diff options
| -rw-r--r-- | drivers/mmc/host/sdhci-pltfm.h | 2 | ||||
| -rw-r--r-- | include/linux/mmc/sdhci.h | 68 |
2 files changed, 35 insertions, 35 deletions
diff --git a/drivers/mmc/host/sdhci-pltfm.h b/drivers/mmc/host/sdhci-pltfm.h index 3a9fc3f40840..b92c7f29a4e7 100644 --- a/drivers/mmc/host/sdhci-pltfm.h +++ b/drivers/mmc/host/sdhci-pltfm.h @@ -17,7 +17,7 @@ struct sdhci_pltfm_data { struct sdhci_ops *ops; - unsigned int quirks; + u64 quirks; }; struct sdhci_pltfm_host { diff --git a/include/linux/mmc/sdhci.h b/include/linux/mmc/sdhci.h index 0c7b5869813b..85e7850b88af 100644 --- a/include/linux/mmc/sdhci.h +++ b/include/linux/mmc/sdhci.h @@ -21,74 +21,74 @@ struct sdhci_host { /* Data set by hardware interface driver */ const char *hw_name; /* Hardware bus name */ - unsigned int quirks; /* Deviations from spec. */ + u64 quirks; /* Deviations from spec. */ /* Controller doesn't honor resets unless we touch the clock register */ -#define SDHCI_QUIRK_CLOCK_BEFORE_RESET (1<<0) +#define SDHCI_QUIRK_CLOCK_BEFORE_RESET (1ULL<<0) /* Controller has bad caps bits, but really supports DMA */ -#define SDHCI_QUIRK_FORCE_DMA (1<<1) +#define SDHCI_QUIRK_FORCE_DMA (1ULL<<1) /* Controller doesn't like to be reset when there is no card inserted. */ -#define SDHCI_QUIRK_NO_CARD_NO_RESET (1<<2) +#define SDHCI_QUIRK_NO_CARD_NO_RESET (1ULL<<2) /* Controller doesn't like clearing the power reg before a change */ -#define SDHCI_QUIRK_SINGLE_POWER_WRITE (1<<3) +#define SDHCI_QUIRK_SINGLE_POWER_WRITE (1ULL<<3) /* Controller has flaky internal state so reset it on each ios change */ -#define SDHCI_QUIRK_RESET_CMD_DATA_ON_IOS (1<<4) +#define SDHCI_QUIRK_RESET_CMD_DATA_ON_IOS (1ULL<<4) /* Controller has an unusable DMA engine */ -#define SDHCI_QUIRK_BROKEN_DMA (1<<5) +#define SDHCI_QUIRK_BROKEN_DMA (1ULL<<5) /* Controller has an unusable ADMA engine */ -#define SDHCI_QUIRK_BROKEN_ADMA (1<<6) +#define SDHCI_QUIRK_BROKEN_ADMA (1ULL<<6) /* Controller can only DMA from 32-bit aligned addresses */ -#define SDHCI_QUIRK_32BIT_DMA_ADDR (1<<7) +#define SDHCI_QUIRK_32BIT_DMA_ADDR (1ULL<<7) /* Controller can only DMA chunk sizes that are a multiple of 32 bits */ -#define SDHCI_QUIRK_32BIT_DMA_SIZE (1<<8) +#define SDHCI_QUIRK_32BIT_DMA_SIZE (1ULL<<8) /* Controller can only ADMA chunks that are a multiple of 32 bits */ -#define SDHCI_QUIRK_32BIT_ADMA_SIZE (1<<9) +#define SDHCI_QUIRK_32BIT_ADMA_SIZE (1ULL<<9) /* Controller needs to be reset after each request to stay stable */ -#define SDHCI_QUIRK_RESET_AFTER_REQUEST (1<<10) +#define SDHCI_QUIRK_RESET_AFTER_REQUEST (1ULL<<10) /* Controller needs voltage and power writes to happen separately */ -#define SDHCI_QUIRK_NO_SIMULT_VDD_AND_POWER (1<<11) +#define SDHCI_QUIRK_NO_SIMULT_VDD_AND_POWER (1ULL<<11) /* Controller provides an incorrect timeout value for transfers */ -#define SDHCI_QUIRK_BROKEN_TIMEOUT_VAL (1<<12) +#define SDHCI_QUIRK_BROKEN_TIMEOUT_VAL (1ULL<<12) /* Controller has an issue with buffer bits for small transfers */ -#define SDHCI_QUIRK_BROKEN_SMALL_PIO (1<<13) +#define SDHCI_QUIRK_BROKEN_SMALL_PIO (1ULL<<13) /* Controller does not provide transfer-complete interrupt when not busy */ -#define SDHCI_QUIRK_NO_BUSY_IRQ (1<<14) +#define SDHCI_QUIRK_NO_BUSY_IRQ (1ULL<<14) /* Controller has unreliable card detection */ -#define SDHCI_QUIRK_BROKEN_CARD_DETECTION (1<<15) +#define SDHCI_QUIRK_BROKEN_CARD_DETECTION (1ULL<<15) /* Controller reports inverted write-protect state */ -#define SDHCI_QUIRK_INVERTED_WRITE_PROTECT (1<<16) +#define SDHCI_QUIRK_INVERTED_WRITE_PROTECT (1ULL<<16) /* Controller has nonstandard clock management */ -#define SDHCI_QUIRK_NONSTANDARD_CLOCK (1<<17) +#define SDHCI_QUIRK_NONSTANDARD_CLOCK (1ULL<<17) /* Controller does not like fast PIO transfers */ -#define SDHCI_QUIRK_PIO_NEEDS_DELAY (1<<18) +#define SDHCI_QUIRK_PIO_NEEDS_DELAY (1ULL<<18) /* Controller losing signal/interrupt enable states after reset */ -#define SDHCI_QUIRK_RESTORE_IRQS_AFTER_RESET (1<<19) +#define SDHCI_QUIRK_RESTORE_IRQS_AFTER_RESET (1ULL<<19) /* Controller has to be forced to use block size of 2048 bytes */ -#define SDHCI_QUIRK_FORCE_BLK_SZ_2048 (1<<20) +#define SDHCI_QUIRK_FORCE_BLK_SZ_2048 (1ULL<<20) /* Controller cannot do multi-block transfers */ -#define SDHCI_QUIRK_NO_MULTIBLOCK (1<<21) +#define SDHCI_QUIRK_NO_MULTIBLOCK (1ULL<<21) /* Controller can only handle 1-bit data transfers */ -#define SDHCI_QUIRK_FORCE_1_BIT_DATA (1<<22) +#define SDHCI_QUIRK_FORCE_1_BIT_DATA (1ULL<<22) /* Controller needs 10ms delay between applying power and clock */ -#define SDHCI_QUIRK_DELAY_AFTER_POWER (1<<23) +#define SDHCI_QUIRK_DELAY_AFTER_POWER (1ULL<<23) /* Controller uses SDCLK instead of TMCLK for data timeouts */ -#define SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK (1<<24) +#define SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK (1ULL<<24) /* Controller reports wrong base clock capability */ -#define SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN (1<<25) +#define SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN (1ULL<<25) /* Controller cannot support End Attribute in NOP ADMA descriptor */ -#define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC (1<<26) +#define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC (1ULL<<26) /* Controller is missing device caps. Use caps provided by host */ -#define SDHCI_QUIRK_MISSING_CAPS (1<<27) +#define SDHCI_QUIRK_MISSING_CAPS (1ULL<<27) /* Controller uses Auto CMD12 command to stop the transfer */ -#define SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12 (1<<28) +#define SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12 (1ULL<<28) /* Controller doesn't have HISPD bit field in HI-SPEED SD card */ -#define SDHCI_QUIRK_NO_HISPD_BIT (1<<29) +#define SDHCI_QUIRK_NO_HISPD_BIT (1ULL<<29) /* Controller treats ADMA descriptors with length 0000h incorrectly */ -#define SDHCI_QUIRK_BROKEN_ADMA_ZEROLEN_DESC (1<<30) +#define SDHCI_QUIRK_BROKEN_ADMA_ZEROLEN_DESC (1ULL<<30) /* The read-only detection via SDHCI_PRESENT_STATE register is unstable */ -#define SDHCI_QUIRK_UNSTABLE_RO_DETECT (1<<31) +#define SDHCI_QUIRK_UNSTABLE_RO_DETECT (1ULL<<31) /* Controller cannot report the line status in present state register */ -#define SDHCI_QUIRK_NON_STD_VOLTAGE_SWITCHING (1UL<<32) +#define SDHCI_QUIRK_NON_STD_VOLTAGE_SWITCHING (1ULL<<32) int irq; /* Device IRQ */ void __iomem *ioaddr; /* Mapped address */ |