nl80211: support beacon report scanning

Beacon report radio measurement requires reporting observed BSSs
on the channels specified in the beacon request. If the measurement
mode is set to passive or active, it requires actually performing a
scan (passive or active, accordingly), and reporting the time that
the scan was started and the time each beacon/probe was received
(both in terms of TSF of the BSS of the requesting AP). If the
request mode is table, this information is optional.
In addition, the radio measurement request specifies the channel
dwell time for the measurement.

In order to use scan for beacon report when the mode is active or
passive, add a parameter to scan request that specifies the
channel dwell time, and add scan start time and beacon received time
to scan results information.

Supporting beacon report is required for Multi Band Operation (MBO).

Signed-off-by: Assaf Krauss <assaf.krauss@intel.com>
Signed-off-by: David Spinadel <david.spinadel@intel.com>
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

1 files changed, 12 insertions, 0 deletions

diff --git a/net/wireless/core.h b/net/wireless/core.h
index a4d547f99f8d..eee91443924d 100644
--- a/net/wireless/core.h
+++ b/net/wireless/core.h
@@ -141,6 +141,18 @@ struct cfg80211_internal_bss {
 	unsigned long refcount;
 	atomic_t hold;
 
+	/* time at the start of the reception of the first octet of the
+	 * timestamp field of the last beacon/probe received for this BSS.
+	 * The time is the TSF of the BSS specified by %parent_bssid.
+	 */
+	u64 parent_tsf;
+
+	/* the BSS according to which %parent_tsf is set. This is set to
+	 * the BSS that the interface that requested the scan was connected to
+	 * when the beacon/probe was received.
+	 */
+	u8 parent_bssid[ETH_ALEN] __aligned(2);
+
 	/* must be last because of priv member */
 	struct cfg80211_bss pub;
 };