linux-toradex.git/drivers/scsi, branch v3.14.57

mvsas: Fix NULL pointer dereference in mvs_slot_task_free

2015-11-09T20:50:26+00:00

commit 2280521719e81919283b82902ac24058f87dfc1b upstream.

When pci_pool_alloc fails in mvs_task_prep then task->lldd_task stays
NULL but it's later used in mvs_abort_task as slot which is passed
to mvs_slot_task_free causing NULL pointer dereference.

Just return from mvs_slot_task_free when passed with NULL slot.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=101891
Signed-off-by: Dāvis Mosāns 
Reviewed-by: Tomas Henzl 
Reviewed-by: Johannes Thumshirn 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

3w-9xxx: don't unmap bounce buffered commands

2015-10-22T21:39:22+00:00

commit 15e3d5a285ab9283136dba34bbf72886d9146706 upstream.

3w controller don't dma map small single SGL entry commands but instead
bounce buffer them.  Add a helper to identify these commands and don't
call scsi_dma_unmap for them.

Based on an earlier patch from James Bottomley.

Fixes: 118c85 ("3w-9xxx: fix command completion race")
Reported-by: Tóth Attila 
Tested-by: Tóth Attila 
Signed-off-by: Christoph Hellwig 
Acked-by: Adam Radford 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

scsi: fix scsi_error_handler vs. scsi_host_dev_release race

2015-10-22T21:39:16+00:00

commit 537b604c8b3aa8b96fe35f87dd085816552e294c upstream.

b9d5c6b7ef57 ("[SCSI] cleanup setting task state in
scsi_error_handler()") has introduced a race between scsi_error_handler
and scsi_host_dev_release resulting in the hang when the device goes
away because scsi_error_handler might miss a wake up:

CPU0					CPU1
scsi_error_handler			scsi_host_dev_release
  					  kthread_stop()
  kthread_should_stop()
    test_bit(KTHREAD_SHOULD_STOP)
					    set_bit(KTHREAD_SHOULD_STOP)
					    wake_up_process()
					    wait_for_completion()

  set_current_state(TASK_INTERRUPTIBLE)
  schedule()

The most straightforward solution seems to be to invert the ordering of
the set_current_state and kthread_should_stop.

The issue has been noticed during reboot test on a 3.0 based kernel but
the current code seems to be affected in the same way.

[jejb: additional comment added]
Reported-and-debugged-by: Mike Mayer 
Signed-off-by: Michal Hocko 
Reviewed-by: Dan Williams 
Reviewed-by: Hannes Reinecke 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

SCSI: Fix NULL pointer dereference in runtime PM

2015-09-13T16:10:51+00:00

commit 49718f0fb8c9af192b33d8af3a2826db04025371 upstream.

The routines in scsi_rpm.c assume that if a runtime-PM callback is
invoked for a SCSI device, it can only mean that the device's driver
has asked the block layer to handle the runtime power management (by
calling blk_pm_runtime_init(), which among other things sets q->dev).

However, this assumption turns out to be wrong for things like the ses
driver.  Normally ses devices are not allowed to do runtime PM, but
userspace can override this setting.  If this happens, the kernel gets
a NULL pointer dereference when blk_post_runtime_resume() tries to use
the uninitialized q->dev pointer.

This patch fixes the problem by calling the block layer's runtime-PM
routines only if the device's driver really does have a runtime-PM
callback routine.  Since ses doesn't define any such callbacks, the
crash won't occur.

This fixes Bugzilla #101371.

Signed-off-by: Alan Stern 
Reported-by: Stanisław Pitucha 
Reported-by: Ilan Cohen 
Tested-by: Ilan Cohen 
Reviewed-by: Johannes Thumshirn 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

libfc: Fix fc_fcp_cleanup_each_cmd()

2015-09-13T16:10:50+00:00

commit 8f2777f53e3d5ad8ef2a176a4463a5c8e1a16431 upstream.

Since fc_fcp_cleanup_cmd() can sleep this function must not
be called while holding a spinlock. This patch avoids that
fc_fcp_cleanup_each_cmd() triggers the following bug:

BUG: scheduling while atomic: sg_reset/1512/0x00000202
1 lock held by sg_reset/1512:
 #0:  (&(&fsp->scsi_pkt_lock)->rlock){+.-...}, at: [] fc_fcp_cleanup_each_cmd.isra.21+0xa5/0x150 [libfc]
Preemption disabled at:[] fc_fcp_cleanup_each_cmd.isra.21+0xa5/0x150 [libfc]
Call Trace:
 [] dump_stack+0x4f/0x7b
 [] __schedule_bug+0x6c/0xd0
 [] __schedule+0x71a/0xa10
 [] schedule+0x32/0x80
 [] fc_seq_set_resp+0xac/0x100 [libfc]
 [] fc_exch_done+0x41/0x60 [libfc]
 [] fc_fcp_cleanup_each_cmd.isra.21+0xcf/0x150 [libfc]
 [] fc_eh_device_reset+0x1c3/0x270 [libfc]
 [] scsi_try_bus_device_reset+0x29/0x60
 [] scsi_ioctl_reset+0x258/0x2d0
 [] scsi_ioctl+0x150/0x440
 [] sd_ioctl+0xad/0x120
 [] blkdev_ioctl+0x1b6/0x810
 [] block_ioctl+0x38/0x40
 [] do_vfs_ioctl+0x2f8/0x530
 [] SyS_ioctl+0x81/0xa0
 [] system_call_fastpath+0x16/0x7a

Signed-off-by: Bart Van Assche 
Signed-off-by: Vasu Dev 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

libfc: Fix fc_exch_recv_req() error path

2015-09-13T16:10:50+00:00

commit f6979adeaab578f8ca14fdd32b06ddee0d9d3314 upstream.

