summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--drivers/mtd/nand/gpmi-nand/gpmi-lib.c18
1 files changed, 14 insertions, 4 deletions
diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
index 2a56fc6f399a..c56f8e021b90 100644
--- a/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
+++ b/drivers/mtd/nand/gpmi-nand/gpmi-lib.c
@@ -69,17 +69,19 @@ static int clear_poll_bit(void __iomem *addr, u32 mask)
* [1] enable the module.
* [2] reset the module.
*
- * In most of the cases, it's ok. But there is a hardware bug in the BCH block.
+ * In most of the cases, it's ok.
+ * But in MX23, there is a hardware bug in the BCH block (see erratum #2847).
* If you try to soft reset the BCH block, it becomes unusable until
* the next hard reset. This case occurs in the NAND boot mode. When the board
* boots by NAND, the ROM of the chip will initialize the BCH blocks itself.
* So If the driver tries to reset the BCH again, the BCH will not work anymore.
- * You will see a DMA timeout in this case.
+ * You will see a DMA timeout in this case. The bug has been fixed
+ * in the following chips, such as MX28.
*
* To avoid this bug, just add a new parameter `just_enable` for
* the mxs_reset_block(), and rewrite it here.
*/
-int gpmi_reset_block(void __iomem *reset_addr, bool just_enable)
+static int gpmi_reset_block(void __iomem *reset_addr, bool just_enable)
{
int ret;
int timeout = 0x400;
@@ -206,7 +208,15 @@ int bch_set_geometry(struct gpmi_nand_data *this)
if (ret)
goto err_out;
- ret = gpmi_reset_block(r->bch_regs, true);
+ /*
+ * Due to erratum #2847 of the MX23, the BCH cannot be soft reset on this
+ * chip, otherwise it will lock up. So we skip resetting BCH on the MX23.
+ * On the other hand, the MX28 needs the reset, because one case has been
+ * seen where the BCH produced ECC errors constantly after 10000
+ * consecutive reboots. The latter case has not been seen on the MX23 yet,
+ * still we don't know if it could happen there as well.
+ */
+ ret = gpmi_reset_block(r->bch_regs, GPMI_IS_MX23(this));
if (ret)
goto err_out;