Add PMC fast startup registers defines.

Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

In the ULP1 mode, in order to achieve the lowest power consumption
with the system in retention mode and be able to resume on the wake
up events, all the clocks are shut off, inclusive the embedded 12MHz
RC oscillator, and the number of wake up sources is limited as well.
When the wake up event is asserted, the embedded 12MHz RC oscillator
restarts automatically.

The ULP1 (Ultra Low-power mode 1) is introduced by SAMA5D2.

The previous size of pm_suspend.o was 2148 bytes. With the addition of
ULP1 mode the new size of pm_suspend.o raised at 2456 bytes.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Signed-off-by: Ludovic Desroches <ludovic.desroches@microchip.com>
[claudiu.beznea@microchip.com: aligned with 4.18-rc1]
Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

This fixes linker errors due to undefined symbols when one or more of
the TI DaVinci SoCs is not enabled in the kernel config.

Signed-off-by: David Lechner <david@lechnology.com>
Signed-off-by: Michael Turquette <mturquette@baylibre.com>
Link: lkml.kernel.org/r/20180525181150.17873-10-david@lechnology.com

On some davinci SoCs, we need to register the PSC clocks during early
boot because they are needed for clocksource/clockevent. These changes
allow for dev == NULL because in this case, we won't have a platform
device for the clocks.

Signed-off-by: David Lechner <david@lechnology.com>
Reviewed-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Michael Turquette <mturquette@baylibre.com>
Link: lkml.kernel.org/r/20180525181150.17873-9-david@lechnology.com

This modifies the TI Davinci PLL clock driver to allow for the case
when dev == NULL. On some (most) SoCs that use this driver, the PLL
clock needs to be registered during early boot because it is used
for clocksource/clkevent and there will be no platform device available.

Signed-off-by: David Lechner <david@lechnology.com>
Reviewed-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Michael Turquette <mturquette@baylibre.com>
Link: lkml.kernel.org/r/20180525181150.17873-7-david@lechnology.com

Pull clk updates from Stephen Boyd:
 "The large diff this time around is from the addition of a new clk
  driver for the TI Davinci family of SoCs. So far those clks have been
  supported with a custom implementation of the clk API in the arch port
  instead of in the CCF. With this driver merged we're one step closer
  to having a single clk API implementation.

  The other large diff is from the Amlogic clk driver that underwent
  some major surgery to use regmap. Beyond that, the biggest hitter is
  Samsung which needed some reworks to properly handle clk provider
  power domains and a bunch of PLL rate updates.

  The core framework was fairly quiet this round, just getting some
  cleanups and small fixes for some of the more esoteric features. And
  the usual set of driver non-critical fixes, cleanups, and minor
  additions are here as well.

  Core:
   - Rejig clk_ops::init() to be a little earlier for phase/accuracy ops
   - debugfs ops macroized to shave some lines of boilerplate code
   - Always calculate the phase instead of caching it in clk_get_phase()
   - More __must_check on bulk clk APIs

  New Drivers:
   - TI's Davinci family of SoCs
   - Intel's Stratix10 SoC
   - stm32mp157 SoC
   - Allwinner H6 CCU
   - Silicon Labs SI544 clock generator chip
   - Renesas R-Car M3-N and V3H SoCs
   - i.MX6SLL SoCs

  Removed Drivers:
   - ST-Ericsson AB8540/9540

  Updates:
   - Mediatek MT2701 and MT7622 audsys support and MT2712 updates
   - STM32F469 DSI and STM32F769 sdmmc2 support
   - GPIO clks can sleep now
   - Spreadtrum SC9860 RTC clks
   - Nvidia Tegra MBIST workarounds and various minor fixes
   - Rockchip phase handling fixes and a memory leak plugged
   - Renesas drivers switch to readl/writel from clk_readl/clk_writel
   - Renesas gained CPU (Z/Z2) and watchdog support
   - Rockchip rk3328 display clks and rk3399 1.6GHz PLL support
   - Qualcomm PM8921 PMIC XO buffers
   - Amlogic migrates to regmap APIs
   - TI Keystone clk latching support
   - Allwinner H3 and H5 video clk fixes
   - Broadcom BCM2835 PLLs needed another bit to enable
   - i.MX6SX CKO mux fix and i.MX7D Video PLL divider fix
   - i.MX6UL/ULL epdc_podf support
   - Hi3798CV200 COMBPHY0 and USB2_OTG_UTMI and phase support for eMMC"

* tag 'clk-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux: (233 commits)
  clk: davinci: add a reset lookup table for psc0
  clk: imx: add clock driver for imx6sll
  dt-bindings: imx: update clock doc for imx6sll
  clk: imx: add new gate/gate2 wrapper funtion
  clk: imx: Add CLK_IS_CRITICAL flag for busy divider and busy mux
  clk: cs2000: set pm_ops in hibernate-compatible way
  clk: bcm2835: De-assert/assert PLL reset signal when appropriate
  clk: imx7d: Move clks_init_on before any clock operations
  clk: imx7d: Correct ahb clk parent select
  clk: imx7d: Correct dram pll type
  clk: imx7d: Add USB clock information
  clk: socfpga: stratix10: add clock driver for Stratix10 platform
  dt-bindings: documentation: add clock bindings information for Stratix10
  clk: ti: fix flag space conflict with clkctrl clocks
  clk: uniphier: add additional ethernet clock lines for Pro4
  clk: uniphier: add SATA clock control support
  clk: uniphier: add PCIe clock control support
  clk: Add driver for the si544 clock generator chip
  clk: davinci: Remove redundant dev_err calls
  clk: uniphier: add ethernet clock control support for PXs3
  ...

