* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6:
  wimax/i2400m: fix missing endian correction read in fw loader
  net8139: fix a race at the end of NAPI
  pktgen: Fix accuracy of inter-packet delay.
  pkt_sched: gen_estimator: add a new lock
  net: deliver skbs on inactive slaves to exact matches
  ipv6: fix ICMP6_MIB_OUTERRORS
  r8169: fix mdio_read and update mdio_write according to hw specs
  gianfar: Revive the driver for eTSEC devices (disable timestamping)
  caif: fix a couple range checks
  phylib: Add support for the LXT973 phy.
  net: Print num_rx_queues imbalance warning only when there are allocated queues

Currently, the accelerated receive path for VLAN's will
drop packets if the real device is an inactive slave and
is not one of the special pkts tested for in
skb_bond_should_drop().  This behavior is different then
the non-accelerated path and for pkts over a bonded vlan.

For example,

vlanx -> bond0 -> ethx

will be dropped in the vlan path and not delivered to any
packet handlers at all.  However,

bond0 -> vlanx -> ethx

and

bond0 -> ethx

will be delivered to handlers that match the exact dev,
because the VLAN path checks the real_dev which is not a
slave and netif_recv_skb() doesn't drop frames but only
delivers them to exact matches.

This patch adds a sk_buff flag which is used for tagging
skbs that would previously been dropped and allows the
skb to continue to skb_netif_recv().  Here we add
logic to check for the deliver_no_wcard flag and if it
is set only deliver to handlers that match exactly.  This
makes both paths above consistent and gives pkt handlers
a way to identify skbs that come from inactive slaves.
Without this patch in some configurations skbs will be
delivered to handlers with exact matches and in others
be dropped out right in the vlan path.

I have tested the following 4 configurations in failover modes
and load balancing modes.

# bond0 -> ethx

# vlanx -> bond0 -> ethx

# bond0 -> vlanx -> ethx

# bond0 -> ethx
            |
  vlanx -> --

Signed-off-by: John Fastabend <john.r.fastabend@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

* 'perf-fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/linux-2.6-tip:
  tracing: Fix null pointer deref with SEND_SIG_FORCED
  perf: Fix signed comparison in perf_adjust_period()
  powerpc/oprofile: fix potential buffer overrun in op_model_cell.c
  perf symbols: Set the DSO long name when using symbol_conf.vmlinux_name

10, 233 is allocated officially to /dev/kmview which is shipping in
Ubuntu and Debian distributions.  vhost_net seem to have borrowed it
without making a proper request and this causes regressions in the other
distributions.

vhost_net can use a dynamic minor so use that instead.  Also update the
file with a comment to try and avoid future misunderstandings.

cc: stable@kernel.org
Signed-off-by: Alan Cox <device@lanana.org>
[ We should have caught this before 2.6.34 got released.  - Linus ]
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

* 'drm-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6: (23 commits)
  drm/radeon: don't poll tv dac if crtc2 is in use.
  drm/radeon: reset i2c valid to avoid incorrect tv-out polling.
  drm/nv50: fix iommu errors caused by device reading from address 0
  drm/nouveau: off by one in init_i2c_device_find()
  nouveau: off by one in nv50_gpio_location()
  drm/nouveau: completely fail init if we fail to map the PRAMIN BAR
  drm/nouveau: match U/DP script against SOR link
  drm/radeon/kms/pm: resurrect printing power states
  drm/radeon/kms: add trivial debugging for voltage
  drm/radeon/kms/r600+: use voltage from requested clock mode (v3)
  drm/radeon/kms/pm: track current voltage (v2)
  drm/radeon/kms/pm: Disable voltage adjust on RS780/RS880
  drm/radeon/kms: fix typo in printing the HPD info
  drm/radeon/kms/pm: add mid profile
  drm/radeon/kms/pm: Misc fixes
  drm/radeon/kms/combios: fix typo in voltage fix
  drm/radeon/kms/evergreen: set accel_enabled
  drm/vmwgfx: return -EFAULT for copy_to_user errors
  drm/drm_crtc: return -EFAULT on copy_to_user errors
  drm/fb: use printk to print out the switching to text mode error.
  ...

