It may be up to the driver (in case ANY HW stats is passed) to select
which type of HW stats he is going to use. Add an infrastructure to
expose this information to user.

$ tc filter add dev enp3s0np1 ingress proto ip handle 1 pref 1 flower dst_ip 192.168.1.1 action drop
$ tc -s filter show dev enp3s0np1 ingress
filter protocol ip pref 1 flower chain 0
filter protocol ip pref 1 flower chain 0 handle 0x1
  eth_type ipv4
  dst_ip 192.168.1.1
  in_hw in_hw_count 2
        action order 1: gact action drop
         random type none pass val 0
         index 1 ref 1 bind 1 installed 10 sec used 10 sec
        Action statistics:
        Sent 0 bytes 0 pkt (dropped 0, overlimits 0 requeues 0)
        backlog 0b 0p requeues 0
        used_hw_stats immediate     <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Signed-off-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Add an error message when device wasn't found.
While there, also set the bad attribute's offset in extack.

Signed-off-by: Guillaume Nault <gnault@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

When the RED Qdisc is currently configured to enable ECN, the RED algorithm
is used to decide whether a certain SKB should be marked. If that SKB is
not ECN-capable, it is early-dropped.

It is also possible to keep all traffic in the queue, and just mark the
ECN-capable subset of it, as appropriate under the RED algorithm. Some
switches support this mode, and some installations make use of it.

To that end, add a new RED flag, TC_RED_NODROP. When the Qdisc is
configured with this flag, non-ECT traffic is enqueued instead of being
early-dropped.

Signed-off-by: Petr Machata <petrm@mellanox.com>
Reviewed-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

Invoke ndo_setup_tc() as appropriate to signal init / replacement,
destroying and dumping of pFIFO / bFIFO Qdisc.

A lot of the FIFO logic is used for pFIFO_head_drop as well, but that's a
semantically very different Qdisc that isn't really in the same boat as
pFIFO / bFIFO. Split some of the functions to keep the Qdisc intact.

Signed-off-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Acked-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

On ingress and cls_act qdiscs init, save the block on ingress
mini_Qdisc and and pass it on to ingress classification, so it
can be used for the looking up a specified chain index.

Co-developed-by: Vlad Buslov <vladbu@mellanox.com>
Signed-off-by: Vlad Buslov <vladbu@mellanox.com>
Signed-off-by: Paul Blakey <paulb@mellanox.com>
Reviewed-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>

TC multi chain configuration can cause offloaded tc chains to miss in
hardware after jumping to some chain. In such cases the software should
continue from the chain that missed in hardware, as the hardware may
have manipulated the packet and updated some counters.

Currently a single tcf classification function serves both ingress and
egress. However, multi chain miss processing (get tc skb extension on
hw miss, set tc skb extension on tc miss) should happen only on
ingress.

Refactor the code to use ingress classification function, and move setting
the tc skb extension from general classification to it, as a prestep
for supporting the hw miss scenario.

Co-developed-by: Vlad Buslov <vladbu@mellanox.com>
Signed-off-by: Vlad Buslov <vladbu@mellanox.com>
Signed-off-by: Paul Blakey <paulb@mellanox.com>
Reviewed-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>

Refactor tc_setup_flow_action() function not to use rtnl lock and remove
'rtnl_held' argument that is no longer needed.

Signed-off-by: Vlad Buslov <vladbu@mellanox.com>
Acked-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The current implementations of ops->bind_class() are merely
searching for classid and updating class in the struct tcf_result,
without invoking either of cl_ops->bind_tcf() or
cl_ops->unbind_tcf(). This breaks the design of them as qdisc's
like cbq use them to count filters too. This is why syzbot triggered
the warning in cbq_destroy_class().

In order to fix this, we have to call cl_ops->bind_tcf() and
cl_ops->unbind_tcf() like the filter binding path. This patch does
so by refactoring out two helper functions __tcf_bind_filter()
and __tcf_unbind_filter(), which are lockless and accept a Qdisc
pointer, then teaching each implementation to call them correctly.

Note, we merely pass the Qdisc pointer as an opaque pointer to
each filter, they only need to pass it down to the helper
functions without understanding it at all.

Fixes: 07d79fc7d94e ("net_sched: add reverse binding for tc class")
Reported-and-tested-by: syzbot+0a0596220218fcb603a8@syzkaller.appspotmail.com
Reported-and-tested-by: syzbot+63bdb6006961d8c917c6@syzkaller.appspotmail.com
Cc: Jamal Hadi Salim <jhs@mojatatu.com>
Cc: Jiri Pirko <jiri@resnulli.us>
Signed-off-by: Cong Wang <xiyou.wangcong@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Invoke ndo_setup_tc as appropriate to signal init / replacement, destroying
and dumping of TBF Qdisc.

Signed-off-by: Petr Machata <petrm@mellanox.com>
Acked-by: Jiri Pirko <jiri@mellanox.com>
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>