Due to patch "libfc: Do not invoke the response handler after
fc_exch_done()" (commit ID 7030fd62) the lport_recv() call
in fc_exch_recv_req() is passed a dangling pointer. Avoid this
by moving the fc_frame_free() call from fc_invoke_resp() to its
callers. This patch fixes the following crash:

general protection fault: 0000 [#3] PREEMPT SMP
RIP: fc_lport_recv_req+0x72/0x280 [libfc]
Call Trace:
 fc_exch_recv+0x642/0xde0 [libfc]
 fcoe_percpu_receive_thread+0x46a/0x5ed [fcoe]
 kthread+0x10a/0x120
 ret_from_fork+0x42/0x70

Signed-off-by: Bart Van Assche 
Signed-off-by: Vasu Dev 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

sg_start_req(): make sure that there's not too many elements in iovec

2015-08-17T03:51:51+00:00

commit 451a2886b6bf90e2fb378f7c46c655450fb96e81 upstream.

unfortunately, allowing an arbitrary 16bit value means a possibility of
overflow in the calculation of total number of pages in bio_map_user_iov() -
we rely on there being no more than PAGE_SIZE members of sum in the
first loop there.  If that sum wraps around, we end up allocating
too small array of pointers to pages and it's easy to overflow it in
the second loop.

X-Coverup: TINC (and there's no lumber cartel either)
Signed-off-by: Al Viro 
[bwh: s/MAX_UIOVEC/UIO_MAXIOV/. This was fixed upstream by commit
 fdc81f45e9f5 ("sg_start_req(): use import_iovec()"), but we don't have
  that function.]
Signed-off-by: Greg Kroah-Hartman

ipr: Fix invalid array indexing for HRRQ

2015-08-17T03:51:46+00:00

commit 3f1c0581310d5d94bd72740231507e763a6252a4 upstream.

Fixes another signed / unsigned array indexing bug in the ipr driver.
Currently, when hrrq_index wraps, it becomes a negative number. We
do the modulo, but still have a negative number, so we end up indexing
backwards in the array. Given where the hrrq array is located in memory,
we probably won't actually reference memory we don't own, but nonetheless
ipr is still looking at data within struct ipr_ioa_cfg and interpreting it as
struct ipr_hrr_queue data, so bad things could certainly happen.

Each ipr adapter has anywhere from 1 to 16 HRRQs. By default, we use 2 on new
adapters.  Let's take an example:

Assume ioa_cfg->hrrq_index=0x7fffffffe and ioa_cfg->hrrq_num=4:

The atomic_add_return will then return -1. We mod this with 3 and get -2, add
one and get -1 for an array index.

On adapters which support more than a single HRRQ, we dedicate HRRQ to adapter
initialization and error interrupts so that we can optimize the other queues
for fast path I/O. So all normal I/O uses HRRQ 1-15. So we want to spread the
I/O requests across those HRRQs.

With the default module parameter settings, this bug won't hit, only when
someone sets the ipr.number_of_msix parameter to a value larger than 3 is when
bad things start to happen.

Tested-by: Wen Xiong 
Reviewed-by: Wen Xiong 
Reviewed-by: Gabriel Krisman Bertazi 
Signed-off-by: Brian King 
Reviewed-by: Martin K. Petersen 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

ipr: Fix incorrect trace indexing

2015-08-17T03:51:46+00:00

commit bb7c54339e6a10ecce5c4961adf5e75b3cf0af30 upstream.

When ipr's internal driver trace was changed to an atomic, a signed/unsigned
bug slipped in which results in us indexing backwards in our memory buffer
writing on memory that does not belong to us. This patch fixes this by removing
the modulo and instead just mask off the low bits.

Tested-by: Wen Xiong 
Reviewed-by: Wen Xiong 
Reviewed-by: Gabriel Krisman Bertazi 
Signed-off-by: Brian King 
Reviewed-by: Martin K. Petersen 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman

ipr: Fix locking for unit attention handling

2015-08-17T03:51:46+00:00

commit 36b8e180e1e929e00b351c3b72aab3147fc14116 upstream.

Make sure we have the host lock held when calling scsi_report_bus_reset. Fixes
a crash seen as the __devices list in the scsi host was changing as we were
iterating through it.

Reviewed-by: Wen Xiong 
Reviewed-by: Gabriel Krisman Bertazi 
Signed-off-by: Brian King 
Reviewed-by: Martin K. Petersen 
Signed-off-by: James Bottomley 
Signed-off-by: Greg Kroah-Hartman