In a very similar spirit to commit c470bdc1aaf3 ("mac80211: don't WARN
on bad WMM parameters from buggy APs"), an AP may not transmit a
fully-formed WMM IE. For example, it may miss or repeat an Access
Category. The above loop won't catch that and will instead leave one of
the four ACs zeroed out. This triggers the following warning in
drv_conf_tx()
wlan0: invalid CW_min/CW_max: 0/0
and it may leave one of the hardware queues unconfigured. If we detect
such a case, let's just print a warning and fall back to the defaults.
Tested with a hacked version of hostapd, intentionally corrupting the
IEs in hostapd_eid_wmm().
Cc: stable@vger.kernel.org
Signed-off-by: Brian Norris <briannorris@chromium.org>
Link: https://lore.kernel.org/r/20190726224758.210953-1-briannorris@chromium.org
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Pull networking updates from David Miller:
"Some highlights from this development cycle:
1) Big refactoring of ipv6 route and neigh handling to support
nexthop objects configurable as units from userspace. From David
Ahern.
2) Convert explored_states in BPF verifier into a hash table,
significantly decreased state held for programs with bpf2bpf
calls, from Alexei Starovoitov.
3) Implement bpf_send_signal() helper, from Yonghong Song.
4) Various classifier enhancements to mvpp2 driver, from Maxime
Chevallier.
5) Add aRFS support to hns3 driver, from Jian Shen.
6) Fix use after free in inet frags by allocating fqdirs dynamically
and reworking how rhashtable dismantle occurs, from Eric Dumazet.
7) Add act_ctinfo packet classifier action, from Kevin
Darbyshire-Bryant.
8) Add TFO key backup infrastructure, from Jason Baron.
9) Remove several old and unused ISDN drivers, from Arnd Bergmann.
10) Add devlink notifications for flash update status to mlxsw driver,
from Jiri Pirko.
11) Lots of kTLS offload infrastructure fixes, from Jakub Kicinski.
12) Add support for mv88e6250 DSA chips, from Rasmus Villemoes.
13) Various enhancements to ipv6 flow label handling, from Eric
Dumazet and Willem de Bruijn.
14) Support TLS offload in nfp driver, from Jakub Kicinski, Dirk van
der Merwe, and others.
15) Various improvements to axienet driver including converting it to
phylink, from Robert Hancock.
16) Add PTP support to sja1105 DSA driver, from Vladimir Oltean.
17) Add mqprio qdisc offload support to dpaa2-eth, from Ioana
Radulescu.
18) Add devlink health reporting to mlx5, from Moshe Shemesh.
19) Convert stmmac over to phylink, from Jose Abreu.
20) Add PTP PHC (Physical Hardware Clock) support to mlxsw, from
Shalom Toledo.
21) Add nftables SYNPROXY support, from Fernando Fernandez Mancera.
22) Convert tcp_fastopen over to use SipHash, from Ard Biesheuvel.
23) Track spill/fill of constants in BPF verifier, from Alexei
Starovoitov.
24) Support bounded loops in BPF, from Alexei Starovoitov.
25) Various page_pool API fixes and improvements, from Jesper Dangaard
Brouer.
26) Just like ipv4, support ref-countless ipv6 route handling. From
Wei Wang.
27) Support VLAN offloading in aquantia driver, from Igor Russkikh.
28) Add AF_XDP zero-copy support to mlx5, from Maxim Mikityanskiy.
29) Add flower GRE encap/decap support to nfp driver, from Pieter
Jansen van Vuuren.
30) Protect against stack overflow when using act_mirred, from John
Hurley.
31) Allow devmap map lookups from eBPF, from Toke Høiland-Jørgensen.
32) Use page_pool API in netsec driver, Ilias Apalodimas.
33) Add Google gve network driver, from Catherine Sullivan.
34) More indirect call avoidance, from Paolo Abeni.
35) Add kTLS TX HW offload support to mlx5, from Tariq Toukan.
36) Add XDP_REDIRECT support to bnxt_en, from Andy Gospodarek.
37) Add MPLS manipulation actions to TC, from John Hurley.
38) Add sending a packet to connection tracking from TC actions, and
then allow flower classifier matching on conntrack state. From
Paul Blakey.
39) Netfilter hw offload support, from Pablo Neira Ayuso"
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (2080 commits)
net/mlx5e: Return in default case statement in tx_post_resync_params
mlx5: Return -EINVAL when WARN_ON_ONCE triggers in mlx5e_tls_resync().
net: dsa: add support for BRIDGE_MROUTER attribute
pkt_sched: Include const.h
net: netsec: remove static declaration for netsec_set_tx_de()
net: netsec: remove superfluous if statement
netfilter: nf_tables: add hardware offload support
net: flow_offload: rename tc_cls_flower_offload to flow_cls_offload
net: flow_offload: add flow_block_cb_is_busy() and use it
net: sched: remove tcf block API
drivers: net: use flow block API
net: sched: use flow block API
net: flow_offload: add flow_block_cb_{priv, incref, decref}()
net: flow_offload: add list handling functions
net: flow_offload: add flow_block_cb_alloc() and flow_block_cb_free()
net: flow_offload: rename TCF_BLOCK_BINDER_TYPE_* to FLOW_BLOCK_BINDER_TYPE_*
net: flow_offload: rename TC_BLOCK_{UN}BIND to FLOW_BLOCK_{UN}BIND
net: flow_offload: add flow_block_cb_setup_simple()
net: hisilicon: Add an tx_desc to adapt HI13X1_GMAC
net: hisilicon: Add an rx_desc to adapt HI13X1_GMAC
...
