- Remove unused struct 'acpi_handle_node' (Dr. David Alan Gilbert)

- Use array notation for portdrv .id_table consistently (Masahiro Yamada)

- Switch to new Intel CPU model defines (Tony Luck)

- Add missing MODULE_DESCRIPTION() macros (Jeff Johnson)

* pci/misc:
  PCI: controller: Add missing MODULE_DESCRIPTION() macros
  PCI: Add missing MODULE_DESCRIPTION() macros
  PCI/PM: Switch to new Intel CPU model defines
  PCI: Use array for .id_table consistently
  ACPI: PCI: Remove unused struct 'acpi_handle_node'

- Create "domain" symlink for vmd before adding devices below the VMD
  bridge so it's available when mdadm assembles RAID devices from them
  (Jiwei Sun)

* pci/controller/vmd:
  PCI: vmd: Create domain symlink before pci_bus_add_devices()

- Ensure Tegra194 and Tegra234 inbound ATU entries are 64KB-aligned to
  match the hardware restriction (Jon Hunter)

- Remove unused struct 'tegra_pcie_soc' (Dr. David Alan Gilbert)

* pci/controller/tegra194:
  PCI: tegra: Remove unused struct 'tegra_pcie_soc'
  PCI: tegra194: Set EP alignment restriction for inbound ATU

- Use dev_err_probe() in dw-rockchip probe error path so the failures
  aren't silent (Uwe Kleine-König)

- Sleep PCIE_T_PVPERL_MS (100ms) before deasserting PERST# (Damien Le Moal)

- Sleep PCIE_T_RRS_READY_MS (100ms) after conventional reset, before a
  config access (Damien Le Moal)

- Request the PERST# GPIO with GPIOD_OUT_LOW so it matches the POR value,
  which avoids a spurious PERST# assertion and fixes a Qcom modem firmware
  crash and issues with WLAN controllers, e.g., RTL8822CE (Manivannan
  Sadhasivam for rockchip, Niklas Cassel for dw-rockchip)

- Refactor dw-rockchip and add support for Endpoint mode for rk3568 and
  rk3588 (Niklas Cassel)

* pci/controller/rockchip:
  PCI: dw-rockchip: Use pci_epc_init_notify() directly
  PCI: dw-rockchip: Add endpoint mode support
  PCI: dw-rockchip: Refactor the driver to prepare for EP mode
  PCI: dw-rockchip: Add rockchip_pcie_get_ltssm() helper
  PCI: dw-rockchip: Fix weird indentation
  PCI: dw-rockchip: Fix initial PERST# GPIO value
  PCI: dw-rockchip: Add error messages in .probe() error paths
  PCI: rockchip: Use GPIOD_OUT_LOW flag while requesting ep_gpio
  PCI: rockchip-host: Wait 100ms after reset before starting configuration
  PCI: rockchip-host: Fix rockchip_pcie_host_init_port() PERST# handling

- Add Synopsys DWC macros for lane skew configuration (Yoshihiro Shimoda)

- Add struct rcar_gen4_pcie_drvdata to provide for future SoCs with
  different initialization requirements (Yoshihiro Shimoda)

- Add .ltssm_control() method for SoC dependencies (Yoshihiro Shimoda)

- Add r8a779g0 (R-Car V4H) support (Yoshihiro Shimoda)

* pci/controller/rcar-gen4:
  PCI: rcar-gen4: Add support for R-Car V4H
  PCI: rcar-gen4: Add .ltssm_control() for other SoC support
  PCI: rcar-gen4: Add struct rcar_gen4_pcie_drvdata
  PCI: dwc: Add PCIE_PORT_{FORCE,LANE_SKEW} macros

- Demote WARN() to dev_warn_ratelimited() in rcar_pcie_wakeup() to avoid
  excessive warnings when the driver is confused about link state when
  resuming (Marek Vasut)

* pci/controller/rcar:
  PCI: rcar: Demote WARN() to dev_warn_ratelimited() in rcar_pcie_wakeup()

- Use devm_clk_bulk_get_all() to get all the clocks from DT to avoid
  writing out all the clock names (Manivannan Sadhasivam)

- Add DT binding and driver support for the SA8775P SoC (Mrinmay Sarkar)

- Refactor dw_pcie_edma_find_chip() to enable adding support for Hyper DMA
  (HDMA) (Manivannan Sadhasivam)

- Enable drivers to supply the eDMA channel count since some can't auto
  detect this (Manivannan Sadhasivam)

- Add HDMA support for the SA8775P SoC (Mrinmay Sarkar)

- Override the SA8775P NO_SNOOP default to avoid possible memory corruption
  (Mrinmay Sarkar)

