powerpc: Remove legacy iSeries bits from assembly files

This removes the various bits of assembly in the kernel entry,
exception handling and SLB management code that were specific
to running under the legacy iSeries hypervisor which is no
longer supported.

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>

1 files changed, 7 insertions, 88 deletions

diff --git a/arch/powerpc/kernel/exceptions-64s.S b/arch/powerpc/kernel/exceptions-64s.S
index 15c5a4f6de01..fea8a69df4b2 100644
--- a/arch/powerpc/kernel/exceptions-64s.S
+++ b/arch/powerpc/kernel/exceptions-64s.S
@@ -19,7 +19,7 @@
  * We layout physical memory as follows:
  * 0x0000 - 0x00ff : Secondary processor spin code
  * 0x0100 - 0x2fff : pSeries Interrupt prologs
- * 0x3000 - 0x5fff : interrupt support, iSeries and common interrupt prologs
+ * 0x3000 - 0x5fff : interrupt support common interrupt prologs
  * 0x6000 - 0x6fff : Initial (CPU0) segment table
  * 0x7000 - 0x7fff : FWNMI data area
  * 0x8000 -        : Early init and support code
@@ -458,6 +458,7 @@ machine_check_common:
 	bl	.machine_check_exception
 	b	.ret_from_except
 
+	STD_EXCEPTION_COMMON_LITE(0x500, hardware_interrupt, do_IRQ)
 	STD_EXCEPTION_COMMON_LITE(0x900, decrementer, .timer_interrupt)
 	STD_EXCEPTION_COMMON(0xa00, trap_0a, .unknown_exception)
 	STD_EXCEPTION_COMMON(0xb00, trap_0b, .unknown_exception)
@@ -672,12 +673,6 @@ _GLOBAL(slb_miss_realmode)
 	ld	r10,PACA_EXSLB+EX_LR(r13)
 	ld	r3,PACA_EXSLB+EX_R3(r13)
 	lwz	r9,PACA_EXSLB+EX_CCR(r13)	/* get saved CR */
-#ifdef CONFIG_PPC_ISERIES
-BEGIN_FW_FTR_SECTION
-	ld	r11,PACALPPACAPTR(r13)
-	ld	r11,LPPACASRR0(r11)		/* get SRR0 value */
-END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
-#endif /* CONFIG_PPC_ISERIES */
 
 	mtlr	r10
 
@@ -690,12 +685,6 @@ END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
 	mtcrf	0x01,r9		/* slb_allocate uses cr0 and cr7 */
 .machine	pop
 
-#ifdef CONFIG_PPC_ISERIES
-BEGIN_FW_FTR_SECTION
-	mtspr	SPRN_SRR0,r11
-	mtspr	SPRN_SRR1,r12
-END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
-#endif /* CONFIG_PPC_ISERIES */
 	ld	r9,PACA_EXSLB+EX_R9(r13)
 	ld	r10,PACA_EXSLB+EX_R10(r13)
 	ld	r11,PACA_EXSLB+EX_R11(r13)
@@ -704,13 +693,7 @@ END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
 	rfid
 	b	.	/* prevent speculative execution */
 
-2:
-#ifdef CONFIG_PPC_ISERIES
-BEGIN_FW_FTR_SECTION
-	b	unrecov_slb
-END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
-#endif /* CONFIG_PPC_ISERIES */
-	mfspr	r11,SPRN_SRR0
+2:	mfspr	r11,SPRN_SRR0
 	ld	r10,PACAKBASE(r13)
 	LOAD_HANDLER(r10,unrecov_slb)
 	mtspr	SPRN_SRR0,r10
@@ -727,20 +710,6 @@ unrecov_slb:
 	bl	.unrecoverable_exception
 	b	1b
 
-	.align	7
-	.globl hardware_interrupt_common
-	.globl hardware_interrupt_entry
-hardware_interrupt_common:
-	EXCEPTION_PROLOG_COMMON(0x500, PACA_EXGEN)
-	FINISH_NAP
-hardware_interrupt_entry:
-	DISABLE_INTS
-BEGIN_FTR_SECTION
-	bl	.ppc64_runlatch_on
-END_FTR_SECTION_IFSET(CPU_FTR_CTRL)
-	addi	r3,r1,STACK_FRAME_OVERHEAD
-	bl	.do_IRQ
-	b	.ret_from_except_lite
 