* clk-ti:
  clk: keystone: sci-clk: add support for dynamically probing clocks
  clk: ti: add support for clock latching to mux clocks
  clk: ti: add support for clock latching to divider clocks
  clk: ti: add generic support for clock latching
  clk: ti: add support for register read-modify-write low-level operation
  dt-bindings: clock: ti: add latching support to mux and divider clocks

* clk-amlogic: (50 commits)
  clk: meson: Drop unused local variable and add static
  clk: meson: clean-up clk81 clocks
  clk: meson: add fdiv clock gates
  clk: meson: add mpll pre-divider
  clk: meson: axg: add hifi pll clock
  clk: meson: axg: add hifi clock bindings
  clk: meson: add ROUND_CLOSEST to the pll driver
  clk: meson: add gp0 frac parameter for axg and gxl
  clk: meson: improve pll driver results with frac
  clk: meson: remove special gp0 lock loop
  clk: meson: poke pll CNTL last
  clk: meson: add fractional part of meson8b fixed_pll
  clk: meson: use hhi syscon if available
  clk: meson: remove obsolete cpu_clk
  clk: meson: rework meson8b cpu clock
  clk: meson: split divider and gate part of mpll
  clk: meson: migrate plls clocks to clk_regmap
  clk: meson: migrate the audio divider clock to clk_regmap
  clk: meson: migrate mplls clocks to clk_regmap
  clk: meson: add regmap helpers for parm
  ...

* clk-tegra:
  clk: tegra: Fix pll_u rate configuration
  clk: tegra: Specify VDE clock rate
  clk: tegra20: Correct PLL_C_OUT1 setup
  clk: tegra: Mark HCLK, SCLK and EMC as critical
  clk: tegra: MBIST work around for Tegra210
  clk: tegra: add fence_delay for clock registers
  clk: tegra: Add la clock for Tegra210

* clk-samsung: (22 commits)
  clk: samsung: Mark a few things static
  clk: samsung: Add fout=196608001 Hz EPLL rate entry for exynos4412
  clk: samsung: exynos5250: Add missing clocks for FIMC LITE SYSMMU devices
  clk: samsung: exynos5420: Add more entries to EPLL rate table
  clk: samsung: exynos5420: Add CLK_SET_RATE_PARENT flag to mout_mau_epll_clk
  clk: samsung: exynos5250: Move PD-dependent clocks to Exynos5 sub-CMU
  clk: samsung: exynos5420: Move PD-dependent clocks to Exynos5 sub-CMU
  clk: samsung: Add Exynos5 sub-CMU clock driver
  soc: samsung: pm_domains: Add blacklisting clock handling
  clk: samsung: Add compile time PLL rate validators
  clk: samsung: s3c2410: Fix PLL rates
  clk: samsung: exynos7: Fix PLL rates
  clk: samsung: exynos5433: Fix PLL rates
  clk: samsung: exynos5260: Fix PLL rates
  clk: samsung: exynos5250: Fix PLL rates
  clk: samsung: exynos3250: Fix PLL rates
  clk: exynos5433: Extend list of available AUD_PLL output frequencies
  clk: exynos5433: Add CLK_IGNORE_UNUSED flag to sclk_ioclk_i2s1_bclk
  clk: samsung: Add a git tree entry to MAINTAINERS
  clk: samsung: Remove redundant dev_err call in exynos_audss_clk_probe()
  ...

Control module can have multiple instances in a system, each with separate
address space and features. Add base support for these auxiliary instances,
with support for syscon and clock mappings under them.

Signed-off-by: Tero Kristo <t-kristo@ti.com>
Tested-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

Tegra210 has a hw bug which can cause IP blocks to lock up when ungating a
domain. The reason is that the logic responsible for resetting the memory
built-in self test mode can come up in an undefined state because its
clock is gated by a second level clock gate (SLCG). Work around this by
making sure the logic will get some clock edges by ensuring the relevant
clock is enabled and temporarily override the relevant SLCGs.
Unfortunately for some IP blocks, the control bits for overriding the
SLCGs are not in CAR, but in the IP block itself. This means we need to
map a few extra register banks in the clock code.

Signed-off-by: Peter De Schrijver <pdeschrijver@nvidia.com>
Reviewed-by: Jon Hunter <jonathanh@nvidia.com>
Tested-by: Jon Hunter <jonathanh@nvidia.com>
Tested-by: Hector Martin <marcan@marcan.st>
Tested-by: Andre Heider <a.heider@gmail.com>
Tested-by: Mikko Perttunen <mperttunen@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>

fixup mbist

Useful for changing few bits on a register, this makes sure for example
that the operation is done atomically in case of syscon.

Signed-off-by: Tero Kristo <t-kristo@ti.com>