- Make sure resources are disabled during PERST# assertion, even if the
  link is already disabled (Manivannan Sadhasivam)

- Vote for the CPU-PCIe ICC (interconnect) path to ensure it stays active
  even if other drivers don't vote for it (Krishna chaitanya chundru)

- Add Operating Performance Points (OPP) to scale performance state based
  on aggregate link bandwidth to improve SoC power efficiency (Krishna
  chaitanya chundru)

- Return failure instead of success if dev_pm_opp_find_freq_floor() fails
  (Dan Carpenter)

- Avoid an error pointer dereference if dev_pm_opp_find_freq_exact() fails
  (Dan Carpenter)

- Prevent use of uninitialized data in qcom_pcie_suspend_noirq() (Dan
  Carpenter)

* pci/controller/qcom:
  PCI: qcom: Prevent use of uninitialized data in qcom_pcie_suspend_noirq()
  PCI: qcom: Prevent potential error pointer dereference
  PCI: qcom: Fix missing error code in qcom_pcie_probe()
  PCI: qcom: Add OPP support to scale performance
  PCI: Bring the PCIe speed to MBps logic to new pcie_dev_speed_mbps()
  PCI: qcom: Add ICC bandwidth vote for CPU to PCIe path
  PCI: qcom-ep: Disable resources unconditionally during PERST# assert
  PCI: qcom-ep: Override NO_SNOOP attribute for SA8775P EP
  PCI: qcom: Override NO_SNOOP attribute for SA8775P RC
  PCI: epf-mhi: Enable HDMA for SA8775P SoC
  PCI: qcom-ep: Add HDMA support for SA8775P SoC
  PCI: dwc: Pass the eDMA mapping format flag directly from glue drivers
  PCI: dwc: Skip finding eDMA channels count for HDMA platforms
  PCI: dwc: Refactor dw_pcie_edma_find_chip() API
  PCI: qcom-ep: Add support for SA8775P SOC
  dt-bindings: PCI: qcom-ep: Add support for SA8775P SoC
  PCI: qcom: Use devm_clk_bulk_get_all() API

- Move PLDA XpressRICH generic DT binding properties to
  plda,xpressrich3-axi-common.yaml where they can be shared across
  PLDA-based drivers (Minda Chen)

- Create a drivers/pci/controller/plda/ directory for PLDA-based drivers
  and move pcie-microchip-host.c there (Minda Chen)

- Move PLDA generic macros to pcie-plda.h where they can be shared across
  drivers (Minda Chen)

- Extract PLDA generic structures from pcie-microchip-host.c, rename them
  to be generic, and move them to pcie-plda-host.c where they can be shared
  across drivers (Minda Chen)

- Add a .request_event_irq() callback for requesting device-specific
  interrupts in addition to PLDA-generic interrupts (Minda Chen)

- Add DT binding and driver for the StarFive JH7110 SoC, based on PLDA IP
  (Minda Chen)

* pci/controller/microchip:
  PCI: starfive: Add JH7110 PCIe controller
  dt-bindings: PCI: Add StarFive JH7110 PCIe controller
  PCI: Add PCIE_RESET_CONFIG_DEVICE_WAIT_MS waiting time value
  PCI: plda: Pass pci_host_bridge to plda_pcie_setup_iomems()
  PCI: plda: Add host init/deinit and map bus functions
  PCI: plda: Add event bitmap field to struct plda_pcie_rp
  PCI: microchip: Move IRQ functions to pcie-plda-host.c
  PCI: microchip: Add event irqchip field to host port and add PLDA irqchip
  PCI: microchip: Add get_events() callback and PLDA get_event()
  PCI: microchip: Add INTx and MSI event num to struct plda_event
  PCI: microchip: Add request_event_irq() callback function
  PCI: microchip: Add num_events field to struct plda_pcie_rp
  PCI: microchip: Rename interrupt related functions
  PCI: microchip: Move PLDA functions to pcie-plda-host.c
  PCI: microchip: Rename PLDA functions to be generic
  PCI: microchip: Move PLDA structures to plda-pcie.h
  PCI: microchip: Rename PLDA structures to be generic
  PCI: microchip: Add bridge_addr field to struct mc_pcie
  PCI: microchip: Move PLDA IP register macros to pcie-plda.h
  PCI: microchip: Move pcie-microchip-host.c to PLDA directory
  dt-bindings: PCI: Add PLDA XpressRICH PCIe host common properties

# Conflicts:
#	drivers/pci/pci.h

* pci/controller/loongson:
  PCI: loongson: Enable MSI in LS7A Root Complex

- Make the ls-gen4 struct mobiveil_rp_ops constant (Christophe JAILLET)

* pci/controller/layerscape:
  PCI: ls-gen4: Make struct mobiveil_rp_ops constant