diff options
Diffstat (limited to 'drivers/crypto')
| -rw-r--r-- | drivers/crypto/s5p-sss.c | 127 |
1 files changed, 82 insertions, 45 deletions
diff --git a/drivers/crypto/s5p-sss.c b/drivers/crypto/s5p-sss.c index a668286d62cb..1b9da3dc799b 100644 --- a/drivers/crypto/s5p-sss.c +++ b/drivers/crypto/s5p-sss.c @@ -270,7 +270,7 @@ static void s5p_sg_copy_buf(void *buf, struct scatterlist *sg, scatterwalk_done(&walk, out, 0); } -static void s5p_aes_complete(struct s5p_aes_dev *dev, int err) +static void s5p_sg_done(struct s5p_aes_dev *dev) { if (dev->sg_dst_cpy) { dev_dbg(dev->dev, @@ -281,8 +281,11 @@ static void s5p_aes_complete(struct s5p_aes_dev *dev, int err) } s5p_free_sg_cpy(dev, &dev->sg_src_cpy); s5p_free_sg_cpy(dev, &dev->sg_dst_cpy); +} - /* holding a lock outside */ +/* Calls the completion. Cannot be called with dev->lock hold. */ +static void s5p_aes_complete(struct s5p_aes_dev *dev, int err) +{ dev->req->base.complete(&dev->req->base, err); dev->busy = false; } @@ -368,51 +371,44 @@ exit: } /* - * Returns true if new transmitting (output) data is ready and its - * address+length have to be written to device (by calling - * s5p_set_dma_outdata()). False otherwise. + * Returns -ERRNO on error (mapping of new data failed). + * On success returns: + * - 0 if there is no more data, + * - 1 if new transmitting (output) data is ready and its address+length + * have to be written to device (by calling s5p_set_dma_outdata()). */ -static bool s5p_aes_tx(struct s5p_aes_dev *dev) +static int s5p_aes_tx(struct s5p_aes_dev *dev) { - int err = 0; - bool ret = false; + int ret = 0; s5p_unset_outdata(dev); if (!sg_is_last(dev->sg_dst)) { - err = s5p_set_outdata(dev, sg_next(dev->sg_dst)); - if (err) - s5p_aes_complete(dev, err); - else - ret = true; - } else { - s5p_aes_complete(dev, err); - - dev->busy = true; - tasklet_schedule(&dev->tasklet); + ret = s5p_set_outdata(dev, sg_next(dev->sg_dst)); + if (!ret) + ret = 1; } return ret; } /* - * Returns true if new receiving (input) data is ready and its - * address+length have to be written to device (by calling - * s5p_set_dma_indata()). False otherwise. + * Returns -ERRNO on error (mapping of new data failed). + * On success returns: + * - 0 if there is no more data, + * - 1 if new receiving (input) data is ready and its address+length + * have to be written to device (by calling s5p_set_dma_indata()). */ -static bool s5p_aes_rx(struct s5p_aes_dev *dev) +static int s5p_aes_rx(struct s5p_aes_dev *dev/*, bool *set_dma*/) { - int err; - bool ret = false; + int ret = 0; s5p_unset_indata(dev); if (!sg_is_last(dev->sg_src)) { - err = s5p_set_indata(dev, sg_next(dev->sg_src)); - if (err) - s5p_aes_complete(dev, err); - else - ret = true; + ret = s5p_set_indata(dev, sg_next(dev->sg_src)); + if (!ret) + ret = 1; } return ret; @@ -422,33 +418,73 @@ static irqreturn_t s5p_aes_interrupt(int irq, void *dev_id) { struct platform_device *pdev = dev_id; struct s5p_aes_dev *dev = platform_get_drvdata(pdev); - bool set_dma_tx = false; - bool set_dma_rx = false; + int err_dma_tx = 0; + int err_dma_rx = 0; + bool tx_end = false; unsigned long flags; uint32_t status; + int err; spin_lock_irqsave(&dev->lock, flags); + /* + * Handle rx or tx interrupt. If there is still data (scatterlist did not + * reach end), then map next scatterlist entry. + * In case of such mapping error, s5p_aes_complete() should be called. + * + * If there is no more data in tx scatter list, call s5p_aes_complete() + * and schedule new tasklet. + */ status = SSS_READ(dev, FCINTSTAT); if (status & SSS_FCINTSTAT_BRDMAINT) - set_dma_rx = s5p_aes_rx(dev); - if (status & SSS_FCINTSTAT_BTDMAINT) - set_dma_tx = s5p_aes_tx(dev); + err_dma_rx = s5p_aes_rx(dev); + + if (status & SSS_FCINTSTAT_BTDMAINT) { + if (sg_is_last(dev->sg_dst)) + tx_end = true; + err_dma_tx = s5p_aes_tx(dev); + } SSS_WRITE(dev, FCINTPEND, status); - /* - * Writing length of DMA block (either receiving or transmitting) - * will start the operation immediately, so this should be done - * at the end (even after clearing pending interrupts to not miss the - * interrupt). - */ - if (set_dma_tx) - s5p_set_dma_outdata(dev, dev->sg_dst); - if (set_dma_rx) - s5p_set_dma_indata(dev, dev->sg_src); + if (err_dma_rx < 0) { + err = err_dma_rx; + goto error; + } + if (err_dma_tx < 0) { + err = err_dma_tx; + goto error; + } + + if (tx_end) { + s5p_sg_done(dev); + + spin_unlock_irqrestore(&dev->lock, flags); + + s5p_aes_complete(dev, 0); + dev->busy = true; + tasklet_schedule(&dev->tasklet); + } else { + /* + * Writing length of DMA block (either receiving or + * transmitting) will start the operation immediately, so this + * should be done at the end (even after clearing pending + * interrupts to not miss the interrupt). + */ + if (err_dma_tx == 1) + s5p_set_dma_outdata(dev, dev->sg_dst); + if (err_dma_rx == 1) + s5p_set_dma_indata(dev, dev->sg_src); + spin_unlock_irqrestore(&dev->lock, flags); + } + + return IRQ_HANDLED; + +error: + s5p_sg_done(dev); spin_unlock_irqrestore(&dev->lock, flags); + s5p_aes_complete(dev, err); return IRQ_HANDLED; } @@ -597,8 +633,9 @@ outdata_error: s5p_unset_indata(dev); indata_error: - s5p_aes_complete(dev, err); + s5p_sg_done(dev); spin_unlock_irqrestore(&dev->lock, flags); + s5p_aes_complete(dev, err); } static void s5p_tasklet_cb(unsigned long data) |