diff options
Diffstat (limited to 'arch/arm')
-rw-r--r-- | arch/arm/mach-pxa/raumfeld.c | 36 | ||||
-rw-r--r-- | arch/arm/plat-pxa/gpio.c | 10 |
2 files changed, 24 insertions, 22 deletions
diff --git a/arch/arm/mach-pxa/raumfeld.c b/arch/arm/mach-pxa/raumfeld.c index d130f77b6d11..2f37d43f51b6 100644 --- a/arch/arm/mach-pxa/raumfeld.c +++ b/arch/arm/mach-pxa/raumfeld.c @@ -573,10 +573,10 @@ static struct pxafb_mode_info sharp_lq043t3dx02_mode = { .xres = 480, .yres = 272, .bpp = 16, - .hsync_len = 4, + .hsync_len = 41, .left_margin = 2, .right_margin = 1, - .vsync_len = 1, + .vsync_len = 10, .upper_margin = 3, .lower_margin = 1, .sync = 0, @@ -596,29 +596,31 @@ static void __init raumfeld_lcd_init(void) { int ret; - pxa_set_fb_info(NULL, &raumfeld_sharp_lcd_info); - - /* Earlier devices had the backlight regulator controlled - * via PWM, later versions use another controller for that */ - if ((system_rev & 0xff) < 2) { - mfp_cfg_t raumfeld_pwm_pin_config = GPIO17_PWM0_OUT; - pxa3xx_mfp_config(&raumfeld_pwm_pin_config, 1); - platform_device_register(&raumfeld_pwm_backlight_device); - } else - platform_device_register(&raumfeld_lt3593_device); - ret = gpio_request(GPIO_TFT_VA_EN, "display VA enable"); if (ret < 0) pr_warning("Unable to request GPIO_TFT_VA_EN\n"); else gpio_direction_output(GPIO_TFT_VA_EN, 1); + msleep(100); + ret = gpio_request(GPIO_DISPLAY_ENABLE, "display enable"); if (ret < 0) pr_warning("Unable to request GPIO_DISPLAY_ENABLE\n"); else gpio_direction_output(GPIO_DISPLAY_ENABLE, 1); + /* Hardware revision 2 has the backlight regulator controlled + * by an LT3593, earlier and later devices use PWM for that. */ + if ((system_rev & 0xff) == 2) { + platform_device_register(&raumfeld_lt3593_device); + } else { + mfp_cfg_t raumfeld_pwm_pin_config = GPIO17_PWM0_OUT; + pxa3xx_mfp_config(&raumfeld_pwm_pin_config, 1); + platform_device_register(&raumfeld_pwm_backlight_device); + } + + pxa_set_fb_info(NULL, &raumfeld_sharp_lcd_info); platform_device_register(&pxa3xx_device_gcu); } @@ -657,10 +659,10 @@ static struct lis3lv02d_platform_data lis3_pdata = { #define SPI_AK4104 \ { \ - .modalias = "ak4104", \ - .max_speed_hz = 10000, \ - .bus_num = 0, \ - .chip_select = 0, \ + .modalias = "ak4104-codec", \ + .max_speed_hz = 10000, \ + .bus_num = 0, \ + .chip_select = 0, \ .controller_data = (void *) GPIO_SPDIF_CS, \ } diff --git a/arch/arm/plat-pxa/gpio.c b/arch/arm/plat-pxa/gpio.c index 48ebb9479b61..a11dc3670505 100644 --- a/arch/arm/plat-pxa/gpio.c +++ b/arch/arm/plat-pxa/gpio.c @@ -50,7 +50,7 @@ static inline void __iomem *gpio_chip_base(struct gpio_chip *c) return container_of(c, struct pxa_gpio_chip, chip)->regbase; } -static inline struct pxa_gpio_chip *gpio_to_chip(unsigned gpio) +static inline struct pxa_gpio_chip *gpio_to_pxachip(unsigned gpio) { return &pxa_gpio_chips[gpio_to_bank(gpio)]; } @@ -161,7 +161,7 @@ static int pxa_gpio_irq_type(struct irq_data *d, unsigned int type) int gpio = irq_to_gpio(d->irq); unsigned long gpdr, mask = GPIO_bit(gpio); - c = gpio_to_chip(gpio); + c = gpio_to_pxachip(gpio); if (type == IRQ_TYPE_PROBE) { /* Don't mess with enabled GPIOs using preconfigured edges or @@ -230,7 +230,7 @@ static void pxa_gpio_demux_handler(unsigned int irq, struct irq_desc *desc) static void pxa_ack_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); __raw_writel(GPIO_bit(gpio), c->regbase + GEDR_OFFSET); } @@ -238,7 +238,7 @@ static void pxa_ack_muxed_gpio(struct irq_data *d) static void pxa_mask_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); uint32_t grer, gfer; c->irq_mask &= ~GPIO_bit(gpio); @@ -252,7 +252,7 @@ static void pxa_mask_muxed_gpio(struct irq_data *d) static void pxa_unmask_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); c->irq_mask |= GPIO_bit(gpio); update_edge_detect(c); |