arm64: dts: imx8mp-verdin-dev: Do not include dahlia dtsi

Follow the change that has been done on imx8mm-verdin-dev.dtsi and
remove the include from dahlia to be consistent. Put back all nodes that
previously had been included.

Upstream-Status: Submitted [https://lore.kernel.org/all/20230118105251.6035-3-dev@pschenker.ch/]
Signed-off-by: Philippe Schenker <philippe.schenker@toradex.com>

1 files changed, 123 insertions, 6 deletions

diff --git a/arch/arm64/boot/dts/freescale/imx8mp-verdin-dev.dtsi b/arch/arm64/boot/dts/freescale/imx8mp-verdin-dev.dtsi
index 5a330368bccf..f0fb7e16a4cd 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-verdin-dev.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mp-verdin-dev.dtsi
@@ -3,8 +3,6 @@
  * Copyright 2022 Toradex
  */
 
-#include "imx8mp-verdin-dahlia.dtsi"
-
 / {
 	reg_eth2phy: regulator-eth2phy {
 		compatible = "regulator-fixed";
@@ -54,18 +52,75 @@
 	};
 };
 
+&backlight {
+	power-supply = <&reg_3p3v>;
+};
+
+/* Verdin SPI_1 */
+&ecspi1 {
+	status = "okay";
+};
+
+/* EEPROM on display adapter boards */
+&eeprom_display_adapter {
+	status = "okay";
+};
+
+/* EEPROM on Verdin Development board */
+&eeprom_carrier_board {
+	status = "okay";
+};
+
+&eqos {
+	status = "okay";
+};
+
 &fec {
 	phy-supply = <&reg_eth2phy>;
 	status = "okay";
 };
 
+&flexcan1 {
+	status = "okay";
+};
+
+&flexcan2 {
+	status = "okay";
+};
+
+/* Verdin QSPI_1 */
+&flexspi {
+	status = "okay";
+};
+
 &gpio_expander_21 {
 	status = "okay";
 	vcc-supply = <&reg_1p8v>;
 };
 
+/* Current measurement into module VCC */
+&hwmon {
+	status = "okay";
+};
+
+&hwmon_temp {
+	vs-supply = <&reg_1p8v>;
+	status = "okay";
+};
+
+/* Verdin I2C_2_DSI */
+&i2c2 {
+	status = "okay";
+};
+
+&i2c3 {
+	status = "okay";
+};
+
 /* Verdin I2C_1 */
 &i2c4 {
+	status = "okay";
+
 	/* Audio Codec */
 	nau8822_1a: codec-nau@1a {
 		compatible = "nuvoton,nau8822";
@@ -76,18 +131,80 @@
 	};
 };
 
+/* TODO: Verdin PCIE_1 */
+
+/* Verdin PWM_1 */
+&pwm1 {
+	status = "okay";
+};
+
+/* Verdin PWM_2 */
+&pwm2 {
+	status = "okay";
+};
+
+/* Verdin PWM_3_DSI */
+&pwm3 {
+	status = "okay";
+};
+
+&reg_usdhc2_vmmc {
+	vin-supply = <&reg_3p3v>;
+};
+
+/* VERDIN I2S_1 */
+&sai1 {
+	#sound-dai-cells = <0>;
+	assigned-clocks = <&clk IMX8MP_CLK_SAI1>;
+	assigned-clock-parents = <&clk IMX8MP_AUDIO_PLL1_OUT>;
+	assigned-clock-rates = <24576000>;
+	fsl,sai-mclk-direction-output;
+	status = "okay";
+};
+
+&sdma2 {
+	status = "okay";
+};
+
 /* Verdin UART_1, connector X50 through RS485 transceiver */
 &uart1 {
 	linux,rs485-enabled-at-boot-time;
 	rs485-rts-active-low;
 	rs485-rx-during-tx;
+	status = "okay";
+};
+
+/* Verdin UART_2 */
+&uart2 {
+	status = "okay";
+};
+
+/* Verdin UART_3, used as the Linux Console */
+&uart3 {
+	status = "okay";
+};
+
+/* Verdin USB_1 */
+&usb3_0 {
+	status = "okay";
+};
+
+&usb3_phy0 {
+	status = "okay";
+};
+
+/* Verdin USB_2 */
+&usb3_1 {
+	fsl,permanently-attached;
+	status = "okay";
+};
+
+&usb3_phy1 {
+	status = "okay";
 };
 
 /* Limit frequency on dev board due to long traces and bad signal integrity */
 &usdhc2 {
 	max-frequency = <100000000>;
-};
-
-&wm8904_1a {
-	status = "disabled";
+	status = "okay";
 };