diff options
Diffstat (limited to 'Documentation/sound/oss/Soundblaster')
| -rw-r--r-- | Documentation/sound/oss/Soundblaster | 53 |
1 files changed, 0 insertions, 53 deletions
diff --git a/Documentation/sound/oss/Soundblaster b/Documentation/sound/oss/Soundblaster deleted file mode 100644 index b288d464ba8b..000000000000 --- a/Documentation/sound/oss/Soundblaster +++ /dev/null @@ -1,53 +0,0 @@ -modprobe sound -insmod uart401 -insmod sb ... - -This loads the driver for the Sound Blaster and assorted clones. Cards that -are covered by other drivers should not be using this driver. - -The Sound Blaster module takes the following arguments - -io I/O address of the Sound Blaster chip (0x220,0x240,0x260,0x280) -irq IRQ of the Sound Blaster chip (5,7,9,10) -dma 8-bit DMA channel for the Sound Blaster (0,1,3) -dma16 16-bit DMA channel for SB16 and equivalent cards (5,6,7) -mpu_io I/O for MPU chip if present (0x300,0x330) - -sm_games=1 Set if you have a Logitech soundman games -acer=1 Set this to detect cards in some ACER notebooks -mwave_bug=1 Set if you are trying to use this driver with mwave (see on) -type Use this to specify a specific card type - -The following arguments are taken if ISAPnP support is compiled in - -isapnp=0 Set this to disable ISAPnP detection (use io=0xXXX etc. above) -multiple=0 Set to disable detection of multiple Soundblaster cards. - Consider it a bug if this option is needed, and send in a - report. -pnplegacy=1 Set this to be able to use a PnP card(s) along with a single - non-PnP (legacy) card. Above options for io, irq, etc. are - needed, and will apply only to the legacy card. -reverse=1 Reverses the order of the search in the PnP table. -uart401=1 Set to enable detection of mpu devices on some clones. -isapnpjump=n Jumps to slot n in the driver's PnP table. Use the source, - Luke. - -You may well want to load the opl3 driver for synth music on most SB and -clone SB devices - -insmod opl3 io=0x388 - -Using Mwave - -To make this driver work with Mwave you must set mwave_bug. You also need -to warm boot from DOS/Windows with the required firmware loaded under this -OS. IBM are being difficult about documenting how to load this firmware. - -Avance Logic ALS007 - -This card is supported; see the separate file ALS007 for full details. - -Avance Logic ALS100 - -This card is supported; setup should be as for a standard Sound Blaster 16. -The driver will identify the audio device as a "Sound Blaster 16 (ALS-100)". |