diff options
Diffstat (limited to 'drivers/net/e1000e/lib.c')
-rw-r--r-- | drivers/net/e1000e/lib.c | 124 |
1 files changed, 73 insertions, 51 deletions
diff --git a/drivers/net/e1000e/lib.c b/drivers/net/e1000e/lib.c index 2fa9b36a2c5a..547542428edc 100644 --- a/drivers/net/e1000e/lib.c +++ b/drivers/net/e1000e/lib.c @@ -139,6 +139,68 @@ void e1000e_init_rx_addrs(struct e1000_hw *hw, u16 rar_count) } /** + * e1000_check_alt_mac_addr_generic - Check for alternate MAC addr + * @hw: pointer to the HW structure + * + * Checks the nvm for an alternate MAC address. An alternate MAC address + * can be setup by pre-boot software and must be treated like a permanent + * address and must override the actual permanent MAC address. If an + * alternate MAC address is found it is programmed into RAR0, replacing + * the permanent address that was installed into RAR0 by the Si on reset. + * This function will return SUCCESS unless it encounters an error while + * reading the EEPROM. + **/ +s32 e1000_check_alt_mac_addr_generic(struct e1000_hw *hw) +{ + u32 i; + s32 ret_val = 0; + u16 offset, nvm_alt_mac_addr_offset, nvm_data; + u8 alt_mac_addr[ETH_ALEN]; + + ret_val = e1000_read_nvm(hw, NVM_ALT_MAC_ADDR_PTR, 1, + &nvm_alt_mac_addr_offset); + if (ret_val) { + e_dbg("NVM Read Error\n"); + goto out; + } + + if (nvm_alt_mac_addr_offset == 0xFFFF) { + /* There is no Alternate MAC Address */ + goto out; + } + + if (hw->bus.func == E1000_FUNC_1) + nvm_alt_mac_addr_offset += E1000_ALT_MAC_ADDRESS_OFFSET_LAN1; + for (i = 0; i < ETH_ALEN; i += 2) { + offset = nvm_alt_mac_addr_offset + (i >> 1); + ret_val = e1000_read_nvm(hw, offset, 1, &nvm_data); + if (ret_val) { + e_dbg("NVM Read Error\n"); + goto out; + } + + alt_mac_addr[i] = (u8)(nvm_data & 0xFF); + alt_mac_addr[i + 1] = (u8)(nvm_data >> 8); + } + + /* if multicast bit is set, the alternate address will not be used */ + if (alt_mac_addr[0] & 0x01) { + e_dbg("Ignoring Alternate Mac Address with MC bit set\n"); + goto out; + } + + /* + * We have a valid alternate MAC address, and we want to treat it the + * same as the normal permanent MAC address stored by the HW into the + * RAR. Do this by mapping this address into RAR0. + */ + e1000e_rar_set(hw, alt_mac_addr, 0); + +out: + return ret_val; +} + +/** * e1000e_rar_set - Set receive address register * @hw: pointer to the HW structure * @addr: pointer to the receive address @@ -2072,67 +2134,27 @@ s32 e1000e_write_nvm_spi(struct e1000_hw *hw, u16 offset, u16 words, u16 *data) } /** - * e1000e_read_mac_addr - Read device MAC address + * e1000_read_mac_addr_generic - Read device MAC address * @hw: pointer to the HW structure * * Reads the device MAC address from the EEPROM and stores the value. * Since devices with two ports use the same EEPROM, we increment the * last bit in the MAC address for the second port. **/ -s32 e1000e_read_mac_addr(struct e1000_hw *hw) +s32 e1000_read_mac_addr_generic(struct e1000_hw *hw) { - s32 ret_val; - u16 offset, nvm_data, i; - u16 mac_addr_offset = 0; - - if (hw->mac.type == e1000_82571) { - /* Check for an alternate MAC address. An alternate MAC - * address can be setup by pre-boot software and must be - * treated like a permanent address and must override the - * actual permanent MAC address.*/ - ret_val = e1000_read_nvm(hw, NVM_ALT_MAC_ADDR_PTR, 1, - &mac_addr_offset); - if (ret_val) { - e_dbg("NVM Read Error\n"); - return ret_val; - } - if (mac_addr_offset == 0xFFFF) - mac_addr_offset = 0; - - if (mac_addr_offset) { - if (hw->bus.func == E1000_FUNC_1) - mac_addr_offset += ETH_ALEN/sizeof(u16); - - /* make sure we have a valid mac address here - * before using it */ - ret_val = e1000_read_nvm(hw, mac_addr_offset, 1, - &nvm_data); - if (ret_val) { - e_dbg("NVM Read Error\n"); - return ret_val; - } - if (nvm_data & 0x0001) - mac_addr_offset = 0; - } + u32 rar_high; + u32 rar_low; + u16 i; - if (mac_addr_offset) - hw->dev_spec.e82571.alt_mac_addr_is_present = 1; - } + rar_high = er32(RAH(0)); + rar_low = er32(RAL(0)); - for (i = 0; i < ETH_ALEN; i += 2) { - offset = mac_addr_offset + (i >> 1); - ret_val = e1000_read_nvm(hw, offset, 1, &nvm_data); - if (ret_val) { - e_dbg("NVM Read Error\n"); - return ret_val; - } - hw->mac.perm_addr[i] = (u8)(nvm_data & 0xFF); - hw->mac.perm_addr[i+1] = (u8)(nvm_data >> 8); - } + for (i = 0; i < E1000_RAL_MAC_ADDR_LEN; i++) + hw->mac.perm_addr[i] = (u8)(rar_low >> (i*8)); - /* Flip last bit of mac address if we're on second port */ - if (!mac_addr_offset && hw->bus.func == E1000_FUNC_1) - hw->mac.perm_addr[5] ^= 1; + for (i = 0; i < E1000_RAH_MAC_ADDR_LEN; i++) + hw->mac.perm_addr[i+4] = (u8)(rar_high >> (i*8)); for (i = 0; i < ETH_ALEN; i++) hw->mac.addr[i] = hw->mac.perm_addr[i]; |