check
  mtd: atmel_nand: make ecc parameters same as definition
  mtd: nand: add ONFI timing mode to nand_timings converter
  mtd: nand: define struct nand_timings
  mtd: cfi_cmdset_0002: fix do_write_buffer() timeout error
  mtd: denali: use 8 bytes for READID command
  mtd/ftl: fix the double free of the buffers allocated in build_maps()
  mtd: phram: Fix whitespace issues
  mtd: spi-nor: add support for EON EN25QH128
  mtd: cfi_cmdset_0002: Add support for locking OTP memory
  mtd: cfi_cmdset_0002: Add support for writing OTP memory
  mtd: cfi_cmdset_0002: Invalidate cache after entering/exiting OTP memory
  mtd: cfi_cmdset_0002: Add support for reading OTP
  mtd: spi-nor: add support for flag status register on Micron chips
  mtd: Account for BBT blocks when a partition is being allocated
  ...

Pull ARM SoC cleanups from Olof Johansson:
 "This merge window brings a good size of cleanups on various platforms.
  Among the bigger ones:

   - Removal of Samsung s5pc100 and s5p64xx platforms.  Both of these
     have lacked active support for quite a while, and after asking
     around nobody showed interest in keeping them around.  If needed,
     they could be resurrected in the future but it's more likely that
     we would prefer reintroduction of them as DT and
     multiplatform-enabled platforms instead.

   - OMAP4 controller code register define diet.  They defined a lot of
     registers that were never actually used, etc.

   - Move of some of the Tegra platform code (PMC, APBIO, fuse,
     powergate) to drivers/soc so it can be shared with 64-bit code.
     This also converts them over to traditional driver models where
     possible.

   - Removal of legacy gpio-samsung driver, since the last users have
     been removed (moved to pinctrl)

  Plus a bunch of smaller changes for various platforms that sort of
  dissapear in the diffstat for the above.  clps711x cleanups, shmobile
  header file refactoring/moves for multiplatform friendliness, some
  misc cleanups, etc"

* tag 'cleanup-for-3.17' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (117 commits)
  drivers: CCI: Correct use of ! and &
  video: clcd-versatile: Depend on ARM
  video: fix up versatile CLCD helper move
  MAINTAINERS: Add sdhci-st file to ARCH/STI architecture
  ARM: EXYNOS: Fix build breakge with PM_SLEEP=n
  MAINTAINERS: Remove Kirkwood
  ARM: tegra: Convert PMC to a driver
  soc/tegra: fuse: Set up in early initcall
  ARM: tegra: Always lock the CPU reset vector
  ARM: tegra: Setup CPU hotplug in a pure initcall
  soc/tegra: Implement runtime check for Tegra SoCs
  soc/tegra: fuse: fix dummy functions
  soc/tegra: fuse: move APB DMA into Tegra20 fuse driver
  soc/tegra: Add efuse and apbmisc bindings
  soc/tegra: Add efuse driver for Tegra
  ARM: tegra: move fuse exports to soc/tegra/fuse.h
  ARM: tegra: export apb dma readl/writel
  ARM: tegra: Use a function to get the chip ID
  ARM: tegra: Sort includes alphabetically
  ARM: tegra: Move includes to include/soc/tegra
  ...

Pull MIPS updates from Ralf Baechle:
 "This is the main pull request for 3.17.  It contains:

   - misc Cavium Octeon, BCM47xx, BCM63xx and Alchemy  updates
   - MIPS ptrace updates and cleanups
   - various fixes that will also go to -stable
   - a number of cleanups and small non-critical fixes.
   - NUMA support for the Loongson 3.
   - more support for MSA
   - support for MAAR
   - various FP enhancements and fixes"

* 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (139 commits)
  MIPS: jz4740: remove unnecessary null test before debugfs_remove
  MIPS: Octeon: remove unnecessary null test before debugfs_remove_recursive
  MIPS: ZBOOT: implement stack protector in compressed boot phase
  MIPS: mipsreg: remove duplicate MIPS_CONF4_FTLBSETS_SHIFT
  MIPS: Bonito64: remove a duplicate define
  MIPS: Malta: initialise MAARs
  MIPS: Initialise MAARs
  MIPS: detect presence of MAARs
  MIPS: define MAAR register accessors & bits
  MIPS: mark MSA experimental
  MIPS: Don't build MSA support unless it can be used
  MIPS: consistently clear MSA flags when starting & copying threads
  MIPS: 16 byte align MSA vector context
  MIPS: disable preemption whilst initialising MSA
  MIPS: ensure MSA gets disabled during boot
  MIPS: fix read_msa_* & write_msa_* functions on non-MSA toolchains
  MIPS: fix MSA context for tasks which don't use FP first
  MIPS: init upper 64b of vector registers when MSA is first used
  MIPS: save/disable MSA in lose_fpu
  MIPS: preserve scalar FP CSR when switching vector context
  ...

replace au_read/write/sync with __raw_read/write and wmb.

Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
Cc: Linux-MIPS <linux-mips@linux-mips.org>
Patchwork: https://patchwork.linux-mips.org/patch/7465/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

This patch changes the static memory controller registers to offsets
from base, prefixes them with AU1000_ to avoid silent failures due to
changed addresses and introduces helpers to access them.

No functional changes, comparing assembly of a few select functions shows
no differences.

Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
Cc: Linux-MIPS <linux-mips@linux-mips.org>
Patchwork: https://patchwork.linux-mips.org/patch/7463/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>