linux-toradex.git/tools/testing/selftests/net/hsr, branch master

selftests: hsr: Add more link fault tests for HSR

2026-02-10T11:02:29+00:00

Run the packet loss and reordering tests also for both HSR versions. Now
they can be removed from the hsr_ping tests completely. The timeout needs
to be increased because there are 15 link fault test cases now, with each
of them taking 5-6sec for the test and at most 5sec for the HSR node tables
to get merged and we also want some room to make the test runs stable.

Signed-off-by: Felix Maurer 
Reviewed-by: Sebastian Andrzej Siewior 
Link: https://patch.msgid.link/eb6f667d3804ce63d86f0ee3fbc0e0ac9e1a209a.1770299429.git.fmaurer@redhat.com
Signed-off-by: Paolo Abeni

selftests: hsr: Add tests for more link faults with PRP

2026-02-10T11:02:29+00:00

Add tests where one link has different rates of packet loss or reorders
packets. PRP should still be able to recover from these link faults and
show no packet loss.  However, it is acceptable to receive some level of
duplicate packets. This matches the current specification (IEC
62439-3:2021) of the duplicate discard algorithm that requires it to be
"designed such that it never rejects a legitimate frame, while occasional
acceptance of a duplicate can be tolerated." The rate of acceptable
duplicates in this test is intentionally high (10%) to make the test
stable, the values I observed in the worst test cases (20% loss) are around
5% duplicates.

The duplicates occur because of the 10ms ping interval in the test. As
blocks expire after 400ms based on the timestamp of the first received
sequence number in the block, every approx. 40th will lead to a new, clean
block being used where the sequence number hasn't been seen before. As this
occurs on both nodes in the test (for requests and replies), we observe
around 20 duplicate frames.

Signed-off-by: Felix Maurer 
Reviewed-by: Sebastian Andrzej Siewior 
Link: https://patch.msgid.link/7b36506d3a80e53786fe56526cf6046c74dfeee1.1770299429.git.fmaurer@redhat.com
Signed-off-by: Paolo Abeni

selftests: hsr: Add tests for faulty links

2026-02-10T11:02:28+00:00

Add a test case that can support different types of faulty links for all
protocol versions (HSRv0, HSRv1, PRPv1). It starts with a baseline with
fully functional links. The first faulty case is one link being cut during
the ping. This test uses a different function for ping that sends more
packets in shorter intervals to stress the duplicate detection algorithms a
bit more and allow for future tests with other link faults (packet loss,
reordering, etc.).

As the link fault tests now cover the cut link for HSR and PRP, it can be
removed from the hsr_ping test. Note that the removed cut link test did not
really test the fault because do_ping_long takes about 1sec while the link
is only cut after a 3sec sleep.

Signed-off-by: Felix Maurer 
Reviewed-by: Sebastian Andrzej Siewior 
Link: https://patch.msgid.link/dad52276e2c349ecb96168bef7e3001bf7becc81.1770299429.git.fmaurer@redhat.com
Signed-off-by: Paolo Abeni

selftests: hsr: Check duplicates on HSR with VLAN

2026-02-10T11:02:28+00:00

Previously the hsr_ping test only checked that all nodes in a VLAN are
reachable (using do_ping). Update the test to also check that there is no
packet loss and no duplicate packets by running the same tests for VLANs as
without VLANs (including using do_ping_long). This also adds tests for IPv6
over VLAN. To unify the test code, the topology without VLANs now uses IP
addresses from dead:beef:0::/64 to align with the 100.64.0.0/24 range for
IPv4. Error messages are updated across the board to make it easier to find
what actually failed.

Also update the VLAN test to only run in VLAN 2, as there is no need to
check if ping really works with VLAN IDs 2, 3, 4, and 5. This lowers the
number of long ping tests on VLANs to keep the overall test runtime in
bounds.

It's still necessary to bump the test timeout a bit, though: a ping long
tests takes 1sec, do_ping_tests performs 12 of them, do_link_problem_tests
6, and the VLAN tests again 12. With some buffer for setup and waiting and
for two protocol versions, 90sec timeout seems reasonable.

