Pull time namespace fix from Thomas Gleixner:
 "An update for the proc interface of time namespaces: Use symbolic
  names instead of clockid numbers. The usability nuisance of numbers
  was noticed by Michael when polishing the man page"

* tag 'timers-urgent-2020-04-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  proc, time/namespace: Show clock symbolic names in /proc/pid/timens_offsets

Pull irq fixes from Thomas Gleixner:
 "A set of fixes/updates for the interrupt subsystem:

   - Remove setup_irq() and remove_irq(). All users have been converted
     so remove them before new users surface.

   - A set of bugfixes for various interrupt chip drivers

   - Add a few missing static attributes to address sparse warnings"

* tag 'irq-urgent-2020-04-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  irqchip/irq-bcm7038-l1: Make bcm7038_l1_of_init() static
  irqchip/irq-mvebu-icu: Make legacy_bindings static
  irqchip/meson-gpio: Fix HARDIRQ-safe -> HARDIRQ-unsafe lock order
  irqchip/sifive-plic: Fix maximum priority threshold value
  irqchip/ti-sci-inta: Fix processing of masked irqs
  irqchip/mbigen: Free msi_desc on device teardown
  irqchip/gic-v4.1: Update effective affinity of virtual SGIs
  irqchip/gic-v4.1: Add support for VPENDBASER's Dirty+Valid signaling
  genirq: Remove setup_irq() and remove_irq()

Pull scheduler fixes from Thomas Gleixner:
 "Two fixes for the scheduler:

   - Work around an uninitialized variable warning where GCC can't
     figure it out.

   - Allow 'isolcpus=' to skip unknown subparameters so that older
     kernels work with the commandline of a newer kernel. Improve the
     error output while at it"

* tag 'sched-urgent-2020-04-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  sched/vtime: Work around an unitialized variable warning
  sched/isolation: Allow "isolcpus=" to skip unknown sub-parameters

Pull RCU fix from Thomas Gleixner:
 "A single bugfix for RCU to prevent taking a lock in NMI context"

* tag 'core-urgent-2020-04-19' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  rcu: Don't acquire lock in NMI handler in rcu_nmi_enter_common()

Pull thread fixes from Christian Brauner:
 "A few fixes and minor improvements:

   - Correctly validate the cgroup file descriptor when clone3() is used
     with CLONE_INTO_CGROUP.

   - Check that a new enough version of struct clone_args is passed
     which supports the cgroup file descriptor argument when
     CLONE_INTO_CGROUP is set in the flags argument.

   - Catch nonsensical struct clone_args layouts at build time.

   - Catch extensions of struct clone_args without updating the uapi
     visible size definitions at build time.

   - Check whether the signal is valid early in kill_pid_usb_asyncio()
     before doing further work.

   - Replace open-coded rcu_read_lock()+kill_pid_info()+rcu_read_unlock()
     sequence in kill_something_info() with kill_proc_info() which is a
     dedicated helper to do just that"

* tag 'for-linus-2020-04-18' of git://git.kernel.org/pub/scm/linux/kernel/git/brauner/linux:
  clone3: add build-time CLONE_ARGS_SIZE_VER* validity checks
  clone3: add a check for the user struct size if CLONE_INTO_CGROUP is set
  clone3: fix cgroup argument sanity check
  signal: use kill_proc_info instead of kill_pid_info in kill_something_info
  signal: check sig before setting info in kill_pid_usb_asyncio

Pull networking fixes from David Miller:

 1) Disable RISCV BPF JIT builds when !MMU, from Björn Töpel.

 2) nf_tables leaves dangling pointer after free, fix from Eric Dumazet.

 3) Out of boundary write in __xsk_rcv_memcpy(), fix from Li RongQing.

 4) Adjust icmp6 message source address selection when routes have a
    preferred source address set, from Tim Stallard.

 5) Be sure to validate HSR protocol version when creating new links,
    from Taehee Yoo.

 6) CAP_NET_ADMIN should be sufficient to manage l2tp tunnels even in
    non-initial namespaces, from Michael Weiß.

 7) Missing release firmware call in mlx5, from Eran Ben Elisha.

 8) Fix variable type in macsec_changelink(), caught by KASAN. Fix from
    Taehee Yoo.

 9) Fix pause frame negotiation in marvell phy driver, from Clemens
    Gruber.

10) Record RX queue early enough in tun packet paths such that XDP
    programs will see the correct RX queue index, from Gilberto Bertin.

11) Fix double unlock in mptcp, from Florian Westphal.

12) Fix offset overflow in ARM bpf JIT, from Luke Nelson.

13) marvell10g needs to soft reset PHY when coming out of low power
    mode, from Russell King.

