linux-toradex.git/drivers/net, branch v2.6.16.44

modify 3c589_cs to be SMP safe

2007-03-08T07:13:04+00:00

1. EL3WINDOW is always 1 when lock is not held.

2. The second argument of el3_interrupt is 'void *dev_id',
not 'struct el3_private *lp'.

Adrian Bunk:
backported to 2.6.16

Signed-off-by: Komuro 
Signed-off-by: Adrian Bunk

sis190: failure to set the MAC address from EEPROM

2007-02-26T22:45:11+00:00

Fix from http://bugzilla.kernel.org/show_bug.cgi?id=7747

Signed-off-by: Francois Romieu 
Signed-off-by: Adrian Bunk

sky2: email and version change.

2007-02-26T00:54:54+00:00

Put in new email address.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: add more pci ids

2007-02-26T00:53:52+00:00

Update the pci device id table to match 2.6.20 (except for new 88e807x
that is still experimental).

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: more stats

2007-02-26T00:53:13+00:00

This is a simple enhancement to dump more device statistics with ethtool.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: fix for use on big endian

2007-02-26T00:52:23+00:00

Ben added this for 2.6.18, it allows sky2 to run on big endian.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: allow multicast pause frames

2007-02-26T00:51:40+00:00

The 802 standard allows pause frames to be either unicast or multicast.
Switches seem to send unicast frames, but on a direct link, other boards send
multicast pause.  Unless the filter bit is set, these pause frames get
dropped.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: fix ram buffer allocation settings

2007-02-26T00:51:03+00:00

Different chipsets have different amount of ram buffer (some have none),
so need to make sure that driver does proper setup for all cases from 0 on
to 48K, in units of 1K.

This is a backport of the code from 2.6.19 or later

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: dual-port pci-x checksum fix

2007-02-22T20:07:51+00:00

Add a workaround for dual port PCI-X card that returns status out of
order sometimes because of split transactions.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk

sky2: fix for NAPI with dual port boards

2007-02-22T20:07:11+00:00

This driver uses port 0 to handle receives on both ports. So
the netif_poll_disable call in dev_close would end up stopping the
second port on dual port cards.

Signed-off-by: Stephen Hemminger 
Signed-off-by: Adrian Bunk