linux-toradex.git/include/linux, branch PD13.2.2

EDT-FT5x06: initial checkin of upstream FT5x06 patch

2013-11-07T17:19:27+00:00

Signed-off-by: Christian Hemp

Fixed support for Micrel's ksz9031 Gigabit phy modified: drivers/net/phy/micrel.c modified: include/linux/micrel_phy.h

2013-11-07T17:19:26+00:00

Signed-off-by: Christian Hemp

Added header file for mt9v024 camera that defines camera's features new file: include/linux/platform_data/mt9v02x.h

2013-11-07T17:19:24+00:00

Signed-off-by: Christian Hemp

MXC IPU capture: add support for greyscale formats

2013-11-07T17:19:21+00:00

Add support for 8-bit and 10-bit grayscale data on CSI interface
(non-tested yet).

Signed-off-by: Yauhen Kharuzhy 
Signed-off-by: Christian Hemp

Driver for DA9063 PMIC.

2013-11-07T17:19:16+00:00

Ported from kernel 3.0.15.

Signed-off-by: Christian Hemp

ldb handle platform specific ldb mode database

2013-11-07T17:19:15+00:00

Conflicts:

	arch/arm/mach-mx6/board-mx6q_sabresd.c

Signed-off-by: Christian Hemp

phytec micrel

2013-11-07T17:19:14+00:00

Signed-off-by: Christian Hemp

can: dev: let can_get_echo_skb() return dlc of CAN frame

2013-04-16T06:34:58+00:00

can_get_echo_skb() is usually called in the TX complete handler.
The stats->tx_packets and stats->tx_bytes should be updated there, too.
This patch simplifies to figure out the size of the sent CAN frame.

Signed-off-by: Marc Kleine-Budde

ENGR00258357-5: mlb: Use circle buf macros to replace old ringbuf mechanism

2013-04-15T09:29:07+00:00

Use circle buf to replace old ringbuf mechanism.
Change to use circle buffer in read, write, rx isr and tx isr functions.
In first design of MLB, it's using it's own mechanism to manage ring
buffer, like in mxc_mlb.c.
And then, I saw that kernel already had a serials of circ buffer macros
which can be used to manage ring buffers.
This patch is to use circle buffer macros to manage mlb internal ring
buffers.
For detail of circle buffers, you can refer to
linux-2.6-imx/Documentation/circular-buffers.txt.

Signed-off-by: Terry Lv

ENGR00257847-2 MX6Q/DL-Fix Ethernet performance issue when WAIT mode is active

2013-04-12T18:47:52+00:00

All of the interrupts from the ENET block are not routed to
the GPC block. Hence ENET interrupts are not able to wake
up the SOC when the system is in WAIT mode. And the ENET
interrupt gets serviced only when another interrupt causes
the SOC to exit WAIT mode. This impacts the ENET performance.

To fix the issue two options:
1. Route the ENET interrupt to a GPIO. Need to enable the
CONFIG_MX6_ENET_IRQ_TO_GPIO in the config.
2. If the GPIO mechanism cannot be used and is not enabled
by the above mentioned config, the patch will disable entry
to WAIT mode until ENET clock is active. When the ENET clock
is disabled, WAIT mode will be automatically enetered.

Signed-off-by: Ranjani Vaidyanathan