Merge tag 'for-linus-20151217' of git://git.infradead.org/linux-mtd

Pull MTD fixes from Brian Norris:
 "I was holding out on this pull request for a bit, since there are a
  few other small issues being discussed that look like 4.4-rc
  regressions.  Hopefully I can get those stabilized soon, but these are
  ready at any rate:

   - A little bit of a last-minute change for the device tree "fixed
     partition" binding.  This is needed because we might want to reuse
     the 'partitions' subnode for other sorts of partitioning
     descriptions -- e.g., for describing which on-flash partition
     format(s) might be used on the system.

   - Also tone down a warning message, since it is probably going to
     show up on a lot of systems where it should just be ignored"

* tag 'for-linus-20151217' of git://git.infradead.org/linux-mtd:
  doc: dt: mtd: partitions: add compatible property to "partitions" node
  mtd: ofpart: don't complain about missing 'partitions' node too loudly

1 files changed, 6 insertions, 1 deletions

diff --git a/Documentation/devicetree/bindings/mtd/partition.txt b/Documentation/devicetree/bindings/mtd/partition.txt
index f1e2a02381a4..1c63e40659fc 100644
--- a/Documentation/devicetree/bindings/mtd/partition.txt
+++ b/Documentation/devicetree/bindings/mtd/partition.txt
@@ -6,7 +6,9 @@ used for what purposes, but which don't use an on-flash partition table such
 as RedBoot.
 
 The partition table should be a subnode of the mtd node and should be named
-'partitions'. Partitions are defined in subnodes of the partitions node.
+'partitions'. This node should have the following property:
+- compatible : (required) must be "fixed-partitions"
+Partitions are then defined in subnodes of the partitions node.
 
 For backwards compatibility partitions as direct subnodes of the mtd device are
 supported. This use is discouraged.
@@ -36,6 +38,7 @@ Examples:
 
 flash@0 {
 	partitions {
+		compatible = "fixed-partitions";
 		#address-cells = <1>;
 		#size-cells = <1>;
 
@@ -53,6 +56,7 @@ flash@0 {
 
 flash@1 {
 	partitions {
+		compatible = "fixed-partitions";
 		#address-cells = <1>;
 		#size-cells = <2>;
 
@@ -66,6 +70,7 @@ flash@1 {
 
 flash@2 {
 	partitions {
+		compatible = "fixed-partitions";
 		#address-cells = <2>;
 		#size-cells = <2>;