linux-toradex.git/drivers/net/ethernet/broadcom, branch v5.9-rc5

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2020-09-04T01:50:48+00:00

Pull networking fixes from David Miller:

 1) Use netif_rx_ni() when necessary in batman-adv stack, from Jussi
    Kivilinna.

 2) Fix loss of RTT samples in rxrpc, from David Howells.

 3) Memory leak in hns_nic_dev_probe(), from Dignhao Liu.

 4) ravb module cannot be unloaded, fix from Yuusuke Ashizuka.

 5) We disable BH for too lokng in sctp_get_port_local(), add a
    cond_resched() here as well, from Xin Long.

 6) Fix memory leak in st95hf_in_send_cmd, from Dinghao Liu.

 7) Out of bound access in bpf_raw_tp_link_fill_link_info(), from
    Yonghong Song.

 8) Missing of_node_put() in mt7530 DSA driver, from Sumera
    Priyadarsini.

 9) Fix crash in bnxt_fw_reset_task(), from Michael Chan.

10) Fix geneve tunnel checksumming bug in hns3, from Yi Li.

11) Memory leak in rxkad_verify_response, from Dinghao Liu.

12) In tipc, don't use smp_processor_id() in preemptible context. From
    Tuong Lien.

13) Fix signedness issue in mlx4 memory allocation, from Shung-Hsi Yu.

14) Missing clk_disable_prepare() in gemini driver, from Dan Carpenter.

15) Fix ABI mismatch between driver and firmware in nfp, from Louis
    Peens.

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (110 commits)
  net/smc: fix sock refcounting in case of termination
  net/smc: reset sndbuf_desc if freed
  net/smc: set rx_off for SMCR explicitly
  net/smc: fix toleration of fake add_link messages
  tg3: Fix soft lockup when tg3_reset_task() fails.
  doc: net: dsa: Fix typo in config code sample
  net: dp83867: Fix WoL SecureOn password
  nfp: flower: fix ABI mismatch between driver and firmware
  tipc: fix shutdown() of connectionless socket
  ipv6: Fix sysctl max for fib_multipath_hash_policy
  drivers/net/wan/hdlc: Change the default of hard_header_len to 0
  net: gemini: Fix another missing clk_disable_unprepare() in probe
  net: bcmgenet: fix mask check in bcmgenet_validate_flow()
  amd-xgbe: Add support for new port mode
  net: usb: dm9601: Add USB ID of Keenetic Plus DSL
  vhost: fix typo in error message
  net: ethernet: mlx4: Fix memory allocation in mlx4_buddy_init()
  pktgen: fix error message with wrong function name
  net: ethernet: ti: am65-cpsw: fix rmii 100Mbit link mode
  cxgb4: fix thermal zone device registration
  ...

tg3: Fix soft lockup when tg3_reset_task() fails.

2020-09-03T19:16:54+00:00

If tg3_reset_task() fails, the device state is left in an inconsistent
state with IFF_RUNNING still set but NAPI state not enabled.  A
subsequent operation, such as ifdown or AER error can cause it to
soft lock up when it tries to disable NAPI state.

Fix it by bringing down the device to !IFF_RUNNING state when
tg3_reset_task() fails.  tg3_reset_task() running from workqueue
will now call tg3_close() when the reset fails.  We need to
modify tg3_reset_task_cancel() slightly to avoid tg3_close()
calling cancel_work_sync() to cancel tg3_reset_task().  Otherwise
cancel_work_sync() will wait forever for tg3_reset_task() to
finish.

Reported-by: David Christensen 
Reported-by: Baptiste Covolato 
Fixes: db2199737990 ("tg3: Schedule at most one tg3_reset_task run")
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

net: bcmgenet: fix mask check in bcmgenet_validate_flow()

2020-09-02T19:54:12+00:00

VALIDATE_MASK(eth_mask->h_source) is checked twice in a row in
bcmgenet_validate_flow(). Add VALIDATE_MASK(eth_mask->h_dest)
instead.

Fixes: 3e370952287c ("net: bcmgenet: add support for ethtool rxnfc flows")
Signed-off-by: Denis Efremov 
Acked-by: Doug Berger 
Acked-by: Florian Fainelli 
Signed-off-by: David S. Miller

bnxt: don't enable NAPI until rings are ready

2020-08-26T23:16:39+00:00

Netpoll can try to poll napi as soon as napi_enable() is called.
It crashes trying to access a doorbell which is still NULL:

 BUG: kernel NULL pointer dereference, address: 0000000000000000
 CPU: 59 PID: 6039 Comm: ethtool Kdump: loaded Tainted: G S                5.9.0-rc1-00469-g5fd99b5d9950-dirty #26
 RIP: 0010:bnxt_poll+0x121/0x1c0
 Code: c4 20 44 89 e0 5b 5d 41 5c 41 5d 41 5e 41 5f c3 41 8b 86 a0 01 00 00 41 23 85 18 01 00 00 49 8b 96 a8 01 00 00 0d 00 00 00 24 <89> 02
41 f6 45 77 02 74 cb 49 8b ae d8 01 00 00 31 c0 c7 44 24 1a
  netpoll_poll_dev+0xbd/0x1a0
  __netpoll_send_skb+0x1b2/0x210
  netpoll_send_udp+0x2c9/0x406
  write_ext_msg+0x1d7/0x1f0
  console_unlock+0x23c/0x520
  vprintk_emit+0xe0/0x1d0
  printk+0x58/0x6f
  x86_vector_activate.cold+0xf/0x46
  __irq_domain_activate_irq+0x50/0x80
  __irq_domain_activate_irq+0x32/0x80
  __irq_domain_activate_irq+0x32/0x80
  irq_domain_activate_irq+0x25/0x40
  __setup_irq+0x2d2/0x700
  request_threaded_irq+0xfb/0x160
  __bnxt_open_nic+0x3b1/0x750
  bnxt_open_nic+0x19/0x30
  ethtool_set_channels+0x1ac/0x220
  dev_ethtool+0x11ba/0x2240
  dev_ioctl+0x1cf/0x390
  sock_do_ioctl+0x95/0x130

