diff options
Diffstat (limited to 'arch/sparc64/kernel/pci_sabre.c')
| -rw-r--r-- | arch/sparc64/kernel/pci_sabre.c | 158 |
1 files changed, 23 insertions, 135 deletions
diff --git a/arch/sparc64/kernel/pci_sabre.c b/arch/sparc64/kernel/pci_sabre.c index 26f194ce4400..5e087b0fb4c9 100644 --- a/arch/sparc64/kernel/pci_sabre.c +++ b/arch/sparc64/kernel/pci_sabre.c @@ -485,114 +485,6 @@ static struct pci_ops sabre_ops = { .write = sabre_write_pci_cfg, }; -static unsigned long sabre_pcislot_imap_offset(unsigned long ino) -{ - unsigned int bus = (ino & 0x10) >> 4; - unsigned int slot = (ino & 0x0c) >> 2; - - if (bus == 0) - return SABRE_IMAP_A_SLOT0 + (slot * 8); - else - return SABRE_IMAP_B_SLOT0 + (slot * 8); -} - -static unsigned long __onboard_imap_off[] = { -/*0x20*/ SABRE_IMAP_SCSI, -/*0x21*/ SABRE_IMAP_ETH, -/*0x22*/ SABRE_IMAP_BPP, -/*0x23*/ SABRE_IMAP_AU_REC, -/*0x24*/ SABRE_IMAP_AU_PLAY, -/*0x25*/ SABRE_IMAP_PFAIL, -/*0x26*/ SABRE_IMAP_KMS, -/*0x27*/ SABRE_IMAP_FLPY, -/*0x28*/ SABRE_IMAP_SHW, -/*0x29*/ SABRE_IMAP_KBD, -/*0x2a*/ SABRE_IMAP_MS, -/*0x2b*/ SABRE_IMAP_SER, -/*0x2c*/ 0 /* reserved */, -/*0x2d*/ 0 /* reserved */, -/*0x2e*/ SABRE_IMAP_UE, -/*0x2f*/ SABRE_IMAP_CE, -/*0x30*/ SABRE_IMAP_PCIERR, -}; -#define SABRE_ONBOARD_IRQ_BASE 0x20 -#define SABRE_ONBOARD_IRQ_LAST 0x30 -#define sabre_onboard_imap_offset(__ino) \ - __onboard_imap_off[(__ino) - SABRE_ONBOARD_IRQ_BASE] - -#define sabre_iclr_offset(ino) \ - ((ino & 0x20) ? (SABRE_ICLR_SCSI + (((ino) & 0x1f) << 3)) : \ - (SABRE_ICLR_A_SLOT0 + (((ino) & 0x1f)<<3))) - -/* When a device lives behind a bridge deeper in the PCI bus topology - * than APB, a special sequence must run to make sure all pending DMA - * transfers at the time of IRQ delivery are visible in the coherency - * domain by the cpu. This sequence is to perform a read on the far - * side of the non-APB bridge, then perform a read of Sabre's DMA - * write-sync register. - */ -static void sabre_wsync_handler(unsigned int ino, void *_arg1, void *_arg2) -{ - struct pci_dev *pdev = _arg1; - unsigned long sync_reg = (unsigned long) _arg2; - u16 _unused; - - pci_read_config_word(pdev, PCI_VENDOR_ID, &_unused); - sabre_read(sync_reg); -} - -static unsigned int sabre_irq_build(struct pci_pbm_info *pbm, - struct pci_dev *pdev, - unsigned int ino) -{ - unsigned long imap, iclr; - unsigned long imap_off, iclr_off; - int inofixup = 0; - int virt_irq; - - ino &= PCI_IRQ_INO; - if (ino < SABRE_ONBOARD_IRQ_BASE) { - /* PCI slot */ - imap_off = sabre_pcislot_imap_offset(ino); - } else { - /* onboard device */ - if (ino > SABRE_ONBOARD_IRQ_LAST) { - prom_printf("sabre_irq_build: Wacky INO [%x]\n", ino); - prom_halt(); - } - imap_off = sabre_onboard_imap_offset(ino); - } - - /* Now build the IRQ bucket. */ - imap = pbm->controller_regs + imap_off; - imap += 4; - - iclr_off = sabre_iclr_offset(ino); - iclr = pbm->controller_regs + iclr_off; - iclr += 4; - - if ((ino & 0x20) == 0) - inofixup = ino & 0x03; - - virt_irq = build_irq(inofixup, iclr, imap); - - if (pdev) { - struct