dev_set_drvdata() needs to be called before device_register()
exposes device to userspace. Otherwise kernel crashes after it
gets null pointer from dev_get_drvdata() when userspace tries
to access sysfs entries.

[Removed backtrace for length -- broonie]

Signed-off-by: Yu Zhao <yuzhao@google.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

Some regulators don't have all states defined and in such cases regulator
core should not assume anything. However in current implementation
of of_get_regulation_constraints() DO_NOTHING_IN_SUSPEND enable value was
set only for regulators which had suspend node defined, otherwise the
default 0 value was used, what means DISABLE_IN_SUSPEND. This lead to
broken system suspend/resume on boards, which had simple regulator
constraints definition (without suspend state nodes).

To avoid further mismatches between the default and uninitialized values
of the suspend enabled/disabled states, change the values of the them,
so default '0' means DO_NOTHING_IN_SUSPEND.

Fixes: 72069f9957a1: regulator: leave one item to record whether regulator is enabled
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

There is a HW quirk in BD71837. The shutdown sequence timings for
bucks/LDOs which are enabled via register interface are changed.
At PMIC poweroff the voltage for BUCK6/7 is cut immediately at the
beginning of shut-down sequence. This causes LDO5/6 voltage
monitoring to detect under voltage and force PMIC to emergency
state instead of poweroff. Disable voltage monitoring for LDO5 and
LDO6 at probe to avoid this.

Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Cc: stable@vger.kernel.org

Pull MFD updates from Lee Jones:
 "New Drivers:
   - Add Cirrus Logic Madera Codec (CS47L35, CS47L85 and CS47L90/91) driver
   - Add ChromeOS EC CEC driver
   - Add ROHM BD71837 PMIC driver

  New Device Support:
   - Add support for Dialog Semi DA9063L PMIC variant to DA9063
   - Add support for Intel Ice Lake to Intel-PLSS-PCI
   - Add support for X-Powers AXP806 to AXP20x

  New Functionality:
   - Add support for USB Charging to the ChromeOS Embedded Controller
   - Add support for HDMI CEC to the ChromeOS Embedded Controller
   - Add support for HDMI CEC to Intel HDMI
   - Add support for accessory detection to Madera devices
   - Allow individual pins to be configured via DT' wlf,csnaddr-pd
   - Provide legacy platform specific EEPROM/Watchdog commands; rave-sp

  Fix-upsL
   - Trivial renaming/spelling fixes; cros_ec, da9063-*
   - Convert to Managed Resources (devm_*); da9063-*, ti_am335x_tscadc
   - Transition to helper macros/functions; da9063-*
   - Constify; kempld-core
   - Improve error path/messages; wm8994-core
   - Disable IRQs locally instead of relying on USB subsystem; dln2
   - Remove unused code; rave-sp
   - New exports; sec-core

  Bug Fixes:
   - Fix possible false I2C transaction error; arizona-core
   - Fix declared memory area size; hi655x-pmic
   - Fix checksum type; rave-sp
   - Fix incorrect default serial port configuration: rave-sp
   - Fix incorrect coherent DMA mask for sub-devices; sm501"

* tag 'mfd-next-4.19' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (60 commits)
  mfd: madera: Add register definitions for accessory detect
  mfd: sm501: Set coherent_dma_mask when creating subdevices
  mfd: bd71837: Devicetree bindings for ROHM BD71837 PMIC
  mfd: bd71837: Core driver for ROHM BD71837 PMIC
  media: platform: cros-ec-cec: Fix dependency on MFD_CROS_EC
  mfd: sec-core: Export OF module alias table
  mfd: as3722: Disable auto-power-on when AC OK
  mfd: axp20x: Support AXP806 in I2C mode
  mfd: axp20x: Add self-working mode support for AXP806
  dt-bindings: mfd: axp20x: Add "self-working" mode for AXP806
  mfd: wm8994: Allow to configure CS/ADDR Pulldown from dts
  mfd: wm8994: Allow to configure Speaker Mode Pullup from dts
  mfd: rave-sp: Emulate CMD_GET_STATUS on device that don't support it
  mfd: rave-sp: Add legacy watchdog ping command translation
  mfd: rave-sp: Add legacy EEPROM access command translation
  mfd: rave-sp: Initialize flow control and parity of the port
  mfd: rave-sp: Fix incorrectly specified checksum type
  mfd: rave-sp: Remove unused defines
  mfd: hi655x: Fix regmap area declared size for hi655x
  mfd: ti_am335x_tscadc: Fix struct clk memory leak
  ...

Pull char/misc driver updates from Greg KH:
 "Here is the bit set of char/misc drivers for 4.19-rc1

  There is a lot here, much more than normal, seems like everyone is
  writing new driver subsystems these days... Anyway, major things here
  are:

   - new FSI driver subsystem, yet-another-powerpc low-level hardware
     bus

   - gnss, finally an in-kernel GPS subsystem to try to tame all of the
     crazy out-of-tree drivers that have been floating around for years,
     combined with some really hacky userspace implementations. This is
     only for GNSS receivers, but you have to start somewhere, and this
     is great to see.

  Other than that, there are new slimbus drivers, new coresight drivers,
  new fpga drivers, and loads of DT bindings for all of these and
  existing drivers.

  All of these have been in linux-next for a while with no reported
  issues"

* tag 'char-misc-4.19-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc: (255 commits)
  android: binder: Rate-limit debug and userspace triggered err msgs
  fsi: sbefifo: Bump max command length
  fsi: scom: Fix NULL dereference
  misc: mic: SCIF Fix scif_get_new_port() error handling
  misc: cxl: changed asterisk position
  genwqe: card_base: Use true and false for boolean values
  misc: eeprom: assignment outside the if statement
  uio: potential double frees if __uio_register_device() fails
  eeprom: idt_89hpesx: clean up an error pointer vs NULL inconsistency
  misc: ti-st: Fix memory leak in the error path of probe()
  android: binder: Show extra_buffers_size in trace
  firmware: vpd: Fix section enabled flag on vpd_section_destroy
  platform: goldfish: Retire pdev_bus
  goldfish: Use dedicated macros instead of manual bit shifting
  goldfish: Add missing includes to goldfish.h
  mux: adgs1408: new driver for Analog Devices ADGS1408/1409 mux
  dt-bindings: mux: add adi,adgs1408
  Drivers: hv: vmbus: Cleanup synic memory free path
  Drivers: hv: vmbus: Remove use of slow_virt_to_phys()
  Drivers: hv: vmbus: Reset the channel callback in vmbus_onoffer_rescind()
  ...

Add the QCOM RPMh regulator driver to manage PMIC regulators
which are controlled via RPMh on some Qualcomm Technologies, Inc.
SoCs.  RPMh is a hardware block which contains several
accelerators which are used to manage various hardware resources
that are shared between the processors of the SoC.  The final
hardware state of a regulator is determined within RPMh by
performing max aggregation of the requests made by all of the
processors.

Add support for PMIC regulator control via the voltage regulator
manager (VRM) and oscillator buffer (XOB) RPMh accelerators.
VRM supports manipulation of enable state, voltage, and mode.
XOB supports manipulation of enable state.

Signed-off-by: David Collins <collinsd@codeaurora.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Replace GPL v2.0+ license statements with SPDX license
identifiers.

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>

Replace GPL v2.0 and v2.0+ license statements with SPDX license
identifiers.

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>