 #ifdef CONFIG_PPC_970_NAP
 power4_fixup_nap:
@@ -913,11 +882,7 @@ END_MMU_FTR_SECTION_IFCLR(MMU_FTR_SLB)
 	andis.	r0,r0,NMI_MASK@h	/* (i.e. an irq when soft-disabled) */
 	bne	77f			/* then don't call hash_page now */
 
-	/*
-	 * On iSeries, we soft-disable interrupts here, then
-	 * hard-enable interrupts so that the hash_page code can spin on
-	 * the hash_table_lock without problems on a shared processor.
-	 */
+	/* We run with interrupts both soft and hard disabled */
 	DISABLE_INTS
 
 	/*
@@ -956,25 +921,11 @@ END_MMU_FTR_SECTION_IFCLR(MMU_FTR_SLB)
 	bl	.hash_page		/* build HPTE if possible */
 	cmpdi	r3,0			/* see if hash_page succeeded */
 
-BEGIN_FW_FTR_SECTION
-	/*
-	 * If we had interrupts soft-enabled at the point where the
-	 * DSI/ISI occurred, and an interrupt came in during hash_page,
-	 * handle it now.
-	 * We jump to ret_from_except_lite rather than fast_exception_return
-	 * because ret_from_except_lite will check for and handle pending
-	 * interrupts if necessary.
-	 */
-	beq	13f
-END_FW_FTR_SECTION_IFSET(FW_FEATURE_ISERIES)
-
-BEGIN_FW_FTR_SECTION
 	/*
 	 * Here we have interrupts hard-disabled, so it is sufficient
 	 * to restore paca->{soft,hard}_enable and get out.
 	 */
 	beq	fast_exc_return_irq	/* Return from exception on success */
-END_FW_FTR_SECTION_IFCLR(FW_FEATURE_ISERIES)
 
 	/* For a hash failure, we don't bother re-enabling interrupts */
 	ble-	12f
@@ -1141,51 +1092,19 @@ _GLOBAL(do_stab_bolted)
 	.= 0x7000
 	.globl fwnmi_data_area
 fwnmi_data_area:
-#endif /* defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV) */
-
-	/* iSeries does not use the FWNMI stuff, so it is safe to put
-	 * this here, even if we later allow kernels that will boot on
-	 * both pSeries and iSeries */
-#ifdef CONFIG_PPC_ISERIES
-        . = LPARMAP_PHYS
-	.globl xLparMap
-xLparMap:
-	.quad	HvEsidsToMap		/* xNumberEsids */
-	.quad	HvRangesToMap		/* xNumberRanges */
-	.quad	STAB0_PAGE		/* xSegmentTableOffs */
-	.zero	40			/* xRsvd */
-	/* xEsids (HvEsidsToMap entries of 2 quads) */
-	.quad	PAGE_OFFSET_ESID	/* xKernelEsid */
-	.quad	PAGE_OFFSET_VSID	/* xKernelVsid */
-	.quad	VMALLOC_START_ESID	/* xKernelEsid */
-	.quad	VMALLOC_START_VSID	/* xKernelVsid */
-	/* xRanges (HvRangesToMap entries of 3 quads) */
-	.quad	HvPagesToMap		/* xPages */
-	.quad	0			/* xOffset */
-	.quad	PAGE_OFFSET_VSID << (SID_SHIFT - HW_PAGE_SHIFT)	/* xVPN */
-
-#endif /* CONFIG_PPC_ISERIES */
 
-#if defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV)
 	/* pseries and powernv need to keep the whole page from
 	 * 0x7000 to 0x8000 free for use by the firmware
 	 */
         . = 0x8000
 #endif /* defined(CONFIG_PPC_PSERIES) || defined(CONFIG_PPC_POWERNV) */
 
-/*
- * Space for CPU0's segment table.
- *
- * On iSeries, the hypervisor must fill in at least one entry before
- * we get control (with relocate on).  The address is given to the hv
- * as a page number (see xLparMap above), so this must be at a
- * fixed address (the linker can't compute (u64)&initial_stab >>
- * PAGE_SHIFT).
- */
-	. = STAB0_OFFSET	/* 0x8000 */
+/* Space for CPU0's segment table */
+	.balign 4096
 	.globl initial_stab
 initial_stab:
 	.space	4096
+
 #ifdef CONFIG_PPC_POWERNV
 _GLOBAL(opal_mc_secondary_handler)
 	HMT_MEDIUM