If a filesystem writes more than one page in ->writepage, write_cache_pages
fails to notice this and continues to attempt writeback when wbc->nr_to_write
has gone negative - this trace was captured from XFS:

    wbc_writeback_start: towrt=1024
    wbc_writepage: towrt=1024
    wbc_writepage: towrt=0
    wbc_writepage: towrt=-1
    wbc_writepage: towrt=-5
    wbc_writepage: towrt=-21
    wbc_writepage: towrt=-85

This has adverse effects on filesystem writeback behaviour. write_cache_pages()
needs to terminate after a certain number of pages are written, not after a
certain number of calls to ->writepage are made.  This is a regression
introduced by 17bc6c30cf6bfffd816bdc53682dd46fc34a2cf4 ("vfs: Add
no_nrwrite_index_update writeback control flag"), but cannot be reverted
directly due to subsequent bug fixes that have gone in on top of it.

Signed-off-by: Dave Chinner <dchinner@redhat.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

BUG: unable to handle kernel NULL pointer dereference at
	0000000000000006
IP: [<ffffffff8107bd37>] ftrace_raw_event_signal_generate+0x87/0x140

TP_STORE_SIGINFO() forgets about SEND_SIG_FORCED, fix.

We should probably export is_si_special() and change TP_STORE_SIGINFO()
to use it in the longer term.

Signed-off-by: Oleg Nesterov <oleg@redhat.com>
Acked-by: Roland McGrath <roland@redhat.com>
Cc: Steven Rostedt <rostedt@goodmis.org>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Jason Baron <jbaron@redhat.com>
Cc: Masami Hiramatsu <mhiramat@redhat.com>
Cc: 2.6.33.x-2.6.34.x <stable@kernel.org>
LKML-Reference: <20100603213409.GA8307@redhat.com>
Signed-off-by: Frederic Weisbecker <fweisbec@gmail.com>

This is needed to enable accel in the ddx.  However,
due to a bug in older versions of the ddx, it relies
on accel being disabled in order to load properly on
evergreen chips.  To maintain compatility, we add a new
get accel param and call that from the ddx.  The old one
always returns false for evergreen cards.

[this fixes a regression with older userspaces on newer kernels].

Signed-off-by: Alex Deucher <alexdeucher@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>

JMB362 is a new variant of jmicron controller which is similar to
JMB360 but has two SATA ports instead of one.  As there is no PATA
port, single function AHCI mode can be used as in JMB360.  Add pci
quirk for JMB362.

Signed-off-by: Tejun Heo <tj@kernel.org>
Reported-by: Aries Lee <arieslee@jmicron.com>
Cc: stable@kernel.org
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (30 commits)
  X25: remove duplicated #include
  tcp: use correct net ns in cookie_v4_check()
  rps: tcp: fix rps_sock_flow_table table updates
  ppp_generic: fix multilink fragment sizes
  syncookies: remove Kconfig text line about disabled-by-default
  ixgbe: only check pfc bits in hang logic if pfc is enabled
  net: check for refcount if pop a stacked dst_entry
  ixgbe: return IXGBE_ERR_RAR_INDEX when out of range
  act_pedit: access skb->data safely
  sfc: Store port number in net_device::dev_id
  epic100: Test __BIG_ENDIAN instead of (non-existent) CONFIG_BIG_ENDIAN
  tehuti: return -EFAULT on copy_to_user errors
  isdn/kcapi: return -EFAULT on copy_from_user errors
  e1000e: change logical negate to bitwise
  sfc: Get port number from CS_PORT_NUM, not PCI function number
  cls_u32: use skb_header_pointer() to dereference data safely
  TCP: tcp_hybla: Fix integer overflow in slow start increment
  act_nat: fix the wrong checksum when addr isn't in old_addr/mask
  net/fec: fix pm to survive to suspend/resume
  korina: count RX DMA OVR as rx_fifo_error
  ...