2 files changed, 32 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gateworks,pld-gpio.txt b/Documentation/devicetree/bindings/gpio/gateworks,pld-gpio.txt
new file mode 100644
index 000000000000..6e81f8b755c5
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gateworks,pld-gpio.txt
@@ -0,0 +1,20 @@
+Gateworks PLD GPIO controller bindings
+
+The GPIO controller should be a child node on an I2C bus,
+see: i2c/i2c.txt for details.
+
+Required properties:
+- compatible: Should be "gateworks,pld-gpio"
+- reg: I2C slave address
+- gpio-controller: Marks the device node as a GPIO controller.
+- #gpio-cells: Should be <2>. The first cell is the gpio number and
+  the second cell is used to specify optional parameters.
+
+Example:
+
+pld@56 {
+	compatible = "gateworks,pld-gpio";
+	reg = <0x56>;
+	gpio-controller;
+	#gpio-cells = <2>;
+};
diff --git a/Documentation/devicetree/bindings/gpio/gpio.txt b/Documentation/devicetree/bindings/gpio/gpio.txt
index f0ba154b5723..a8895d339bfe 100644
--- a/Documentation/devicetree/bindings/gpio/gpio.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio.txt
@@ -67,6 +67,18 @@ Optional standard bitfield specifiers for the last cell:
            https://en.wikipedia.org/wiki/Open_collector
 - Bit 3: 0 means the output should be maintained during sleep/low-power mode
          1 means the output state can be lost during sleep/low-power mode
+- Bit 4: 0 means no pull-up resistor should be enabled
+         1 means a pull-up resistor should be enabled
+         This setting only applies to hardware with a simple on/off
+         control for pull-up configuration. If the hardware has more
+         elaborate pull-up configuration, it should be represented
+         using a pin control binding.
+- Bit 5: 0 means no pull-down resistor should be enabled
+         1 means a pull-down resistor should be enabled
+         This setting only applies to hardware with a simple on/off
+         control for pull-down configuration. If the hardware has more
+         elaborate pull-down configuration, it should be represented
+         using a pin control binding.
 
 1.1) GPIO specifier best practices
 ----------------------------------