linux-toradex.git/drivers/net/dm9000.c, branch v2.6.25.10

dm9000 trivial annotation

2008-03-30T21:20:24+00:00

Signed-off-by: Al Viro 
Signed-off-by: Linus Torvalds

dm9000: Support promisc and all-multi modes

2008-03-26T03:41:28+00:00

Signed-off-by: Peter Korsgaard 
Signed-off-by: Jeff Garzik

DM9000: Show the MAC address source after printing MAC

2008-02-11T16:06:37+00:00

Show whether the MAC address was read from the EEPROM or
the onboard PAR registers.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Update retry count whilst identifying chip

2008-02-11T16:06:36+00:00

Reading the ID register does not always return the correct ID
from the device, so we retry several times to see if we get
a correct value.

These failures seem to be excaserbated by the speed of the
access to the chip (possibly time between issuing the address
and then the data cycle).

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Add support for MII ioctl() calls

2008-02-11T16:06:36+00:00

Add entry to handle the MII ioctl() calls via the
generic_mii_ioctl call.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Add platform flag for no attached EEPROM

2008-02-11T16:06:35+00:00

Allow the platform data to specify to the DM9000 driver
that there is no posibility of an attached EEPROM on the
device, so default all reads to 0xff and ignore any
write operations.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Remove redudant use of "& 0xff"

2008-02-11T16:06:34+00:00

The writing of the data should implicitly truncate
the data to 8bits, so do not bother with the ands
in the code.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Remove cal_CRC() and use ether_crc_le instead

2008-02-11T16:06:34+00:00

Remove the cal_CRC as this is basically wrappering the
ether_crc_le function, and is only being used by the
multicast hash table functions.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Fix delays used by EEPROM read and write

2008-02-11T16:06:33+00:00

The code was using a delay of 8ms, when it should have been
using the EEPROM status flag from the device to indicate the
EEPROM transaction had finished.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik

DM9000: Use netif_msg to enable debugging options

2008-02-11T16:06:32+00:00

Use the netif_msg_*() macros to enable the debugging based
on the board's msg_enable field. The output still goes via
the dev_dbg() macros, so will be tagged and output as
appropriate.

Signed-off-by: Ben Dooks 
Signed-off-by: Jeff Garzik