linux-toradex.git/net/ipv6, branch v5.0-rc6

sit: check if IPv6 enabled before calling ip6_err_gen_icmpv6_unreach()

2019-02-07T18:48:42+00:00

If we disabled IPv6 from the kernel command line (ipv6.disable=1), we should
not call ip6_err_gen_icmpv6_unreach(). This:

  ip link add sit1 type sit local 192.0.2.1 remote 192.0.2.2 ttl 1
  ip link set sit1 up
  ip addr add 198.51.100.1/24 dev sit1
  ping 198.51.100.2

if IPv6 is disabled at boot time, will crash the kernel.

v2: there's no need to use in6_dev_get(), use __in6_dev_get() instead,
    as we only need to check that idev exists and we are under
    rcu_read_lock() (from netif_receive_skb_internal()).

Reported-by: Jianlin Shi 
Fixes: ca15a078bd90 ("sit: generate icmpv6 error when receiving icmpv4 error")
Cc: Oussama Ghorbel 
Signed-off-by: Hangbin Liu 
Reviewed-by: Stefano Brivio 
Signed-off-by: David S. Miller

netfilter: ipv6: Don't preserve original oif for loopback address

2019-02-05T13:10:33+00:00

Commit 508b09046c0f ("netfilter: ipv6: Preserve link scope traffic
original oif") made ip6_route_me_harder() keep the original oif for
link-local and multicast packets. However, it also affected packets
for the loopback address because it used rt6_need_strict().

REDIRECT rules in the OUTPUT chain rewrite the destination to loopback
address; thus its oif should not be preserved. This commit fixes the bug
that redirected local packets are being dropped. Actually the packet was
not exactly dropped; Instead it was sent out to the original oif rather
than lo. When a packet with daddr ::1 is sent to the router, it is
effectively dropped.

Fixes: 508b09046c0f ("netfilter: ipv6: Preserve link scope traffic original oif")
Signed-off-by: Eli Cooper 
Signed-off-by: Pablo Neira Ayuso

ipv6: sr: clear IP6CB(skb) on SRH ip4ip6 encapsulation

2019-01-30T22:06:12+00:00

skb->cb may contain data from previous layers (in an observed case
IPv4 with L3 Master Device). In the observed scenario, the data in
IPCB(skb)->frags was misinterpreted as IP6CB(skb)->frag_max_size,
eventually caused an unexpected IPv6 fragmentation in ip6_fragment()
through ip6_finish_output().

This patch clears IP6CB(skb), which potentially contains garbage data,
on the SRH ip4ip6 encapsulation.

Fixes: 32d99d0b6702 ("ipv6: sr: add support for ip4ip6 encapsulation")
Signed-off-by: Yohei Kanemaru 
Signed-off-by: David S. Miller

net: ip6_gre: always reports o_key to userspace

2019-01-30T22:00:02+00:00

As Erspan_v4, Erspan_v6 protocol relies on o_key to configure
session id header field. However TUNNEL_KEY bit is cleared in
ip6erspan_tunnel_xmit since ERSPAN protocol does not set the key field
of the external GRE header and so the configured o_key is not reported
to userspace. The issue can be triggered with the following reproducer:

$ip link add ip6erspan1 type ip6erspan local 2000::1 remote 2000::2 \
    key 1 seq erspan_ver 1
$ip link set ip6erspan1 up
ip -d link sh ip6erspan1

ip6erspan1@NONE:  mtu 1422 qdisc noop state DOWN mode DEFAULT
    link/ether ba:ff:09:24:c3:0e brd ff:ff:ff:ff:ff:ff promiscuity 0 minmtu 68 maxmtu 1500
    ip6erspan remote 2000::2 local 2000::1 encaplimit 4 flowlabel 0x00000 ikey 0.0.0.1 iseq oseq

Fix the issue adding TUNNEL_KEY bit to the o_flags parameter in
ip6gre_fill_info

Fixes: 5a963eb61b7c ("ip6_gre: Add ERSPAN native tunnel support")
Signed-off-by: Lorenzo Bianconi 
Signed-off-by: David S. Miller

ip6mr: Fix notifiers call on mroute_clean_tables()

2019-01-28T07:16:07+00:00

When the MC route socket is closed, mroute_clean_tables() is called to
cleanup existing routes. Mistakenly notifiers call was put on the cleanup
of the unresolved MC route entries cache.
In a case where the MC socket closes before an unresolved route expires,
the notifier call leads to a crash, caused by the driver trying to
increment a non initialized refcount_t object [1] and then when handling
is done, to decrement it [2]. This was detected by a test recently added in
commit 6d4efada3b82 ("selftests: forwarding: Add multicast routing test").

Fix that by putting notifiers call on the resolved entries traversal,
instead of on the unresolved entries traversal.

