commit 11ca2b7ab432eb90906168c327733575e68d388f upstream.

New bindings use "fsl,t1040-ucc-uart" as the compatible for qe-uart.
So add it.

Signed-off-by: Zhao Qiang <qiang.zhao@nxp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

The maximum bitrate supported depends on the clock rate used in BRG.
This is stored in port.uartclk during probe. Respecting the 16x
oversampling higher bitrates can be supported.

Signed-off-by: Alexander Stein <alexander.stein@systec-electronic.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

of_device_id is always used as const.
(See driver.of_match_table and open firmware functions)

Signed-off-by: Fabian Frederick <fabf@skynet.be>
Acked-by: Peter Korsgaard <peter@korsgaard.com>
Acked-by: Timur Tabi <timur@tabi.org>
Acked-by: Patrice Chotard <patrice.chotard@st.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

A platform_driver does not need to set an owner, it will be populated by the
driver core.

Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

Signed-off-by: Alexander Shiyan <shc_work@mail.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

If IGNBRK is set without either BRKINT or PARMRK set, some uart
drivers send a 0x00 byte for BREAK without the TTYBREAK flag to the
line discipline, when it should send either nothing or the TTYBREAK flag
set. This happens because the read_status_mask masks out the BI
condition, which uart_insert_char() then interprets as a normal 0x00 byte.

SUS v3 is clear regarding the meaning of IGNBRK; Section 11.2.2, General
Terminal Interface - Input Modes, states:
  "If IGNBRK is set, a break condition detected on input shall be ignored;
   that is, not put on the input queue and therefore not read by any
   process."

Fix read_status_mask to include the BI bit if IGNBRK is set; the
lsr status retains the BI bit if a BREAK is recv'd, which is
subsequently ignored in uart_insert_char() when masked with the
ignore_status_mask.

Affected drivers:
8250 - all
serial_txx9
mfd
amba-pl010
amba-pl011
atmel_serial
bfin_uart
dz
ip22zilog
max310x
mxs-auart
netx-serial
pnx8xxx_uart
pxa
sb1250-duart
sccnxp
serial_ks8695
sirfsoc_uart
st-asc
vr41xx_siu
zs
sunzilog
fsl_lpuart
sunsab
ucc_uart
bcm63xx_uart
sunsu
efm32-uart
pmac_zilog
mpsc
msm_serial
m32r_sio

Unaffected drivers:
omap-serial
rp2
sa1100
imx
icom

Annotated for fixes:
altera_uart
mcf

Drivers without break detection:
21285
xilinx-uartps
altera_jtaguart
apbuart
arc-uart
clps711x
max3100
uartlite
msm_serial_hs
nwpserial
lantiq
vt8500_serial

Unknown:
samsung
mpc52xx_uart
bfin_sport_uart
cpm_uart/core

Fixes: Bugzilla #71651, '8250_core.c incorrectly handles IGNBRK flag'
Reported-by: Ivan <athlon_@mail.ru>
Signed-off-by: Peter Hurley <peter@hurleysoftware.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Pull devicetree updates from Rob Herring:
 "DeviceTree updates for 3.13.  This is a bit larger pull request than
  usual for this cycle with lots of clean-up.

   - Cross arch clean-up and consolidation of early DT scanning code.
   - Clean-up and removal of arch prom.h headers.  Makes arch specific
     prom.h optional on all but Sparc.
   - Addition of interrupts-extended property for devices connected to
     multiple interrupt controllers.
   - Refactoring of DT interrupt parsing code in preparation for
     deferred probe of interrupts.
   - ARM cpu and cpu topology bindings documentation.
   - Various DT vendor binding documentation updates"

* tag 'devicetree-for-3.13' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux: (82 commits)
  powerpc: add missing explicit OF includes for ppc
  dt/irq: add empty of_irq_count for !OF_IRQ
  dt: disable self-tests for !OF_IRQ
  of: irq: Fix interrupt-map entry matching
  MIPS: Netlogic: replace early_init_devtree() call
  of: Add Panasonic Corporation vendor prefix
  of: Add Chunghwa Picture Tubes Ltd. vendor prefix
  of: Add AU Optronics Corporation vendor prefix
  of/irq: Fix potential buffer overflow
  of/irq: Fix bug in interrupt parsing refactor.
  of: set dma_mask to point to coherent_dma_mask
  of: add vendor prefix for PHYTEC Messtechnik GmbH
  DT: sort vendor-prefixes.txt
  of: Add vendor prefix for Cadence
  of: Add empty for_each_available_child_of_node() macro definition
  arm/versatile: Fix versatile irq specifications.
  of/irq: create interrupts-extended property
  microblaze/pci: Drop PowerPC-ism from irq parsing
  of/irq: Create of_irq_parse_and_map_pci() to consolidate arch code.
  of/irq: Use irq_of_parse_and_map()
  ...

These aren't necessary after switch and while blocks.

Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Powerpc is a mess of implicit includes by prom.h. Add the necessary
explicit includes to drivers in preparation of prom.h cleanup.

Signed-off-by: Rob Herring <rob.herring@calxeda.com>
Acked-by: Grant Likely <grant.likely@linaro.org>

when platform_driver_register broken, we should unregister ucc_uart_driver

Signed-off-by: Libo chen <libo.chen@huawei.com>
Acked-by: Timur Tabi <timur@tabi.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>