For blocksize < pagesize we need to remove blocks that got allocated in
block_write_begin() if we fail with ENOSPC for later blocks.
block_write_begin() internally does this if it allocated page locally.
This makes sure we don't have blocks outside inode.i_size during ENOSPC.

Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Any block based fs (this patch includes ext3) just has to declare its own
fiemap() function and then call this generic function with its own
get_block_t. This works well for block based filesystems that will map
multiple contiguous blocks at one time, but will work for filesystems that
only map one block at a time, you will just end up with an "extent" for each
block. One gotcha is this will not play nicely where there is hole+data
after the EOF. This function will assume its hit the end of the data as soon
as it hits a hole after the EOF, so if there is any data past that it will
not pick that up. AFAIK no block based fs does this anyway, but its in the
comments of the function anyway just in case.

Signed-off-by: Josef Bacik <jbacik@redhat.com>
Signed-off-by: Mark Fasheh <mfasheh@suse.com>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>
Cc: linux-fsdevel@vger.kernel.org

When we read some part of a file through pagecache, if there is a
pagecache of corresponding index but this page is not uptodate, read IO
is issued and this page will be uptodate.

I think this is good for pagesize == blocksize environment but there is
room for improvement on pagesize != blocksize environment.  Because in
this case a page can have multiple buffers and even if a page is not
uptodate, some buffers can be uptodate.

So I suggest that when all buffers which correspond to a part of a file
that we want to read are uptodate, use this pagecache and copy data from
this pagecache to user buffer even if a page is not uptodate.  This can
reduce read IO and improve system throughput.

I wrote a benchmark program and got result number with this program.

This benchmark do:

  1: mount and open a test file.

  2: create a 512MB file.

  3: close a file and umount.

  4: mount and again open a test file.

  5: pwrite randomly 300000 times on a test file.  offset is aligned
     by IO size(1024bytes).

  6: measure time of preading randomly 100000 times on a test file.

The result was:
	2.6.26
        330 sec

	2.6.26-patched
        226 sec

Arch:i386
Filesystem:ext3
Blocksize:1024 bytes
Memory: 1GB

On ext3/4, a file is written through buffer/block.  So random read/write
mixed workloads or random read after random write workloads are optimized
with this patch under pagesize != blocksize environment.  This test result
showed this.

The benchmark program is as follows:

#include <stdio.h>
#include <sys/types.h>
#include <sys/stat.h>
#include <fcntl.h>
#include <unistd.h>
#include <time.h>
#include <stdlib.h>
#include <string.h>
#include <sys/mount.h>

#define LEN 1024
#define LOOP 1024*512 /* 512MB */

main(void)
{
	unsigned long i, offset, filesize;
	int fd;
	char buf[LEN];
	time_t t1, t2;

	if (mount("/dev/sda1", "/root/test1/", "ext3", 0, 0) < 0) {
		perror("cannot mount\n");
		exit(1);
	}
	memset(buf, 0, LEN);
	fd = open("/root/test1/testfile", O_CREAT|O_RDWR|O_TRUNC);
	if (fd < 0) {
		perror("cannot open file\n");
		exit(1);
	}
	for (i = 0; i < LOOP; i++)
		write(fd, buf, LEN);
	close(fd);
	if (umount("/root/test1/") < 0) {
		perror("cannot umount\n");
		exit(1);
	}
	if (mount("/dev/sda1", "/root/test1/", "ext3", 0, 0) < 0) {
		perror("cannot mount\n");
		exit(1);
	}
	fd = open("/root/test1/testfile", O_RDWR);
	if (fd < 0) {
		perror("cannot open file\n");
		exit(1);
	}

	filesize = LEN * LOOP;
	for (i = 0; i < 300000; i++){
		offset = (random() % filesize) & (~(LEN - 1));
		pwrite(fd, buf, LEN, offset);
	}
	printf("start test\n");
	time(&t1);
	for (i = 0; i < 100000; i++){
		offset = (random() % filesize) & (~(LEN - 1));
		pread(fd, buf, LEN, offset);
	}
	time(&t2);
	printf("%ld sec\n", t2-t1);
	close(fd);
	if (umount("/root/test1/") < 0) {
		perror("cannot umount\n");
		exit(1);
	}
}