Pull crypto updates from Herbert Xu: "Here is the crypto update for 5.3: API: - Test shash interface directly in testmgr - cra_driver_name is now mandatory Algorithms: - Replace arc4 crypto_cipher with library helper - Implement 5 way interleave for ECB, CBC and CTR on arm64 - Add xxhash - Add continuous self-test on noise source to drbg - Update jitter RNG Drivers: - Add support for SHA204A random number generator - Add support for 7211 in iproc-rng200 - Fix fuzz test failures in inside-secure - Fix fuzz test failures in talitos - Fix fuzz test failures in qat" * 'linus' of git://git.kernel.org/pub/scm/linux/kernel/git/herbert/crypto-2.6: (143 commits) crypto: stm32/hash - remove interruptible condition for dma crypto: stm32/hash - Fix hmac issue more than 256 bytes crypto: stm32/crc32 - rename driver file crypto: amcc - remove memset after dma_alloc_coherent crypto: ccp - Switch to SPDX license identifiers crypto: ccp - Validate the the error value used to index error messages crypto: doc - Fix formatting of new crypto engine content crypto: doc - Add parameter documentation crypto: arm64/aes-ce - implement 5 way interleave for ECB, CBC and CTR crypto: arm64/aes-ce - add 5 way interleave routines crypto: talitos - drop icv_ool crypto: talitos - fix hash on SEC1. crypto: talitos - move struct talitos_edesc into talitos.h lib/scatterlist: Fix mapping iterator when sg->offset is greater than PAGE_SIZE crypto/NX: Set receive window credits to max number of CRBs in RxFIFO crypto: asymmetric_keys - select CRYPTO_HASH where needed crypto: serpent - mark __serpent_setkey_sbox noinline crypto: testmgr - dynamically allocate crypto_shash crypto: testmgr - dynamically allocate testvec_config crypto: talitos - eliminate unneeded 'done' functions at build time ...
Minor SPDX change conflict. Signed-off-by: David S. Miller <davem@davemloft.net>
Pull still more SPDX updates from Greg KH: "Another round of SPDX updates for 5.2-rc6 Here is what I am guessing is going to be the last "big" SPDX update for 5.2. It contains all of the remaining GPLv2 and GPLv2+ updates that were "easy" to determine by pattern matching. The ones after this are going to be a bit more difficult and the people on the spdx list will be discussing them on a case-by-case basis now. Another 5000+ files are fixed up, so our overall totals are: Files checked: 64545 Files with SPDX: 45529 Compared to the 5.1 kernel which was: Files checked: 63848 Files with SPDX: 22576 This is a huge improvement. Also, we deleted another 20000 lines of boilerplate license crud, always nice to see in a diffstat" * tag 'spdx-5.2-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/spdx: (65 commits) treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 507 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 506 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 505 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 504 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 503 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 502 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 501 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 500 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 499 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 498 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 497 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 496 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 495 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 491 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 490 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 489 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 488 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 487 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 486 treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 485 ...
The WEP code in the mac80211 subsystem currently uses the crypto API to access the arc4 (RC4) cipher, which is overly complicated, and doesn't really have an upside in this particular case, since ciphers are always synchronous and therefore always implemented in software. Given that we have no accelerated software implementations either, it is much more straightforward to invoke a generic library interface directly. Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org> Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Based on 2 normalized pattern(s): this program is free software you can redistribute it and or modify it under the terms of the gnu general public license version 2 as published by the free software foundation this program is free software you can redistribute it and or modify it under the terms of the gnu general public license version 2 as published by the free software foundation # extracted by the scancode license scanner the SPDX license identifier GPL-2.0-only has been chosen to replace the boilerplate/reference in 4122 file(s). Signed-off-by: Thomas Gleixner <tglx@linutronix.de> Reviewed-by: Enrico Weigelt <info@metux.net> Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org> Reviewed-by: Allison Randal <allison@lohutok.net> Cc: linux-spdx@vger.kernel.org Link: https://lkml.kernel.org/r/20190604081206.933168790@linutronix.de Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Honestly all the conflicts were simple overlapping changes, nothing really interesting to report. Signed-off-by: David S. Miller <davem@davemloft.net>
Even if we have a station, we currently call rate_control_send_low() with the NULL station unless further rate control (driver, minstrel) has been initialized. Change this so we can use more information about the station to use a better rate. For example, when we associate with an AP, we will now use the lowest rate it advertised as supported (that we can) rather than the lowest mandatory rate. This aligns our behaviour with most other 802.11 implementations. To make this possible, we need to also ensure that we have non-zero rates at all times, so in case we really have *nothing* pre-fill the supp_rates bitmap with the very lowest mandatory bitmap (11b and 11a on 2.4 and 5 GHz respectively). Additionally, hostapd appears to be giving us an empty supported rates bitmap (it can and should do better, since the STA must have supported for at least the basic rates in the BSS), so ignore any such bitmaps that would actually zero out the supp_rates, and in that case just keep the pre-filled mandatory rates. Signed-off-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Luca Coelho <luciano.coelho@intel.com> Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Turn TWT for STA interfaces when they associate and/or receive a beacon where the twt_responder bit has changed. Signed-off-by: Shashidhar Lakkavalli <slakkavalli@datto.com> Signed-off-by: John Crispin <john@phrozen.org> Signed-off-by: Johannes Berg <johannes.berg@intel.com>