diff options
Diffstat (limited to 'drivers/net/ethernet/cortina/gemini.c')
| -rw-r--r-- | drivers/net/ethernet/cortina/gemini.c | 49 |
1 files changed, 30 insertions, 19 deletions
diff --git a/drivers/net/ethernet/cortina/gemini.c b/drivers/net/ethernet/cortina/gemini.c index 8361faf03e42..675c6dda45e2 100644 --- a/drivers/net/ethernet/cortina/gemini.c +++ b/drivers/net/ethernet/cortina/gemini.c @@ -68,7 +68,6 @@ MODULE_PARM_DESC(debug, "Debug level (0=none,...,16=all)"); #define DEFAULT_GMAC_RXQ_ORDER 9 #define DEFAULT_GMAC_TXQ_ORDER 8 #define DEFAULT_RX_BUF_ORDER 11 -#define DEFAULT_NAPI_WEIGHT 64 #define TX_MAX_FRAGS 16 #define TX_QUEUE_NUM 1 /* max: 6 */ #define RX_MAX_ALLOC_ORDER 2 @@ -433,8 +432,8 @@ static const struct gmac_max_framelen gmac_maxlens[] = { .val = CONFIG0_MAXLEN_1536, }, { - .max_l3_len = 1542, - .val = CONFIG0_MAXLEN_1542, + .max_l3_len = 1548, + .val = CONFIG0_MAXLEN_1548, }, { .max_l3_len = 9212, @@ -1146,6 +1145,7 @@ static int gmac_map_tx_bufs(struct net_device *netdev, struct sk_buff *skb, dma_addr_t mapping; unsigned short mtu; void *buffer; + int ret; mtu = ETH_HLEN; mtu += netdev->mtu; @@ -1160,9 +1160,30 @@ static int gmac_map_tx_bufs(struct net_device *netdev, struct sk_buff *skb, word3 |= mtu; } - if (skb->ip_summed != CHECKSUM_NONE) { + if (skb->len >= ETH_FRAME_LEN) { + /* Hardware offloaded checksumming isn't working on frames + * bigger than 1514 bytes. A hypothesis about this is that the + * checksum buffer is only 1518 bytes, so when the frames get + * bigger they get truncated, or the last few bytes get + * overwritten by the FCS. + * + * Just use software checksumming and bypass on bigger frames. + */ + if (skb->ip_summed == CHECKSUM_PARTIAL) { + ret = skb_checksum_help(skb); + if (ret) + return ret; + } + word1 |= TSS_BYPASS_BIT; + } else if (skb->ip_summed == CHECKSUM_PARTIAL) { int tcp = 0; + /* We do not switch off the checksumming on non TCP/UDP + * frames: as is shown from tests, the checksumming engine + * is smart enough to see that a frame is not actually TCP + * or UDP and then just pass it through without any changes + * to the frame. + */ if (skb->protocol == htons(ETH_P_IP)) { word1 |= TSS_IP_CHKSUM_BIT; tcp = ip_hdr(skb)->protocol == IPPROTO_TCP; @@ -1979,15 +2000,6 @@ static int gmac_change_mtu(struct net_device *netdev, int new_mtu) return 0; } -static netdev_features_t gmac_fix_features(struct net_device *netdev, - netdev_features_t features) -{ - if (netdev->mtu + ETH_HLEN + VLAN_HLEN > MTU_SIZE_BIT_MASK) - features &= ~GMAC_OFFLOAD_FEATURES; - - return features; -} - static int gmac_set_features(struct net_device *netdev, netdev_features_t features) { @@ -2209,7 +2221,6 @@ static const struct net_device_ops gmac_351x_ops = { .ndo_set_mac_address = gmac_set_mac_address, .ndo_get_stats64 = gmac_get_stats64, .ndo_change_mtu = gmac_change_mtu, - .ndo_fix_features = gmac_fix_features, .ndo_set_features = gmac_set_features, }; @@ -2459,15 +2470,15 @@ static int gemini_ethernet_port_probe(struct platform_device *pdev) netdev->hw_features = GMAC_OFFLOAD_FEATURES; netdev->features |= GMAC_OFFLOAD_FEATURES | NETIF_F_GRO; - /* We can handle jumbo frames up to 10236 bytes so, let's accept - * payloads of 10236 bytes minus VLAN and ethernet header + /* We can receive jumbo frames up to 10236 bytes but only + * transmit 2047 bytes so, let's accept payloads of 2047 + * bytes minus VLAN and ethernet header */ netdev->min_mtu = ETH_MIN_MTU; - netdev->max_mtu = 10236 - VLAN_ETH_HLEN; + netdev->max_mtu = MTU_SIZE_BIT_MASK - VLAN_ETH_HLEN; port->freeq_refill = 0; - netif_napi_add(netdev, &port->napi, gmac_napi_poll, - DEFAULT_NAPI_WEIGHT); + netif_napi_add(netdev, &port->napi, gmac_napi_poll, NAPI_POLL_WEIGHT); if (is_valid_ether_addr((void *)port->mac_addr)) { memcpy(netdev->dev_addr, port->mac_addr, ETH_ALEN); |