diff options
Diffstat (limited to 'drivers/input')
| -rw-r--r-- | drivers/input/touchscreen/wm97xx-core.c | 56 |
1 files changed, 48 insertions, 8 deletions
diff --git a/drivers/input/touchscreen/wm97xx-core.c b/drivers/input/touchscreen/wm97xx-core.c index 2910999e05a0..e9c7ea46b6e3 100644 --- a/drivers/input/touchscreen/wm97xx-core.c +++ b/drivers/input/touchscreen/wm97xx-core.c @@ -262,6 +262,23 @@ void wm97xx_config_gpio(struct wm97xx *wm, u32 gpio, enum wm97xx_gpio_dir dir, EXPORT_SYMBOL_GPL(wm97xx_config_gpio); /* + * Configure the WM97XX_PRP value to use while system is suspended. + * If a value other than 0 is set then WM97xx pen detection will be + * left enabled in the configured mode while the system is in suspend, + * the device has users and suspend has not been disabled via the + * wakeup sysfs entries. + * + * @wm: WM97xx device to configure + * @mode: WM97XX_PRP value to configure while suspended + */ +void wm97xx_set_suspend_mode(struct wm97xx *wm, u16 mode) +{ + wm->suspend_mode = mode; + device_init_wakeup(&wm->input_dev->dev, mode != 0); +} +EXPORT_SYMBOL_GPL(wm97xx_set_suspend_mode); + +/* * Handle a pen down interrupt. */ static void wm97xx_pen_irq_worker(struct work_struct *work) @@ -328,18 +345,18 @@ static void wm97xx_pen_irq_worker(struct work_struct *work) * * We have to disable the codec interrupt in the handler because it * can take upto 1ms to clear the interrupt source. We schedule a task - * in a work queue to do the actual interaction with the chip (it - * doesn't matter if we end up reenqueing it before it is executed - * since we don't touch the chip until it has run). The interrupt is - * then enabled again in the slow handler when the source has been - * cleared. + * in a work queue to do the actual interaction with the chip. The + * interrupt is then enabled again in the slow handler when the source + * has been cleared. */ static irqreturn_t wm97xx_pen_interrupt(int irq, void *dev_id) { struct wm97xx *wm = dev_id; - wm->mach_ops->irq_enable(wm, 0); - queue_work(wm->ts_workq, &wm->pen_event_work); + if (!work_pending(&wm->pen_event_work)) { + wm->mach_ops->irq_enable(wm, 0); + queue_work(wm->ts_workq, &wm->pen_event_work); + } return IRQ_HANDLED; } @@ -355,7 +372,8 @@ static int wm97xx_init_pen_irq(struct wm97xx *wm) * provided. */ BUG_ON(!wm->mach_ops->irq_enable); - if (request_irq(wm->pen_irq, wm97xx_pen_interrupt, IRQF_SHARED, + if (request_irq(wm->pen_irq, wm97xx_pen_interrupt, + IRQF_SHARED | IRQF_SAMPLE_RANDOM, "wm97xx-pen", wm)) { dev_err(wm->dev, "Failed to register pen down interrupt, polling"); @@ -688,10 +706,32 @@ static int wm97xx_remove(struct device *dev) static int wm97xx_suspend(struct device *dev, pm_message_t state) { struct wm97xx *wm = dev_get_drvdata(dev); + u16 reg; + int suspend_mode; + + if (device_may_wakeup(&wm->input_dev->dev)) + suspend_mode = wm->suspend_mode; + else + suspend_mode = 0; if (wm->input_dev->users) cancel_delayed_work_sync(&wm->ts_reader); + /* Power down the digitiser (bypassing the cache for resume) */ + reg = wm97xx_reg_read(wm, AC97_WM97XX_DIGITISER2); + reg &= ~WM97XX_PRP_DET_DIG; + if (wm->input_dev->users) + reg |= suspend_mode; + wm->ac97->bus->ops->write(wm->ac97, AC97_WM97XX_DIGITISER2, reg); + + /* WM9713 has an additional power bit - turn it off if there + * are no users or if suspend mode is zero. */ + if (wm->id == WM9713_ID2 && + (!wm->input_dev->users || !suspend_mode)) { + reg = wm97xx_reg_read(wm, AC97_EXTENDED_MID) | 0x8000; + wm97xx_reg_write(wm, AC97_EXTENDED_MID, reg); + } + return 0; } |