diff options
Diffstat (limited to 'Documentation/networking')
| -rw-r--r-- | Documentation/networking/dccp.txt | 6 | ||||
| -rw-r--r-- | Documentation/networking/ip-sysctl.txt | 58 | ||||
| -rwxr-xr-x | Documentation/networking/ixgbevf.txt | 90 | ||||
| -rw-r--r-- | Documentation/networking/packet_mmap.txt | 8 | ||||
| -rw-r--r-- | Documentation/networking/regulatory.txt | 24 | ||||
| -rw-r--r-- | Documentation/networking/tcp-thin.txt | 47 |
6 files changed, 224 insertions, 9 deletions
diff --git a/Documentation/networking/dccp.txt b/Documentation/networking/dccp.txt index b132e4a3cf0f..a62fdf7a6bff 100644 --- a/Documentation/networking/dccp.txt +++ b/Documentation/networking/dccp.txt @@ -58,8 +58,10 @@ DCCP_SOCKOPT_GET_CUR_MPS is read-only and retrieves the current maximum packet size (application payload size) in bytes, see RFC 4340, section 14. DCCP_SOCKOPT_AVAILABLE_CCIDS is also read-only and returns the list of CCIDs -supported by the endpoint (see include/linux/dccp.h for symbolic constants). -The caller needs to provide a sufficiently large (> 2) array of type uint8_t. +supported by the endpoint. The option value is an array of type uint8_t whose +size is passed as option length. The minimum array size is 4 elements, the +value returned in the optlen argument always reflects the true number of +built-in CCIDs. DCCP_SOCKOPT_CCID is write-only and sets both the TX and RX CCIDs at the same time, combining the operation of the next two socket options. This option is diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index e87f3cdc8a6a..8b72c88ba213 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -487,6 +487,30 @@ tcp_dma_copybreak - INTEGER and CONFIG_NET_DMA is enabled. Default: 4096 +tcp_thin_linear_timeouts - BOOLEAN + Enable dynamic triggering of linear timeouts for thin streams. + If set, a check is performed upon retransmission by timeout to + determine if the stream is thin (less than 4 packets in flight). + As long as the stream is found to be thin, up to 6 linear + timeouts may be performed before exponential backoff mode is + initiated. This improves retransmission latency for + non-aggressive thin streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + +tcp_thin_dupack - BOOLEAN + Enable dynamic triggering of retransmissions after one dupACK + for thin streams. If set, a check is performed upon reception + of a dupACK to determine if the stream is thin (less than 4 + packets in flight). As long as the stream is found to be thin, + data is retransmitted on the first received dupACK. This + improves retransmission latency for non-aggressive thin + streams, often found to be time-dependent. + For more information on thin streams, see + Documentation/networking/tcp-thin.txt + Default: 0 + UDP variables: udp_mem - vector of 3 INTEGERs: min, pressure, max @@ -692,6 +716,25 @@ proxy_arp - BOOLEAN conf/{all,interface}/proxy_arp is set to TRUE, it will be disabled otherwise +proxy_arp_pvlan - BOOLEAN + Private VLAN proxy arp. + Basically allow proxy arp replies back to the same interface + (from which the ARP request/solicitation was received). + + This is done to support (ethernet) switch features, like RFC + 3069, where the individual ports are NOT allowed to + communicate with each other, but they are allowed to talk to + the upstream router. As described in RFC 3069, it is possible + to allow these hosts to communicate through the upstream + router by proxy_arp'ing. Don't need to be used together with + proxy_arp. + + This technology is known by different names: + In RFC 3069 it is called VLAN Aggregation. + Cisco and Allied Telesyn call it Private VLAN. + Hewlett-Packard call it Source-Port filtering or port-isolation. + Ericsson call it MAC-Forced Forwarding (RFC Draft). + shared_media - BOOLEAN Send(router) or accept(host) RFC1620 shared media redirects. Overrides ip_secure_redirects. @@ -833,9 +876,18 @@ arp_notify - BOOLEAN or hardware address changes. arp_accept - BOOLEAN - Define behavior when gratuitous arp replies are received: - 0 - drop gratuitous arp frames - 1 - accept gratuitous arp frames + Define behavior for gratuitous ARP frames who's IP is not + already present in the ARP table: + 0 - don't create new entries in the ARP table + 1 - create new entries in the ARP table + + Both replies and requests type gratuitous arp will trigger the + ARP table to be updated, if this setting is on. + + If the ARP table already contains the IP address of the + gratuitous arp frame, the arp table will be updated regardless + if this setting is on or off. + app_solicit - INTEGER The maximum number of probes to send to the user space