Reported-by: Rob Sherwood 
Fixes: c0c050c58d84 ("bnxt_en: New Broadcom ethernet driver.")
Signed-off-by: Jakub Kicinski 
Reviewed-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: Setup default RSS map in all scenarios.

2020-08-26T14:19:03+00:00

The recent changes to support user-defined RSS map assume that RX
rings are always reserved and the default RSS map is set after the
RX rings are successfully reserved.  If the firmware spec is older
than 1.6.1, no ring reservations are required and the default RSS
map is not setup at all.  In another scenario where the fw Resource
Manager is older, RX rings are not reserved and we also end up with
no valid RSS map.

Fix both issues in bnxt_need_reserve_rings().  In both scenarios
described above, we don't need to reserve RX rings so we need to
call this new function bnxt_check_rss_map_no_rmgr() to setup the
default RSS map when needed.

Without valid RSS map, the NIC won't receive packets properly.

Fixes: 1667cbf6a4eb ("bnxt_en: Add logical RSS indirection table structure.")
Reviewed-by: Vasundhara Volam 
Reviewed-by: Edwin Peer 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: init RSS table for Minimal-Static VF reservation

2020-08-26T14:19:03+00:00

There are no VF rings available during probe when the device is configured
using the Minimal-Static reservation strategy. In this case, the RSS
indirection table can only be initialized later, during bnxt_open_nic().
However, this was not happening because the rings will already have been
reserved via bnxt_init_dflt_ring_mode(), causing bnxt_need_reserve_rings()
to return false in bnxt_reserve_rings() and bypass the RSS table init.

Solve this by pushing the call to bnxt_set_dflt_rss_indir_tbl() into
__bnxt_reserve_rings(), which is common to both paths and is called
whenever ring configuration is changed. After doing this, the RSS table
init that must be called from bnxt_init_one() happens implicitly via
bnxt_set_default_rings(), necessitating doing the allocation earlier in
order to avoid a null pointer dereference.

Fixes: bd3191b5d87d ("bnxt_en: Implement ethtool -X to set indirection table.")
Signed-off-by: Edwin Peer 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: fix HWRM error when querying VF temperature

2020-08-26T14:19:03+00:00

Firmware returns RESOURCE_ACCESS_DENIED for HWRM_TEMP_MONITORY_QUERY for
VFs. This produces unpleasing error messages in the log when temp1_input
is queried via the hwmon sysfs interface from a VF.

The error is harmless and expected, so silence it and return unknown as
the value. Since the device temperature is not particularly sensitive
information, provide flexibility to change this policy in future by
silencing the error rather than avoiding the HWRM call entirely for VFs.

Fixes: cde49a42a9bb ("bnxt_en: Add hwmon sysfs support to read temperature")
Cc: Marc Smith 
Reported-by: Marc Smith 
Signed-off-by: Edwin Peer 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: Fix possible crash in bnxt_fw_reset_task().

2020-08-26T14:19:03+00:00

bnxt_fw_reset_task() is run from a delayed workqueue.  The current
code is not cancelling the workqueue in the driver's .remove()
method and it can potentially crash if the device is removed with
the workqueue still pending.

The fix is to clear the BNXT_STATE_IN_FW_RESET flag and then cancel
the delayed workqueue in bnxt_remove_one().  bnxt_queue_fw_reset_work()
also needs to check that this flag is set before scheduling.  This
will guarantee that no rescheduling will be done after it is cancelled.

Fixes: 230d1f0de754 ("bnxt_en: Handle firmware reset.")
Reviewed-by: Vasundhara Volam 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: Fix PCI AER error recovery flow

2020-08-26T14:19:03+00:00

When a PCI error is detected the PCI state could be corrupt, save
the PCI state after initialization and restore it after the slot
reset.

Fixes: 6316ea6db93d ("bnxt_en: Enable AER support.")
Signed-off-by: Vasundhara Volam 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller

bnxt_en: Fix ethtool -S statitics with XDP or TCs enabled.

2020-08-26T14:19:03+00:00

We are returning the wrong count for ETH_SS_STATS in get_sset_count()
when XDP or TCs are enabled.  In a recent commit, we got rid of
irrelevant counters when the ring is RX only or TX only, but we
did not make the proper adjustments for the count.  As a result,
when we have XDP or TCs enabled, we are returning an excess count
because some of the rings are TX only.  This causes ethtool -S to
display extra counters with no counter names.

Fix bnxt_get_num_ring_stats() by not assuming that all rings will
always have RX and TX counters in combined mode.

Fixes: 125592fbf467 ("bnxt_en: show only relevant ethtool stats for a TX or RX ring")
Reviewed-by: Vasundhara Volam 
Signed-off-by: Michael Chan 
Signed-off-by: David S. Miller