summaryrefslogtreecommitdiff
path: root/Documentation/devicetree/bindings/leds/leds-gpio.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/leds/leds-gpio.txt')
-rw-r--r--Documentation/devicetree/bindings/leds/leds-gpio.txt52
1 files changed, 52 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/leds/leds-gpio.txt b/Documentation/devicetree/bindings/leds/leds-gpio.txt
new file mode 100644
index 000000000000..df1b3080f6b8
--- /dev/null
+++ b/Documentation/devicetree/bindings/leds/leds-gpio.txt
@@ -0,0 +1,52 @@
+LEDs connected to GPIO lines
+
+Required properties:
+- compatible : should be "gpio-leds".
+
+Each LED is represented as a sub-node of the gpio-leds device. Each
+node's name represents the name of the corresponding LED.
+
+LED sub-node properties:
+- gpios : Should specify the LED's GPIO, see "gpios property" in
+ Documentation/devicetree/bindings/gpio/gpio.txt. Active low LEDs should be
+ indicated using flags in the GPIO specifier.
+- label : (optional)
+ see Documentation/devicetree/bindings/leds/common.txt
+- linux,default-trigger : (optional)
+ see Documentation/devicetree/bindings/leds/common.txt
+- default-state: (optional) The initial state of the LED. Valid
+ values are "on", "off", and "keep". If the LED is already on or off
+ and the default-state property is set the to same value, then no
+ glitch should be produced where the LED momentarily turns off (or
+ on). The "keep" setting will keep the LED at whatever its current
+ state is, without producing a glitch. The default is off if this
+ property is not present.
+
+Examples:
+
+leds {
+ compatible = "gpio-leds";
+ hdd {
+ label = "IDE Activity";
+ gpios = <&mcu_pio 0 1>; /* Active low */
+ linux,default-trigger = "ide-disk";
+ };
+
+ fault {
+ gpios = <&mcu_pio 1 0>;
+ /* Keep LED on if BIOS detected hardware fault */
+ default-state = "keep";
+ };
+};
+
+run-control {
+ compatible = "gpio-leds";
+ red {
+ gpios = <&mpc8572 6 0>;
+ default-state = "off";
+ };
+ green {
+ gpios = <&mpc8572 7 0>;
+ default-state = "on";
+ };
+};