ARP daemon diff --git a/Documentation/networking/ixgbevf.txt b/Documentation/networking/ixgbevf.txt new file mode 100755 index 000000000000..19015de6725f --- /dev/null +++ b/Documentation/networking/ixgbevf.txt @@ -0,0 +1,90 @@ +Linux* Base Driver for Intel(R) Network Connection +================================================== + +November 24, 2009 + +Contents +======== + +- In This Release +- Identifying Your Adapter +- Known Issues/Troubleshooting +- Support + +In This Release +=============== + +This file describes the ixgbevf Linux* Base Driver for Intel Network +Connection. + +The ixgbevf driver supports 82599-based virtual function devices that can only +be activated on kernels with CONFIG_PCI_IOV enabled. + +The ixgbevf driver supports virtual functions generated by the ixgbe driver +with a max_vfs value of 1 or greater. + +The guest OS loading the ixgbevf driver must support MSI-X interrupts. + +VLANs: There is a limit of a total of 32 shared VLANs to 1 or more VFs. + +Identifying Your Adapter +======================== + +For more information on how to identify your adapter, go to the Adapter & +Driver ID Guide at: + + http://support.intel.com/support/network/sb/CS-008441.htm + +Known Issues/Troubleshooting +============================ + + Unloading Physical Function (PF) Driver Causes System Reboots When VM is + Running and VF is Loaded on the VM + ------------------------------------------------------------------------ + Do not unload the PF driver (ixgbe) while VFs are assigned to guests. + +Support +======= + +For general information, go to the Intel support website at: + + http://support.intel.com + +or the Intel Wired Networking project hosted by Sourceforge at: + + http://sourceforge.net/projects/e1000 + +If an issue is identified with the released source code on the supported +kernel with a supported adapter, email the specific information related +to the issue to e1000-devel@lists.sf.net + +License +======= + +Intel 10 Gigabit Linux driver. +Copyright(c) 1999 - 2009 Intel Corporation. + +This program is free software; you can redistribute it and/or modify it +under the terms and conditions of the GNU General Public License, +version 2, as published by the Free Software Foundation. + +This program is distributed in the hope it will be useful, but WITHOUT +ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or +FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for +more details. + +You should have received a copy of the GNU General Public License along with +this program; if not, write to the Free Software Foundation, Inc., +51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA. + +The full GNU General Public License is included in this distribution in +the file called "COPYING". + +Trademarks +========== + +Intel, Itanium, and Pentium are trademarks or registered trademarks of +Intel Corporation or its subsidiaries in the United States and other +countries. + +* Other names and brands may be claimed as the property of others. diff --git a/Documentation/networking/packet_mmap.txt b/Documentation/networking/packet_mmap.txt index a22fd85e3796..09ab0d290326 100644 --- a/Documentation/networking/packet_mmap.txt +++ b/Documentation/networking/packet_mmap.txt @@ -2,7 +2,7 @@ + ABSTRACT -------------------------------------------------------------------------------- -This file documents the CONFIG_PACKET_MMAP option available with the PACKET +This file documents the mmap() facility available with the PACKET socket interface on 2.4 and 2.6 kernels. This type of sockets is used for capture network traffic with utilities like tcpdump or any other that needs raw access to network interface. @@ -44,7 +44,7 @@ enabled. For transmission, check the MTU (Maximum Transmission Unit) used and supported by devices of your network. -------------------------------------------------------------------------------- -+ How to use CONFIG_PACKET_MMAP to improve capture process ++ How to use mmap() to improve capture process -------------------------------------------------------------------------------- From the user standpoint, you should use the higher level libpcap library, which @@ -64,7 +64,7 @@ the low level details or want to improve libpcap by including PACKET_MMAP support. -------------------------------------------------------------------------------- -+ How to use CONFIG_PACKET_MMAP directly to improve capture process ++ How to use mmap() directly to improve capture process -------------------------------------------------------------------------------- From the system calls stand point, the use of PACKET_MMAP involves @@ -105,7 +105,7 @@ also the mapping of the circular buffer in the user process and the use of this buffer. -------------------------------------------------------------------------------- -+ How to use CONFIG_PACKET_MMAP directly to improve transmission process ++ How to use mmap() directly to improve transmission process -------------------------------------------------------------------------------- Transmission process is similar to capture as shown below. diff --git a/Documentation/networking/regulatory.txt b/Documentation/networking/regulatory.txt index ee31369e9e5b..9551622d0a7b 100644 --- a/Documentation/networking/regulatory.txt +++ b/Documentation/networking/regulatory.txt @@ -188,3 +188,27 @@ Then in some part of your code after your wiphy has been registered: &mydriver_jp_regdom.reg_rules[i], sizeof(struct ieee80211_reg_rule)); regulatory_struct_hint(rd); + +Statically compiled regulatory database +--------------------------------------- + +In most situations the userland solution using CRDA as described +above is the preferred solution. However in some cases a set of +rules built into the kernel itself may be desirable. To account +for this situation, a configuration option has been provided +(i.e. CONFIG_CFG80211_INTERNAL_REGDB). With this option enabled, +the wireless database information contained in net/wireless/db.txt is +used to generate a data structure encoded in net/wireless/regdb.c. +That option also enables code in net/wireless/reg.c which queries +the data in regdb.c as an alternative to using CRDA. + +The file net/wireless/db.txt should be kept up-to-date with the db.txt +file available in the git repository here: + + git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-regdb.git + +Again, most users in most situations should be using the CRDA package +provided with their distribution, and in most other situations users +should be building and using CRDA on their own rather than using +this option. If you are not absolutely sure that you should be using +CONFIG_CFG80211_INTERNAL_REGDB then _DO_NOT_USE_IT_. diff --git a/Documentation/networking/tcp-thin.txt b/Documentation/networking/tcp-thin.txt new file mode 100644 index 000000000000..151e229980f1 --- /dev/null +++ b/Documentation/networking/tcp-thin.txt @@ -0,0 +1,47 @@ +Thin-streams and TCP +==================== +A wide range of Internet-based services that use reliable transport +protocols display what we call thin-stream properties. This means +that the application sends data with such a low rate that the +retransmission mechanisms of the transport protocol are not fully +effective. In time-dependent scenarios (like online games, control +systems, stock trading etc.) where the user experience depends +on the data delivery latency, packet loss can be devastating for +the service quality. Extreme latencies are caused by TCP's +dependency on the arrival of new data from the application to trigger +retransmissions effectively through fast retransmit instead of +waiting for long timeouts. + +After analysing a large number of time-dependent interactive +applications, we have seen that they often produce thin streams +and also stay with this traffic pattern throughout its entire +lifespan. The combination of time-dependency and the fact that the +streams provoke high latencies when using TCP is unfortunate. + +In order to reduce application-layer latency when packets are lost, +a set of mechanisms has been made, which address these latency issues +for thin streams. In short, if the kernel detects a thin stream, +the retransmission mechanisms are modified in the following manner: + +1) If the stream is thin, fast retransmit on the first dupACK. +2) If the stream is thin, do not apply exponential backoff. + +These enhancements are applied only if the stream is detected as +thin. This is accomplished by defining a threshold for the number +of packets in flight. If there are less than 4 packets in flight, +fast retransmissions can not be triggered, and the stream is prone +to experience high retransmission latencies. + +Since these mechanisms are targeted at time-dependent applications, +they must be specifically activated by the application using the +TCP_THIN_LINEAR_TIMEOUTS and TCP_THIN_DUPACK IOCTLS or the +tcp_thin_linear_timeouts and tcp_thin_dupack sysctls. Both +modifications are turned off by default. + +References +========== +More information on the modifications, as well as a wide range of +experimental data can be found here: +"Improving latency for interactive, thin-stream applications over +reliable transport" +http://simula.no/research/nd/publications/Simula.nd.477/simula_pdf_file |