diff options
Diffstat (limited to 'arch/i386/kernel/cpu/cpufreq/powernow-k8.h')
| -rw-r--r-- | arch/i386/kernel/cpu/cpufreq/powernow-k8.h | 232 |
1 files changed, 0 insertions, 232 deletions
diff --git a/arch/i386/kernel/cpu/cpufreq/powernow-k8.h b/arch/i386/kernel/cpu/cpufreq/powernow-k8.h deleted file mode 100644 index b06c812208ca..000000000000 --- a/arch/i386/kernel/cpu/cpufreq/powernow-k8.h +++ /dev/null @@ -1,232 +0,0 @@ -/* - * (c) 2003-2006 Advanced Micro Devices, Inc. - * Your use of this code is subject to the terms and conditions of the - * GNU general public license version 2. See "COPYING" or - * http://www.gnu.org/licenses/gpl.html - */ - -struct powernow_k8_data { - unsigned int cpu; - - u32 numps; /* number of p-states */ - u32 batps; /* number of p-states supported on battery */ - - /* these values are constant when the PSB is used to determine - * vid/fid pairings, but are modified during the ->target() call - * when ACPI is used */ - u32 rvo; /* ramp voltage offset */ - u32 irt; /* isochronous relief time */ - u32 vidmvs; /* usable value calculated from mvs */ - u32 vstable; /* voltage stabilization time, units 20 us */ - u32 plllock; /* pll lock time, units 1 us */ - u32 exttype; /* extended interface = 1 */ - - /* keep track of the current fid / vid or did */ - u32 currvid, currfid, currdid; - - /* the powernow_table includes all frequency and vid/fid pairings: - * fid are the lower 8 bits of the index, vid are the upper 8 bits. - * frequency is in kHz */ - struct cpufreq_frequency_table *powernow_table; - -#ifdef CONFIG_X86_POWERNOW_K8_ACPI - /* the acpi table needs to be kept. it's only available if ACPI was - * used to determine valid frequency/vid/fid states */ - struct acpi_processor_performance acpi_data; -#endif - /* we need to keep track of associated cores, but let cpufreq - * handle hotplug events - so just point at cpufreq pol->cpus - * structure */ - cpumask_t *available_cores; -}; - - -/* processor's cpuid instruction support */ -#define CPUID_PROCESSOR_SIGNATURE 1 /* function 1 */ -#define CPUID_XFAM 0x0ff00000 /* extended family */ -#define CPUID_XFAM_K8 0 -#define CPUID_XMOD 0x000f0000 /* extended model */ -#define CPUID_XMOD_REV_MASK 0x00080000 -#define CPUID_XFAM_10H 0x00100000 /* family 0x10 */ -#define CPUID_USE_XFAM_XMOD 0x00000f00 -#define CPUID_GET_MAX_CAPABILITIES 0x80000000 -#define CPUID_FREQ_VOLT_CAPABILITIES 0x80000007 -#define P_STATE_TRANSITION_CAPABLE 6 - -/* Model Specific Registers for p-state transitions. MSRs are 64-bit. For */ -/* writes (wrmsr - opcode 0f 30), the register number is placed in ecx, and */ -/* the value to write is placed in edx:eax. For reads (rdmsr - opcode 0f 32), */ -/* the register number is placed in ecx, and the data is returned in edx:eax. */ - -#define MSR_FIDVID_CTL 0xc0010041 -#define MSR_FIDVID_STATUS 0xc0010042 - -/* Field definitions within the FID VID Low Control MSR : */ -#define MSR_C_LO_INIT_FID_VID 0x00010000 -#define MSR_C_LO_NEW_VID 0x00003f00 -#define MSR_C_LO_NEW_FID 0x0000003f -#define MSR_C_LO_VID_SHIFT 8 - -/* Field definitions within the FID VID High Control MSR : */ -#define MSR_C_HI_STP_GNT_TO 0x000fffff - -/* Field definitions within the FID VID Low Status MSR : */ -#define MSR_S_LO_CHANGE_PENDING 0x80000000 /* cleared when completed */ -#define MSR_S_LO_MAX_RAMP_VID 0x3f000000 -#define MSR_S_LO_MAX_FID 0x003f0000 -#define MSR_S_LO_START_FID 0x00003f00 -#define MSR_S_LO_CURRENT_FID 0x0000003f - -/* Field definitions within the FID VID High Status MSR : */ -#define MSR_S_HI_MIN_WORKING_VID 0x3f000000 -#define MSR_S_HI_MAX_WORKING_VID 0x003f0000 -#define MSR_S_HI_START_VID 0x00003f00 -#define MSR_S_HI_CURRENT_VID 0x0000003f -#define MSR_C_HI_STP_GNT_BENIGN 0x00000001 - - -/* Hardware Pstate _PSS and MSR definitions */ -#define USE_HW_PSTATE 0x00000080 -#define HW_PSTATE_FID_MASK 0x0000003f -#define HW_PSTATE_DID_MASK 0x000001c0 -#define HW_PSTATE_DID_SHIFT 6 -#define HW_PSTATE_MASK 0x00000007 -#define HW_PSTATE_VALID_MASK 0x80000000 -#define HW_FID_INDEX_SHIFT 8 -#define HW_FID_INDEX_MASK 0x0000ff00 -#define HW_DID_INDEX_SHIFT 16 -#define HW_DID_INDEX_MASK 0x00ff0000 -#define HW_WATTS_MASK 0xff -#define HW_PWR_DVR_MASK 0x300 -#define HW_PWR_DVR_SHIFT 8 -#define HW_PWR_MAX_MULT 3 -#define