Signed-off-by: Hisashi Hifumi <hifumi.hisashi@oss.ntt.co.jp>
Cc: Nick Piggin <nickpiggin@yahoo.com.au>
Cc: Christoph Hellwig <hch@infradead.org>
Cc: Jan Kara <jack@ucw.cz>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

While freeing indirect blocks we attach a journal head to the parent
buffer head, free the blocks, then journal the parent.  If the indirect
block list is corrupted and points to the parent the journal head will be
detached when the block is cleared, causing an OOPS.

Check for that explicitly and handle it gracefully.

This patch fixes the third case (image hdb.20000057.nullderef.gz)
reported in http://bugzilla.kernel.org/show_bug.cgi?id=10882.

Immediately above the change, in the ext3_free_data function, we call
ext3_clear_blocks to clear the indirect blocks in this parent block.  If
one of those blocks happens to actually be the parent block it will clear
b_private / BH_JBD.

I did the check at the end rather than earlier as it seemed more elegant.
I don't think there should be much practical difference, although it is
possible the FS may not be quite so badly corrupted if we did it the other
way (and didn't clear the block at all).  To be honest, I'm not convinced
there aren't other similar failure modes lurking in this code, although I
couldn't find any with a quick review.

[akpm@linux-foundation.org: fix printk warning]
Signed-off-by: Duane Griffin <duaneg@dghda.com>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

A transient I/O error can corrupt inode data.  Here is the scenario:

(1) update inode_A at the block_B
(2) pdflush writes out new inode_A to the filesystem, but it results
    in write I/O error, at this point, BH_Uptodate flag of the buffer
    for block_B is cleared and BH_Write_EIO is set
(3) create new inode_C which located at block_B, and
    __ext3_get_inode_loc() tries to read on-disk block_B because the
    buffer is not uptodate
(4) if it can read on-disk block_B successfully, inode_A is
    overwritten by old data

This patch makes __ext3_get_inode_loc() not read the inode block if the
buffer has BH_Write_EIO flag.  In this case, the buffer should have the
latest information, so setting the uptodate flag to the buffer (this
avoids WARN_ON_ONCE() in mark_buffer_dirty().)

According to this change, we would need to test BH_Write_EIO flag for the
error checking.  Currently nobody checks write I/O errors on metadata
buffers, but it will be done in other patches I'm working on.

Signed-off-by: Hidehiro Kawai <hidehiro.kawai.ez@hitachi.com>
Cc: sugita <yumiko.sugita.yf@hitachi.com>
Cc: Satoshi OSHIMA <satoshi.oshima.fk@hitachi.com>
Cc: Nick Piggin <nickpiggin@yahoo.com.au>
Cc: Jan Kara <jack@ucw.cz>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

If the orphan node list includes valid, untruncatable nodes with nlink > 0
the ext3_orphan_cleanup loop which attempts to delete them will not do so,
causing it to loop forever. Fix by checking for such nodes in the
ext3_orphan_get function.

This patch fixes the second case (image hdb.20000009.softlockup.gz)
reported in http://bugzilla.kernel.org/show_bug.cgi?id=10882.

[akpm@linux-foundation.org: coding-style fixes]
[akpm@linux-foundation.org: printk warning fix]
Signed-off-by: Duane Griffin <duaneg@dghda.com>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

'copied' is unsigned, whereas 'ret2' is not. The test (copied < 0) fails

Signed-off-by: Roel Kluin <12o3l@tiscali.nl>
Signed-off-by: "Theodore Ts'o" <tytso@mit.edu>

__FUNCTION__ is gcc-specific, use __func__

Signed-off-by: Harvey Harrison <harvey.harrison@gmail.com>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Use ext3_get_group_desc()

Signed-off-by: Akinobu Mita <akinobu.mita@gmail.com>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Spelling fix: prefered -> preferred

Signed-off-by: Benoit Boissinot <benoit.boissinot@ens-lyon.org>
Signed-off-by: Jesper Juhl <jesper.juhl@gmail.com>