The in_recovery rw_semaphore has always been acquired and
released by different threads by design.  To work around
the "BUG: bad unlock balance detected!" messages, adjust
things so the dlm_recoverd thread always does both down_write
and up_write.

Signed-off-by: David Teigland <teigland@redhat.com>

When a large number of resources are being recovered,
a linear search of the recover_list takes a long time.
Use an idr in place of a list.

Signed-off-by: David Teigland <teigland@redhat.com>

Remove the dir hash table (dirtbl), and use
the rsb hash table (rsbtbl) as the resource
directory.  It has always been an unnecessary
duplication of information.

This improves efficiency by using a single rsbtbl
lookup in many cases where both rsbtbl and dirtbl
lookups were needed previously.

This eliminates the need to handle cases of rsbtbl
and dirtbl being out of sync.

In many cases there will be memory savings because
the dir hash table no longer exists.

Signed-off-by: David Teigland <teigland@redhat.com>

The "nodir" mode (statically assign master nodes instead
of using the resource directory) has always been highly
experimental, and never seriously used.  This commit
fixes a number of problems, making nodir much more usable.

- Major change to recovery: recover all locks and restart
  all in-progress operations after recovery.  In some
  cases it's not possible to know which in-progess locks
  to recover, so recover all.  (Most require recovery
  in nodir mode anyway since rehashing changes most
  master nodes.)

- Change the way nodir mode is enabled, from a command
  line mount arg passed through gfs2, into a sysfs
  file managed by dlm_controld, consistent with the
  other config settings.

- Allow recovering MSTCPY locks on an rsb that has not
  yet been turned into a master copy.

- Ignore RCOM_LOCK and RCOM_LOCK_REPLY recovery messages
  from a previous, aborted recovery cycle.  Base this
  on the local recovery status not being in the state
  where any nodes should be sending LOCK messages for the
  current recovery cycle.

- Hold rsb lock around dlm_purge_mstcpy_locks() because it
  may run concurrently with dlm_recover_master_copy().

- Maintain highbast on process-copy lkb's (in addition to
  the master as is usual), because the lkb can switch
  back and forth between being a master and being a
  process copy as the master node changes in recovery.

- When recovering MSTCPY locks, flag rsb's that have
  non-empty convert or waiting queues for granting
  at the end of recovery.  (Rename flag from LOCKS_PURGED
  to RECOVER_GRANT and similar for the recovery function,
  because it's not only resources with purged locks
  that need grant a grant attempt.)

- Replace a couple of unnecessary assertion panics with
  error messages.

Signed-off-by: David Teigland <teigland@redhat.com>

Unify the checking for both types of ignored
rcom messages, and replace the two log_debug
statements with a single, rate limited debug
message.

Signed-off-by: David Teigland <teigland@redhat.com>

Slot numbers are assigned to nodes when they join the lockspace.
The slot number chosen is the minimum unused value starting at 1.
Once a node is assigned a slot, that slot number will not change
while the node remains a lockspace member.  If the node leaves
and rejoins it can be assigned a new slot number.

A new generation number is also added to a lockspace.  It is
set and incremented during each recovery along with the slot
collection/assignment.

The slot numbers will be passed to gfs2 which will use them as
journal id's.

Signed-off-by: David Teigland <teigland@redhat.com>

Change how callbacks are recorded for locks.  Previously, information
about multiple callbacks was combined into a couple of variables that
indicated what the end result should be.  In some situations, we
could not tell from this combined state what the exact sequence of
callbacks were, and would end up either delivering the callbacks in
the wrong order, or suppress redundant callbacks incorrectly.  This
new approach records all the data for each callback, leaving no
uncertainty about what needs to be delivered.

Signed-off-by: David Teigland <teigland@redhat.com>

Replace all GFP_KERNEL and ls_allocation with GFP_NOFS.
ls_allocation would be GFP_KERNEL for userland lockspaces
and GFP_NOFS for file system lockspaces.

It was discovered that any lockspaces on the system can
affect all others by triggering memory reclaim in the
file system which could in turn call back into the dlm
to acquire locks, deadlocking dlm threads that were
shared by all lockspaces, like dlm_recv.

Signed-off-by: David Teigland <teigland@redhat.com>

The recent patch to validate data lengths in rcom_names messages
failed to account for fake messages a node directs to itself before
ever sending it.  In this case we need to fill in the message length
in the header for the validation code to use.

Signed-off-by: David Teigland <teigland@redhat.com>

Use proper types for ast and bast functions, and use
consistent type for ast param.

Signed-off-by: David Teigland <teigland@redhat.com>