14) Fix MTU setting regression in stmmac for some chip types, from
    Florian Fainelli.

* git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (101 commits)
  amd-xgbe: Use __napi_schedule() in BH context
  mISDN: make dmril and dmrim static
  net: stmmac: dwmac-sunxi: Provide TX and RX fifo sizes
  net: dsa: mt7530: fix tagged frames pass-through in VLAN-unaware mode
  tipc: fix incorrect increasing of link window
  Documentation: Fix tcp_challenge_ack_limit default value
  net: tulip: make early_486_chipsets static
  dt-bindings: net: ethernet-phy: add desciption for ethernet-phy-id1234.d400
  ipv6: remove redundant assignment to variable err
  net/rds: Use ERR_PTR for rds_message_alloc_sgs()
  net: mscc: ocelot: fix untagged packet drops when enslaving to vlan aware bridge
  selftests/bpf: Check for correct program attach/detach in xdp_attach test
  libbpf: Fix type of old_fd in bpf_xdp_set_link_opts
  libbpf: Always specify expected_attach_type on program load if supported
  xsk: Add missing check on user supplied headroom size
  mac80211: fix channel switch trigger from unknown mesh peer
  mac80211: fix race in ieee80211_register_hw()
  net: marvell10g: soft-reset the PHY when coming out of low power
  net: marvell10g: report firmware version
  net/cxgb4: Check the return from t4_query_params properly
  ...

Michael Kerrisk suggested to replace numeric clock IDs with symbolic names.

Now the content of these files looks like this:
$ cat /proc/774/timens_offsets
monotonic      864000         0
boottime      1728000         0

For setting offsets, both representations of clocks (numeric and symbolic)
can be used.

As for compatibility, it is acceptable to change things as long as
userspace doesn't care. The format of timens_offsets files is very new and
there are no userspace tools yet which rely on this format.

But three projects crun, util-linux and criu rely on the interface of
setting time offsets and this is why it's required to continue supporting
the numeric clock IDs on write.

Fixes: 04a8682a71be ("fs/proc: Introduce /proc/pid/timens_offsets")
Suggested-by: Michael Kerrisk <mtk.manpages@gmail.com>
Signed-off-by: Andrei Vagin <avagin@gmail.com>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Tested-by: Michael Kerrisk <mtk.manpages@gmail.com>
Acked-by: Michael Kerrisk <mtk.manpages@gmail.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Eric W. Biederman <ebiederm@xmission.com>
Cc: Dmitry Safonov <0x7f454c46@gmail.com>
Cc: stable@vger.kernel.org
Link: https://lkml.kernel.org/r/20200411154031.642557-1-avagin@gmail.com

Work around this warning:

  kernel/sched/cputime.c: In function ‘kcpustat_field’:
  kernel/sched/cputime.c:1007:6: warning: ‘val’ may be used uninitialized in this function [-Wmaybe-uninitialized]

because GCC can't see that val is used only when err is 0.

Acked-by: Peter Zijlstra <peterz@infradead.org>
Signed-off-by: Borislav Petkov <bp@suse.de>
Signed-off-by: Ingo Molnar <mingo@kernel.org>
Link: https://lore.kernel.org/r/20200327214334.GF8015@zn.tnic

The "isolcpus=" parameter allows sub-parameters before the cpulist is
specified, and if the parser detects an unknown sub-parameters the whole
parameter will be ignored.

This design is incompatible with itself when new sub-parameters are added.
An older kernel will not recognize the new sub-parameter and will
invalidate the whole parameter so the CPU isolation will not take
effect. It emits a warning:

    isolcpus: Error, unknown flag

The better and compatible way is to allow "isolcpus=" to skip unknown
sub-parameters, so that even if new sub-parameters are added an older
kernel will still be able to behave as usual even if with the new
sub-parameter specified on the command line.

Ideally this should have been there when the first sub-parameter for
"isolcpus=" was introduced.

Suggested-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Peter Xu <peterx@redhat.com>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Link: https://lkml.kernel.org/r/20200403223517.406353-1-peterx@redhat.com

CLONE_ARGS_SIZE_VER* macros are defined explicitly and not via
the offsets of the relevant struct clone_args fields, which makes
it rather error-prone, so it probably makes sense to add some
compile-time checks for them (including the one that breaks
on struct clone_args extension as a reminder to add a relevant
size macro and a similar check).  Function copy_clone_args_from_user
seems to be a good place for such checks.

Signed-off-by: Eugene Syromiatnikov <esyr@redhat.com>
Acked-by: Christian Brauner <christian.brauner@ubuntu.com>
Link: https://lore.kernel.org/r/20200412202658.GA31499@asgard.redhat.com
Signed-off-by: Christian Brauner <christian.brauner@ubuntu.com>