[1]

[  245.748967] refcount_t: increment on 0; use-after-free.
[  245.754829] WARNING: CPU: 3 PID: 3223 at lib/refcount.c:153 refcount_inc_checked+0x2b/0x30
...
[  245.802357] Hardware name: Mellanox Technologies Ltd. MSN2740/SA001237, BIOS 5.6.5 06/07/2016
[  245.811873] RIP: 0010:refcount_inc_checked+0x2b/0x30
...
[  245.907487] Call Trace:
[  245.910231]  mlxsw_sp_router_fib_event.cold.181+0x42/0x47 [mlxsw_spectrum]
[  245.917913]  notifier_call_chain+0x45/0x7
[  245.922484]  atomic_notifier_call_chain+0x15/0x20
[  245.927729]  call_fib_notifiers+0x15/0x30
[  245.932205]  mroute_clean_tables+0x372/0x3f
[  245.936971]  ip6mr_sk_done+0xb1/0xc0
[  245.940960]  ip6_mroute_setsockopt+0x1da/0x5f0
...

[2]

[  246.128487] refcount_t: underflow; use-after-free.
[  246.133859] WARNING: CPU: 0 PID: 7 at lib/refcount.c:187 refcount_sub_and_test_checked+0x4c/0x60
[  246.183521] Hardware name: Mellanox Technologies Ltd. MSN2740/SA001237, BIOS 5.6.5 06/07/2016
...
[  246.193062] Workqueue: mlxsw_core_ordered mlxsw_sp_router_fibmr_event_work [mlxsw_spectrum]
[  246.202394] RIP: 0010:refcount_sub_and_test_checked+0x4c/0x60
...
[  246.298889] Call Trace:
[  246.301617]  refcount_dec_and_test_checked+0x11/0x20
[  246.307170]  mlxsw_sp_router_fibmr_event_work.cold.196+0x47/0x78 [mlxsw_spectrum]
[  246.315531]  process_one_work+0x1fa/0x3f0
[  246.320005]  worker_thread+0x2f/0x3e0
[  246.324083]  kthread+0x118/0x130
[  246.327683]  ? wq_update_unbound_numa+0x1b0/0x1b0
[  246.332926]  ? kthread_park+0x80/0x80
[  246.337013]  ret_from_fork+0x1f/0x30

Fixes: 088aa3eec2ce ("ip6mr: Support fib notifications")
Signed-off-by: Nir Dotan 
Reviewed-by: Ido Schimmel 
Signed-off-by: David S. Miller

net/ipv6: lower the level of "link is not ready" messages

2019-01-23T04:42:39+00:00

This message gets logged far too often for how interesting is it.

Most distributions nowadays configure NetworkManager to use randomly
generated MAC addresses for Wi-Fi network scans. The interfaces end up
being periodically brought down for the address change. When they're
subsequently brought back up, the message is logged, eventually flooding
the log.

Perhaps the message is not all that helpful: it seems to be more
interesting to hear when the addrconf actually start, not when it does
not. Let's lower its level.

Signed-off-by: Lubomir Rintel 
Acked-By: Thomas Haller 
Signed-off-by: David S. Miller

net/ipv6: don't return positive numbers when nothing was dumped

2019-01-23T01:24:18+00:00

in6_dump_addrs() returns a positive 1 if there was nothing to dump.
This return value can not be passed as return from inet6_dump_addr()
as is, because it will confuse rtnetlink, resulting in NLMSG_DONE
never getting set:

$ ip addr list dev lo
EOF on netlink
Dump terminated

v2: flip condition to avoid a new goto (DaveA)

Fixes: 7c1e8a3817c5 ("netlink: fixup regression in RTM_GETADDR")
Reported-by: Brendan Galloway 
Signed-off-by: Jakub Kicinski 
Reviewed-by: David Ahern 
Tested-by: David Ahern 
Signed-off-by: David S. Miller

net: ip_gre: use erspan key field for tunnel lookup

2019-01-22T19:52:17+00:00

Use ERSPAN key header field as tunnel key in gre_parse_header routine
since ERSPAN protocol sets the key field of the external GRE header to
0 resulting in a tunnel lookup fail in ip6gre_err.
In addition remove key field parsing and pskb_may_pull check in
erspan_rcv and ip6erspan_rcv

Fixes: 5a963eb61b7c ("ip6_gre: Add ERSPAN native tunnel support")
Signed-off-by: Lorenzo Bianconi 
Signed-off-by: David S. Miller

udp6: add missing rehash callback to udplite

2019-01-17T23:01:08+00:00

After commit 23b0269e58ae ("net: udp6: prefer listeners bound to an
address"), UDP-Lite only works when specifying a local address for
the sockets.

This is related to the problem addressed in the commit 719f835853a9
("udp: add rehash on connect()"). Moreover, __udp6_lib_lookup() now
looks for a socket immediately in the secondary hash table.

And this issue was found with LTP/network tests as well.

Fixes: 23b0269e58ae ("net: udp6: prefer listeners bound to an address")
Signed-off-by: Alexey Kodanev 
Reviewed-by: Eric Dumazet 
Signed-off-by: David S. Miller

udp: with udp_segment release on error path

2019-01-16T23:48:11+00:00

Failure __ip_append_data triggers udp_flush_pending_frames, but these
tests happen later. The skb must be freed directly.

Fixes: bec1f6f697362 ("udp: generate gso with UDP_SEGMENT")
Reported-by: Eric Dumazet 
Signed-off-by: Willem de Bruijn 
Signed-off-by: David S. Miller