pcidev_cookie *pcp = pdev->sysdata; - - if (pdev->bus->number != pcp->pbm->pci_first_busno) { - struct pci_controller_info *p = pcp->pbm->parent; - - irq_install_pre_handler(virt_irq, - sabre_wsync_handler, - pdev, - (void *) - p->pbm_A.controller_regs + - SABRE_WRSYNC); - } - } - return virt_irq; -} - /* SABRE error handling support. */ static void sabre_check_iommu_error(struct pci_controller_info *p, unsigned long afsr, @@ -929,17 +821,30 @@ static irqreturn_t sabre_pcierr_intr(int irq, void *dev_id, struct pt_regs *regs return IRQ_HANDLED; } -/* XXX What about PowerFail/PowerManagement??? -DaveM */ -#define SABRE_UE_INO 0x2e -#define SABRE_CE_INO 0x2f -#define SABRE_PCIERR_INO 0x30 static void sabre_register_error_handlers(struct pci_controller_info *p) { struct pci_pbm_info *pbm = &p->pbm_A; /* arbitrary */ + struct device_node *dp = pbm->prom_node; + struct of_device *op; unsigned long base = pbm->controller_regs; - unsigned long irq, portid = pbm->portid; u64 tmp; + if (pbm->chip_type == PBM_CHIP_TYPE_SABRE) + dp = dp->parent; + + op = of_find_device_by_node(dp); + if (!op) + return; + + /* Sabre/Hummingbird IRQ property layout is: + * 0: PCI ERR + * 1: UE ERR + * 2: CE ERR + * 3: POWER FAIL + */ + if (op->num_irqs < 4) + return; + /* We clear the error bits in the appropriate AFSR before * registering the handler so that we don't get spurious * interrupts. @@ -948,32 +853,16 @@ static void sabre_register_error_handlers(struct pci_controller_info *p) (SABRE_UEAFSR_PDRD | SABRE_UEAFSR_PDWR | SABRE_UEAFSR_SDRD | SABRE_UEAFSR_SDWR | SABRE_UEAFSR_SDTE | SABRE_UEAFSR_PDTE)); - irq = sabre_irq_build(pbm, NULL, (portid << 6) | SABRE_UE_INO); - if (request_irq(irq, sabre_ue_intr, - SA_SHIRQ, "SABRE UE", p) < 0) { - prom_printf("SABRE%d: Cannot register UE interrupt.\n", - p->index); - prom_halt(); - } + + request_irq(op->irqs[1], sabre_ue_intr, SA_SHIRQ, "SABRE UE", p); sabre_write(base + SABRE_CE_AFSR, (SABRE_CEAFSR_PDRD | SABRE_CEAFSR_PDWR | SABRE_CEAFSR_SDRD | SABRE_CEAFSR_SDWR)); - irq = sabre_irq_build(pbm, NULL, (portid << 6) | SABRE_CE_INO); - if (request_irq(irq, sabre_ce_intr, - SA_SHIRQ, "SABRE CE", p) < 0) { - prom_printf("SABRE%d: Cannot register CE interrupt.\n", - p->index); - prom_halt(); - } - irq = sabre_irq_build(pbm, NULL, (portid << 6) | SABRE_PCIERR_INO); - if (request_irq(irq, sabre_pcierr_intr, - SA_SHIRQ, "SABRE PCIERR", p) < 0) { - prom_printf("SABRE%d: Cannot register PciERR interrupt.\n", - p->index); - prom_halt(); - } + request_irq(op->irqs[2], sabre_ce_intr, SA_SHIRQ, "SABRE CE", p); + request_irq(op->irqs[0], sabre_pcierr_intr, SA_SHIRQ, + "SABRE PCIERR", p); tmp = sabre_read(base + SABRE_PCICTRL); tmp |= SABRE_PCICTRL_ERREN; @@ -1492,7 +1381,6 @@ void sabre_init(struct device_node *dp, char *model_name) p->index = pci_num_controllers++; p->pbms_same_domain = 1; p->scan_bus = sabre_scan_bus; - p->irq_build = sabre_irq_build; p->base_address_update = sabre_base_address_update; p->resource_adjust = sabre_resource_adjust; p->pci_ops = &sabre_ops; |