linux-toradex.git/mm/filemap.c, branch v3.14.23

mm/filemap.c: avoid always dirtying mapping->flags on O_DIRECT

2014-10-09T19:21:29+00:00

commit 7fcbbaf18392f0b17c95e2f033c8ccf87eecde1d upstream.

In some testing I ran today (some fio jobs that spread over two nodes),
we end up spending 40% of the time in filemap_check_errors().  That
smells fishy.  Looking further, this is basically what happens:

blkdev_aio_read()
    generic_file_aio_read()
        filemap_write_and_wait_range()
            if (!mapping->nr_pages)
                filemap_check_errors()

and filemap_check_errors() always attempts two test_and_clear_bit() on
the mapping flags, thus dirtying it for every single invocation.  The
patch below tests each of these bits before clearing them, avoiding this
issue.  In my test case (4-socket box), performance went from 1.7M IOPS
to 4.0M IOPS.

Signed-off-by: Jens Axboe 
Acked-by: Jeff Moyer 
Cc: Al Viro 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds 
Signed-off-by: Mel Gorman 
Signed-off-by: Greg Kroah-Hartman

mm: optimize put_mems_allowed() usage

2014-10-09T19:21:28+00:00

commit d26914d11751b23ca2e8747725f2cae10c2f2c1b upstream.

Since put_mems_allowed() is strictly optional, its a seqcount retry, we
don't need to evaluate the function if the allocation was in fact
successful, saving a smp_rmb some loads and comparisons on some relative
fast-paths.

Since the naming, get/put_mems_allowed() does suggest a mandatory
pairing, rename the interface, as suggested by Mel, to resemble the
seqcount interface.

This gives us: read_mems_allowed_begin() and read_mems_allowed_retry(),
where it is important to note that the return value of the latter call
is inverted from its previous incarnation.

Signed-off-by: Peter Zijlstra 
Signed-off-by: Mel Gorman 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds 
Signed-off-by: Mel Gorman 
Signed-off-by: Greg Kroah-Hartman

fix O_SYNC|O_APPEND syncing the wrong range on write()

2014-02-09T20:18:09+00:00

It actually goes back to 2004 ([PATCH] Concurrent O_SYNC write support)
when sync_page_range() had been introduced; generic_file_write{,v}() correctly
synced
	pos_after_write - written .. pos_after_write - 1
but generic_file_aio_write() synced
	pos_before_write .. pos_before_write + written - 1
instead.  Which is not the same thing with O_APPEND, obviously.
A couple of years later correct variant had been killed off when
everything switched to use of generic_file_aio_write().

All users of generic_file_aio_write() are affected, and the same bug
has been copied into other instances of ->aio_write().

The fix is trivial; the only subtle point is that generic_write_sync()
ought to be inlined to avoid calculations useless for the majority of
calls.

Signed-off-by: Al Viro

Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs

2014-01-28T16:38:04+00:00

Pull vfs updates from Al Viro:
 "Assorted stuff; the biggest pile here is Christoph's ACL series.  Plus
  assorted cleanups and fixes all over the place...

  There will be another pile later this week"

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/vfs: (43 commits)
  __dentry_path() fixes
  vfs: Remove second variable named error in __dentry_path
  vfs: Is mounted should be testing mnt_ns for NULL or error.
  Fix race when checking i_size on direct i/o read
  hfsplus: remove can_set_xattr
  nfsd: use get_acl and ->set_acl
  fs: remove generic_acl
  nfs: use generic posix ACL infrastructure for v3 Posix ACLs
  gfs2: use generic posix ACL infrastructure
  jfs: use generic posix ACL infrastructure
  xfs: use generic posix ACL infrastructure
  reiserfs: use generic posix ACL infrastructure
  ocfs2: use generic posix ACL infrastructure
  jffs2: use generic posix ACL infrastructure
  hfsplus: use generic posix ACL infrastructure
  f2fs: use generic posix ACL infrastructure
  ext2/3/4: use generic posix ACL infrastructure
  btrfs: use generic posix ACL infrastructure
  fs: make posix_acl_create more useful
  fs: make posix_acl_chmod more useful
  ...

Fix race when checking i_size on direct i/o read

2014-01-26T13:26:42+00:00

So far I've had one ACK for this, and no other comments. So I think it
is probably time to send this via some suitable tree. I'm guessing that
the vfs tree would be the most appropriate route, but not sure that
there is one at the moment (don't see anything recent at kernel.org)
so in that case I think -mm is the "back up plan". Al, please let me
know if you will take this?

Steve.

---------------------

Following on from the "Re: [PATCH v3] vfs: fix a bug when we do some dio
reads with append dio writes" thread on linux-fsdevel, this patch is my
current version of the fix proposed as option (b) in that thread.