MAX_HW_PSTATE 8 /* hw pstate supports up to 8 */ -#define MSR_PSTATE_DEF_BASE 0xc0010064 /* base of Pstate MSRs */ -#define MSR_PSTATE_STATUS 0xc0010063 /* Pstate Status MSR */ -#define MSR_PSTATE_CTRL 0xc0010062 /* Pstate control MSR */ - -/* define the two driver architectures */ -#define CPU_OPTERON 0 -#define CPU_HW_PSTATE 1 - - -/* - * There are restrictions frequencies have to follow: - * - only 1 entry in the low fid table ( <=1.4GHz ) - * - lowest entry in the high fid table must be >= 2 * the entry in the - * low fid table - * - lowest entry in the high fid table must be a <= 200MHz + 2 * the entry - * in the low fid table - * - the parts can only step at <= 200 MHz intervals, odd fid values are - * supported in revision G and later revisions. - * - lowest frequency must be >= interprocessor hypertransport link speed - * (only applies to MP systems obviously) - */ - -/* fids (frequency identifiers) are arranged in 2 tables - lo and hi */ -#define LO_FID_TABLE_TOP 7 /* fid values marking the boundary */ -#define HI_FID_TABLE_BOTTOM 8 /* between the low and high tables */ - -#define LO_VCOFREQ_TABLE_TOP 1400 /* corresponding vco frequency values */ -#define HI_VCOFREQ_TABLE_BOTTOM 1600 - -#define MIN_FREQ_RESOLUTION 200 /* fids jump by 2 matching freq jumps by 200 */ - -#define MAX_FID 0x2a /* Spec only gives FID values as far as 5 GHz */ -#define LEAST_VID 0x3e /* Lowest (numerically highest) useful vid value */ - -#define MIN_FREQ 800 /* Min and max freqs, per spec */ -#define MAX_FREQ 5000 - -#define INVALID_FID_MASK 0xffffffc0 /* not a valid fid if these bits are set */ -#define INVALID_VID_MASK 0xffffffc0 /* not a valid vid if these bits are set */ - -#define VID_OFF 0x3f - -#define STOP_GRANT_5NS 1 /* min poss memory access latency for voltage change */ - -#define PLL_LOCK_CONVERSION (1000/5) /* ms to ns, then divide by clock period */ - -#define MAXIMUM_VID_STEPS 1 /* Current cpus only allow a single step of 25mV */ -#define VST_UNITS_20US 20 /* Voltage Stabalization Time is in units of 20us */ - -/* - * Most values of interest are enocoded in a single field of the _PSS - * entries: the "control" value. - */ - -#define IRT_SHIFT 30 -#define RVO_SHIFT 28 -#define EXT_TYPE_SHIFT 27 -#define PLL_L_SHIFT 20 -#define MVS_SHIFT 18 -#define VST_SHIFT 11 -#define VID_SHIFT 6 -#define IRT_MASK 3 -#define RVO_MASK 3 -#define EXT_TYPE_MASK 1 -#define PLL_L_MASK 0x7f -#define MVS_MASK 3 -#define VST_MASK 0x7f -#define VID_MASK 0x1f -#define FID_MASK 0x1f -#define EXT_VID_MASK 0x3f -#define EXT_FID_MASK 0x3f - - -/* - * Version 1.4 of the PSB table. This table is constructed by BIOS and is - * to tell the OS's power management driver which VIDs and FIDs are - * supported by this particular processor. - * If the data in the PSB / PST is wrong, then this driver will program the - * wrong values into hardware, which is very likely to lead to a crash. - */ - -#define PSB_ID_STRING "AMDK7PNOW!" -#define PSB_ID_STRING_LEN 10 - -#define PSB_VERSION_1_4 0x14 - -struct psb_s { - u8 signature[10]; - u8 tableversion; - u8 flags1; - u16 vstable; - u8 flags2; - u8 num_tables; - u32 cpuid; - u8 plllocktime; - u8 maxfid; - u8 maxvid; - u8 numps; -}; - -/* Pairs of fid/vid values are appended to the version 1.4 PSB table. */ -struct pst_s { - u8 fid; - u8 vid; -}; - -#define dprintk(msg...) cpufreq_debug_printk(CPUFREQ_DEBUG_DRIVER, "powernow-k8", msg) - -static int core_voltage_pre_transition(struct powernow_k8_data *data, u32 reqvid); -static int core_voltage_post_transition(struct powernow_k8_data *data, u32 reqvid); -static int core_frequency_transition(struct powernow_k8_data *data, u32 reqfid); - -static void powernow_k8_acpi_pst_values(struct powernow_k8_data *data, unsigned int index); - -#ifdef CONFIG_X86_POWERNOW_K8_ACPI -static int fill_powernow_table_pstate(struct powernow_k8_data *data, struct cpufreq_frequency_table *powernow_table); -static int fill_powernow_table_fidvid(struct powernow_k8_data *data, struct cpufreq_frequency_table *powernow_table); -#endif - -#ifdef CONFIG_SMP -static inline void define_siblings(int cpu, cpumask_t cpu_sharedcore_mask[]) -{ -} -#else -static inline void define_siblings(int cpu, cpumask_t cpu_sharedcore_mask[]) -{ - cpu_set(0, cpu_sharedcore_mask[0]); -} -#endif |