Signed-off-by: Felix Maurer 
Reviewed-by: Sebastian Andrzej Siewior 
Link: https://patch.msgid.link/e3ded0e2547b5f720524b62fabeb96debc579697.1770299429.git.fmaurer@redhat.com
Signed-off-by: Paolo Abeni

selftests: hsr: Add ping test for PRP

2026-02-10T11:02:28+00:00

Add a selftest for PRP that performs a basic ping test on IPv4 and IPv6,
over the plain PRP interface and a VLAN interface, similar to the existing
ping test for HSR. The test first checks reachability of the other node,
then checks for no loss and no duplicates.

Signed-off-by: Felix Maurer 
Reviewed-by: Sebastian Andrzej Siewior 
Link: https://patch.msgid.link/4a342189e842d7308d037da72af566729ee75834.1770299429.git.fmaurer@redhat.com
Signed-off-by: Paolo Abeni

selftests: net: unify the Makefile formats

2025-10-06T20:14:06+00:00

We get a significant number of conflicts between net and net-next
because of selftests Makefile changes. People tend to append new
test cases at the end of the Makefile when there's no clear sort
order. Sort all networking selftests Makefiles, use the following
format:

 VAR_NAME := \
	 entry1 \
	 entry2 \
	 entry3 \
 # end of VAR_NAME

Some Makefiles are already pretty close to this.

Acked-by: Antonio Quartulli 
Acked-by: Matthieu Baerts (NGI0) 
Acked-by: Allison Henderson 
Reviewed-by: Petr Machata 
Link: https://patch.msgid.link/20251003210127.1021918-1-kuba@kernel.org
Signed-off-by: Jakub Kicinski

selftests: net: sort configs

2025-10-06T20:12:59+00:00

Sort config files for networking selftests. This should help us
avoid merge conflicts between net and net-next. patchwork check
will be added to prevent new issues.

Acked-by: Phil Sutter 
Acked-by: Matthieu Baerts (NGI0) 
Acked-by: Florian Westphal 
Acked-by: Antonio Quartulli 
Link: https://patch.msgid.link/20251003205736.1019673-1-kuba@kernel.org
Signed-off-by: Jakub Kicinski

selftests: hsr: Add test for VLAN

2024-11-12T00:40:44+00:00

Add test for VLAN ping for HSR. The test adds vlan interfaces to the hsr
interface and then verifies if ping to them works.

Signed-off-by: MD Danish Anwar 
Reviewed-by: Jiri Pirko 
Link: https://patch.msgid.link/20241106091710.3308519-5-danishanwar@ti.com
Signed-off-by: Jakub Kicinski

tests: hsr: Increase timeout to 50 seconds

2024-10-30T23:23:38+00:00

The HSR test, hsr_ping.sh, actually needs 7 min to run. Around 375s to
be exact, and even more on a debug kernel or kernel with other network
security limits. The timeout setting for the kselftest is currently 45
seconds, which is way too short to integrate hsr tests to run_kselftest
infrastructure. However, timeout of hundreds of seconds is quite a long
time, especially in a CI/CD environment. It seems that we need
accelerate the test and balance with timeout setting.

The most time-consuming func is do_ping_long, where ping command sends
10 packages to the given address. The default interval between two ping
packages is 1s according to the ping Mannual. There isn't any operation
between pings thus we could pass -i 0.1 to ping to make it 10 times
faster.

While even with this short interval, the test still need about 46.4
seconds to finish because of the two HSR interfaces, each of which is
tested by calling do_ping func 12 times and do_ping_long func 19 times
and sleep for 3s.

So, an explicit setting is also needed to slightly increase the
timeout. And to leave us some slack, use 50 as default timeout.

Signed-off-by: Yunshui Jiang 
Link: https://patch.msgid.link/20241028082757.2945232-1-jiangyunshui@kylinos.cn
Signed-off-by: Jakub Kicinski

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2024-06-06T19:06:56+00:00

Cross-merge networking fixes after downstream PR.

No conflicts.

Adjacent changes:

drivers/net/ethernet/pensando/ionic/ionic_txrx.c
  d9c04209990b ("ionic: Mark error paths in the data path as unlikely")
  491aee894a08 ("ionic: fix kernel panic in XDP_TX action")

net/ipv6/ip6_fib.c
  b4cb4a1391dc ("net: use unrcu_pointer() helper")
  b01e1c030770 ("ipv6: fix possible race in __fib6_drop_pcpu_from()")

Signed-off-by: Jakub Kicinski