Removing the i_size test from the direct i/o read path at vfs level
means that filesystems now have to deal with requests which are beyond
i_size themselves. These I've divided into three sets:

 a) Those with "no op" ->direct_IO (9p, cifs, ceph)
These are obviously not going to be an issue

 b) Those with "home brew" ->direct_IO (nfs, fuse)
I've been told that NFS should not have any problem with the larger
i_size, however I've added an extra test to FUSE to duplicate the
original behaviour just to be on the safe side.

 c) Those using __blockdev_direct_IO()
These call through to ->get_block() which should deal with the EOF
condition correctly. I've verified that with GFS2 and I believe that
Zheng has verified it for ext4. I've also run the test on XFS and it
passes both before and after this change.

The part of the patch in filemap.c looks a lot larger than it really is
- there are only two lines of real change. The rest is just indentation
of the contained code.

There remains a test of i_size though, which was added for btrfs. It
doesn't cause the other filesystems a problem as the test is performed
after ->direct_IO has been called. It is possible that there is a race
that does matter to btrfs, however this patch doesn't change that, so
its still an overall improvement.

Signed-off-by: Steven Whitehouse 
Reported-by: Zheng Liu 
Cc: Jan Kara 
Cc: Dave Chinner 
Acked-by: Miklos Szeredi 
Cc: Chris Mason 
Cc: Josef Bacik 
Cc: Christoph Hellwig 
Cc: Alexander Viro 
Signed-off-by: Al Viro

mm: dump page when hitting a VM_BUG_ON using VM_BUG_ON_PAGE

2014-01-24T00:36:50+00:00

Most of the VM_BUG_ON assertions are performed on a page.  Usually, when
one of these assertions fails we'll get a BUG_ON with a call stack and
the registers.

I've recently noticed based on the requests to add a small piece of code
that dumps the page to various VM_BUG_ON sites that the page dump is
quite useful to people debugging issues in mm.

This patch adds a VM_BUG_ON_PAGE(cond, page) which beyond doing what
VM_BUG_ON() does, also dumps the page before executing the actual
BUG_ON.

[akpm@linux-foundation.org: fix up includes]
Signed-off-by: Sasha Levin 
Cc: "Kirill A. Shutemov" 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: drop actor argument of do_generic_file_read()

2013-11-15T00:32:13+00:00

There's only one caller of do_generic_file_read() and the only actor is
file_read_actor().  No reason to have a callback parameter.

Signed-off-by: Kirill A. Shutemov 
Acked-by: Dave Hansen 
Reviewed-by: Wanpeng Li 
Cc: Matthew Wilcox 
Cc: Hugh Dickins 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: memcg: handle non-error OOM situations more gracefully

2013-10-17T04:35:53+00:00

Commit 3812c8c8f395 ("mm: memcg: do not trap chargers with full
callstack on OOM") assumed that only a few places that can trigger a
memcg OOM situation do not return VM_FAULT_OOM, like optional page cache
readahead.  But there are many more and it's impractical to annotate
them all.

First of all, we don't want to invoke the OOM killer when the failed
allocation is gracefully handled, so defer the actual kill to the end of
the fault handling as well.  This simplifies the code quite a bit for
added bonus.

Second, since a failed allocation might not be the abrupt end of the
fault, the memcg OOM handler needs to be re-entrant until the fault
finishes for subsequent allocation attempts.  If an allocation is
attempted after the task already OOMed, allow it to bypass the limit so
that it can quickly finish the fault and invoke the OOM killer.

Reported-by: azurIt 
Signed-off-by: Johannes Weiner 
Cc: Michal Hocko 
Cc: 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: cleanup add_to_page_cache_locked()

2013-09-12T22:38:03+00:00

Make add_to_page_cache_locked() cleaner:

 - unindent most code of the function by inverting one condition;
 - streamline code no-error path;
 - move insert error path outside normal code path;
 - call radix_tree_preload_end() earlier;

No functional changes.

Signed-off-by: Kirill A. Shutemov 
Acked-by: Dave Hansen 
Cc: Andrea Arcangeli 
Cc: Al Viro 
Cc: Hugh Dickins 
Cc: Wu Fengguang 
Cc: Jan Kara 
Cc: Mel Gorman 
Cc: Andi Kleen 
Cc: Matthew Wilcox 
Cc: Hillf Danton 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

mm: memcg: enable memcg OOM killer only for user faults

2013-09-12T22:38:01+00:00

System calls and kernel faults (uaccess, gup) can handle an out of memory
situation gracefully and just return -ENOMEM.

Enable the memcg OOM killer only for user faults, where it's really the
only option available.

Signed-off-by: Johannes Weiner 
Acked-by: Michal Hocko 
Cc: David Rientjes 
Cc: KAMEZAWA Hiroyuki 
Cc: azurIt 
Cc: KOSAKI Motohiro 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds