diff options
Diffstat (limited to 'Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt')
-rw-r--r-- | Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt | 61 |
1 files changed, 0 insertions, 61 deletions
diff --git a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt b/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt deleted file mode 100644 index 64fa2fbd98c9..000000000000 --- a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt +++ /dev/null @@ -1,61 +0,0 @@ -pwm-backlight bindings - -Required properties: - - compatible: "pwm-backlight" - - pwms: OF device-tree PWM specification (see PWM binding[0]) - - power-supply: regulator for supply voltage - -Optional properties: - - pwm-names: a list of names for the PWM devices specified in the - "pwms" property (see PWM binding[0]) - - enable-gpios: contains a single GPIO specifier for the GPIO which enables - and disables the backlight (see GPIO binding[1]) - - post-pwm-on-delay-ms: Delay in ms between setting an initial (non-zero) PWM - and enabling the backlight using GPIO. - - pwm-off-delay-ms: Delay in ms between disabling the backlight using GPIO - and setting PWM value to 0. - - brightness-levels: Array of distinct brightness levels. Typically these - are in the range from 0 to 255, but any range starting at - 0 will do. The actual brightness level (PWM duty cycle) - will be interpolated from these values. 0 means a 0% duty - cycle (darkest/off), while the last value in the array - represents a 100% duty cycle (brightest). - - default-brightness-level: The default brightness level (index into the - array defined by the "brightness-levels" property). - - num-interpolated-steps: Number of interpolated steps between each value - of brightness-levels table. This way a high - resolution pwm duty cycle can be used without - having to list out every possible value in the - brightness-level array. - -[0]: Documentation/devicetree/bindings/pwm/pwm.txt -[1]: Documentation/devicetree/bindings/gpio/gpio.txt - -Example: - - backlight { - compatible = "pwm-backlight"; - pwms = <&pwm 0 5000000>; - - brightness-levels = <0 4 8 16 32 64 128 255>; - default-brightness-level = <6>; - - power-supply = <&vdd_bl_reg>; - enable-gpios = <&gpio 58 0>; - post-pwm-on-delay-ms = <10>; - pwm-off-delay-ms = <10>; - }; - -Example using num-interpolation-steps: - - backlight { - compatible = "pwm-backlight"; - pwms = <&pwm 0 5000000>; - - brightness-levels = <0 2048 4096 8192 16384 65535>; - num-interpolated-steps = <2048>; - default-brightness-level = <4096>; - - power-supply = <&vdd_bl_reg>; - enable-gpios = <&gpio 58 0>; - }; |